Authorized Distributor: Total Power International, Inc. Toll Free: 877-646-0900(US) PH# (978) 453-7272 www.total-power.com PM-10 10W Output Switching Power Supply series ¡½ Features : ¡EUniversal AC input / Full range ¡ Protections: Short circuit / Overload / Over voltage E ¡ Ultra-miniature size, light weight E ¡ Cooling by free air convection E ¡ Isolation class¢º E ¡ Medical safety approved (MOPP level) E ¡ No load power consumption<0.5W E ¡ 100% full load burn-in test E ¡ Fixed switching frequency at 67KHz E ¡ High reliability E ¡ 3 years warranty E SPECIFICATION MODEL OUTPUT INPUT PM-10-3.3 PM-10-5 PM-10-12 PM-10-15 PM-10-24 DC VOLTAGE 3.3V 5V 12V 15V 24V RATED CURRENT 2.5A 2A 0.85A 0.67A 0.42A CURRENT RANGE 0 ~ 2.5A 0 ~ 2A 0 ~ 0.85A 0 ~ 0.67A 0 ~ 0.42A RATED POWER 8.25W 10W 10.2W 10.05W 10.08W RIPPLE & NOISE (max.) Note.2 150mVp-p 150mVp-p 150mVp-p 150mVp-p 240mVp-p VOLTAGE TOLERANCE Note.3 ¡Ó3.0% ¡Ó2.0% ¡Ó2.0% ¡Ó2.0% ¡Ó2.0% LINE REGULATION ¡Ó1.0% ¡Ó1.0% ¡Ó0.5% ¡Ó0.5% ¡Ó0.5% LOAD REGULATION ¡Ó1.0% ¡Ó1.0% ¡Ó1.0% ¡Ó1.0% ¡Ó0.5% SETUP, RISE TIME 1800ms, 20ms/230VAC HOLD UP TIME (Typ.) 100ms/230VAC VOLTAGE RANGE 85 ~ 264VAC FREQUENCY RANGE 47 ~ 440Hz 79% 79% EFFICIENCY (Typ.) 66% AC CURRENT (Typ.) INRUSH CURRENT (Typ.) 0.25A/115VAC LEAKAGE CURRENT PROTECTION OVER VOLTAGE WORKING TEMP. WORKING HUMIDITY ENVIRONMENT STORAGE TEMP., HUMIDITY TEMP. COEFFICIENT VIBRATION SAFETY STANDARDS SAFETY & WITHSTAND VOLTAGE (Note 4) ISOLATION RESISTANCE EMC EMISSION EMC IMMUNITY MTBF OTHERS DIMENSION PACKING NOTE 24ms/115VAC at full load 120 ~ 370VDC 74% 78% 0.15A/230VAC COLD START 25A/115VAC £g 45A/230VAC Note.5 Touch current < 80 A/264VAC OVERLOAD EMC 1800ms, 20ms/115VAC at full load Above 105% rated output power Protection type : Hiccup mode, recovers automatically after fault condition is removed 3.8 ~ 4.95V 5.75 ~ 6.75V 13.8 ~ 16.2V 17.25 ~ 20.25V 27.6 ~ 32.4V Protection type : Shut off o/p voltage, clamping by zener diode -20 ~ +70¢J (Refer to "Derating Curve") 20 ~ 90% RH non-condensing -40 ~ +85¢J, 10 ~ 95% RH ¡Ó0.03%/¢J (0 ~ 50¢J) 10 ~ 500Hz, 2G 10min./1cycle, period for 60min. each along X, Y, Z axes ANSI/AAMI ES60601-1, TUV EN60601-1, IEC60601-1 approved I/P-O/P:4KVAC I/P-O/P:100M Ohms / 500VDC / 25¢J/ 70% RH Compliance to EN55011(CISPR11),EN55022 (CISPR22) Class B, EN61000-3-2,-3 Compliance to EN61000-4-2,3,4,5,6,8,11, EN55024, EN60601-1-2, EN61204-3, medical level, criteria A 723.2Khrs min. MIL-HDBK-217F (25¢J) 70*50*22.7mm (L*W*H) 0.105Kg; 120pcs/13.6Kg/0.97CUFT 1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25¢J of ambient temperature. 2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor. 3. Tolerance : includes set up tolerance, line regulation and load regulation. 4. The power supply is considered a component which will be installed into a final equipment. The final equipment must be re-confirmed that it still meets EMC directives. 5. Touch current was measured from primary input to DC output. File Name:PM-10-SPEC 2012-09-03 Authorized Distributor: Total Power International, Inc. Toll Free: 877-646-0900(US) PH# (978) 453-7272 www.total-power.com PM-10 10W Output Switching Power Supply Mechanical Specification Case No. 949A series Unit:inch(mm) 0.315"(8mm) 1.97"(50mm) 0.689" (17.5mm) 2.76"(70mm) 2.13"(54mm) 0.89"(22.7mm) 0.041"(1.05mm) AC/N 0.295" (7.5mm) AC/L BOTTOM VIEW 0.138" (3.5¡Ó1mm) -V +V 0.789" (20.04mm) 0.59" (15mm) Block Diagram fosc : 67KHz RECTIFIERS & FILTER EMI FILTER I/P RECTIFIERS & FILTER POWER SWITCHING PWM CONTROL Derating Curve +V -V DETECTION CIRCUIT Output Derating VS Input Voltage 100 100 90 80 80 70 LOAD (%) LOAD (%) 60 40 20 -20 0 10 20 30 40 50 AMBIENT TEMPERATURE (¢J) 60 70 (HORIZONTAL) 60 50 40 85 95 100 115 120 140 160 180 200 220 240 264 INPUT VOLTAGE (VAC) 60Hz File Name:PM-10-SPEC 2012-09-03