product details QT-T/E 1X70/230-240 Product description: EAN/ Product: Quantity: QT-T/E 1X70/230-240 1) 4050300792002 Unpacked (UNV) contains 1 Piece (PCE) You can find this product in the eCatalog: http://catalog.myosram.com?~language=EN&~country=COM&it_p=4050300792002 Applications Dimmable Motion IP code IP20 Lamp start warm start General Description Design / version ECG standard SEG no. 7980187 Standards acc. to DIN VDE 0875/CISPR 15/EN 55015 | acc. to EN 61547 | acc. to EN 610003-2 Energy Label - EEI A2 Sstl-Number 4031140 Technical - Electrical Data Operating frequency 40 ... 95 kHz Mains frequency 50-60 Hz Lamp wattage 70 W Power factor c 0.98 Nominal voltage 230-240 V DC voltage 176...254 V 2) Max. no. of ECGs on circuit breaker 10A 17 Max. no. of ECGs on circuit breaker 16A 28 Technical - Geometries Mounting hole spacing, length 129.5 mm Width 79 mm Height 33 mm Length 123 mm Technical - Temperatures Max. casing temp. in case of fault 110 °C Max. operating temp. at the Tc point 65 °C Ambient temperature range -10 ... +50 °C Storage temperature -40 ... 85 °C Relative humidity 5 ... 85 % 3) Packaging units EAN Packaging type and content Dimensions in h x w x l Gross weight Volume 4050300792002 Unpacked contains 1 Piece 80,000 mm x 35,000 mm x 123,000 mm 198,000 g (0,000 g) 0,344 Cubic dec. 4050300792019 Shipping carton box contains 12 Piece 210,000 mm x 80,000 mm x 250,000 mm 2.380,000 g (0,000 g) 4,200 Cubic dec. QT-T/E 1X70/230-240 product details system overview operation of ecg with Length in mm Number of lighting outlet Length in mm Width in mm Height in mm System power consumptio n in W (ECG) DULUX T/E 70 235 mm 1 123 mm 79 mm 33 mm 77 W System power consumptio n in W (CCG) System power consumptio n in W (LLB) Luminous flux with ECG in lumen 5200 lm 1) Battery voltage may drop to 176V. Lamps must be ignited at over 198V however. Same luminous flux with direct current and alternating current Amalgam lamps such as DULUX T/E IN (red stamp) are not suitable for outdoor lighting (t<sub>a</sub> < 5°C) or in most emergency lighting applications where a fast run-up is necessary 2) Ignition must take place above 198 V. 3) max. 56 d/y at 85% Luminous flux in lumen (CCG) Power factor 1