AZ822 156 PCB signal relays Subminiature DIP relays - single side stable AZ822 subminiature DIP relays - single side stable • Low profile for compact board spacing • DC coils: up to 48 V DC • Life expectancy to 10 million operations • 2,54 mm pinning • Fits standard 16 pin IC socket • Epoxy sealed for automatic wave soldering and cleaning • Meets FCC Part 68.302 1500 V lightning surge • Meets FCC Part 68.304 1000 V dielectric • UL, CUR-E43203 Contacts Contact number & arrangement Contact material Resistive load • max. switching power • max. switching current • max. switching voltage • rated load Resistance 2C/O DPDT (2 Form C) Bifurcated crossbar contacts AgPd/Au ❶ 60 W / 125 VA 2A 220 V DC ❷ UL: 1 A / 24 V DC ≤ 50 mΩ 250 V AC 0,5 A / 120 V AC Coil (Polarized) Rated voltage Must release voltage Power consumption Power at pickup voltage (typical value) DC DC Max. continuous dissipation Temperature rise at Un coil Temperature 5-6-9-12-24-48 V ≥ 0,1 Un 0,15...0,3 W coil 5-12 V Un 74 mW 98 mW coil 24 V Un 147 mW coil 48 V Un 0,94 W 20oC 15 oC max. 105 oC General data Electrical life: • AC1 • DC1 Mechanical life Operating time (typical value) at Un coil Release time (typical value) at Un coil Bounce (typical) Capacitance Dielectric strength insulation (at sea level for 1 min.) Dimensions (L x W x H) Weight Enclosure Terminals Ambient temperature • storing • operating (at Un coil) Cover protection category Shock resistance Vibration resistance Solder bath temperature Soldering time 2 x 105 0,5 A, 120 V AC 5 x 105 1 A, 30 V DC 108 5 ms 2 ms (with no coil suppression) 2 ms NO; 3 ms NC 1,2 pF contact to contact 1,6 pF between contact sets 1,5 pF contact to coil 1 000 Vrms contact to coil 1 000 Vrms contact to contact 1 000 Vrms between contact sets 20 x 9,8 x 12 mm 4,5 g poliester P.B.T. alloy Cu-Sn -55...+105 oC -55...+90 oC IP 67 20 g stable amplitude to 1,5 mm DA at 10...55 Hz max. 270 oC max. 5 s ❶ Min. current / voltage: 10 µA / 10 mV ❷ At switching voltage above 30 V DC, contact Relpol S.A. Notes: All values at 20 °C • Relays should not operate when the limit values are exceeded • Relay adjustment may be affected by undue pressure on relay case • Specifications subject to change without notice. www.relpol.com.pl AZ822 PCB signal relays 157 Subminiature DIP relays - single side stable Ordering codes See Coil data - Table 1 www.relpol.com.pl