Yageo corporation ELECTROLYTIC CAPACITORS Miniature Aluminum Electrolytic Capacitors SZ [ Ultra Low ESR ] 105°C Single-Ended Lead Aluminum Electrolytic Capacitors for High Frequency Applications Electrical Characteristics Operating Temperature Range : -40 ~ +105°C Rated Voltage Range : 6.3 ~ 16V Rated Capacitance Range : 470 ~ 3300µF Capacitance Tolerance : -20 ~ +20% at 120Hz, 20°C description DC Leakage Current (µA) : I = 0.03 CV whichever is greater. (After Rated Voltage Applied for 2 Minutes) Used in switching regulator applications in computers, especially for high frequency. Dissipation Factor W V (V) : 6.3 10 16 D.F. (%) : 22 19 16 When nominal capacitance is over 1000μF, tan δ shall be added 0.02 to the listed value with increase of every 1000μF. Low impedance and ESR, high permissible ripple current at high frequency and higher operating temperature (-40°C to +105°C). High Temperature Load Life at 105°C for 2000 Hours W V (V) : Rated Voltage (V) Impedance: Z - 25°C / Z + 20°C Z - 40°C / Z + 20°C MULTIPLIER FOR RIPPLE CURRENT Frequency Coefficient FREQUENCY (Hz) 120 1K 10K 100K FACTOR 0.50 0.80 0.90 1.00 Temperature Coefficient TEMPERATURE (°C) 65 85 105 FACTOR 2.10 1.70 1.00 6.3 2 3 10 2 3 16 2 3 Endurance: After the rated voltage has been applied at 105°C for 2000 hours, the capacitors shall meet the following requirements. (a) Capacitance Change : Within ±25% of Initial Value (b) Dissipation Factor : Not Exceeding 200% of Specified Value (c) Leakage Current : Not Exceeding the Specified Value Shelf Life: After having been placed at 105°C without voltage applied for 1000 hours, the capacitors shell meet the same requirements as Endurance. diagram of dimensions Dimensions: mm Rubber Stand-off Vinyl Sleeve (P.V.C) Vinyl Sleeve (P.V.C) Rubber End Seal Rubber End Seal F±0.5 F±0.5 L 15Min. 5Min. D±0.5 L L ≤ 16 L + 1.5Max. L > 16 L + 2Max. Dø = 8 & 10 L + 2.5Max. 15Min. 5Min. Dø F dø 4.0 1.5 0.45 5.0 2.0 0.5 6.3 2.5 8.0 3.5 10.0 5.0 0.6 12.0 D±0.5 Dø < 20 Dø + 0.5 Dø ≥ 20 Dø + 1 13.0 16.0 7.5 18.0 22.0 10.0 0.8 79 CASE SIZE & PERMISSIBLE RIPPLE CURRENT OF STANDARD PRODUCTS CAP. (µF) 6.3 (8) SIZE RIPPLE ESR 10 (13) SIZE RIPPLE ESR 470 680 820 D x L: mm RATED VOLTAGE W V (SURGE VOLTAGE W V) 8 x 11 8 x 11 1036 1036 43 RIPPLE ESR 8 x 11 1036 43 8 x 15 1355 34 10 x 12 1400 31 43 1000 8 x 15 1355 34 8 x 20 1700 25 10 x 12 1400 31 10 x 15 1818 23 10 x 19.5 2318 16 10 x 25 2546 14 1200 8 x 15 1355 34 1500 8 x 20 1740 25 8 x 20 1700 25 10 x 12 1400 31 10 x 15 1818 23 1800 10 x 15 1818 23 10 x 19.5 2318 16 2200 10 x 19.5 2318 15 10 x 25 2545 14 3300 10 x 25 2364 14 Note: 1. Ripple Current: (mA/rms) 105°C, 100KHz 2. ESR: 100KHz / 20°C (mΩ Max.) 16 (20) SIZE