Yageo corporation ELECTROLYTIC CAPACITORS Miniature Aluminum Electrolytic Capacitors SW [ Higher Temperature Range and Long Life ] 125°C 2000 ~ 5000 Hours, High Temperature Long Life Electrical Characteristics Operating Temperature Range : -40 ~ +125°C Rated Voltage Range : 10 ~ 63VDC Rated Capacitance Range : 47 ~ 4700μF Capacitance Tolerance : ±20% at 120Hz, 20°C description Leakage Current (Max.) (20°C): I = 0.01CV or 3μA whichever is greater. Applicable for Electronic Ballast, Lighting Ballast I = Leakage Current (μA), C = Nominal Capacitance (μF), V = Rated Voltage (V) (After Rated Voltage Applied for 2 Minutes) Dissipation Factor (Max.) (tanδ) (120Hz, 20°C) W V (V) : 10 16 25 35 50 63 10K 100K D.F. (%) : 20 16 14 12 10 9 0.40 0.75 0.90 1.00 When nominal capacitance is over 1000μF, the value of tanδ shall be increased by 0.02 for every addition of 10μF < Cap ≤ 100μF 0.50 0.85 0.95 1.00 1000μF. 100μF < Cap ≤ 1,000μF 0.60 0.88 0.96 1.00 Low Temperature Stability Impedance Ratio (Max.) 1,000μF < Cap 0.75 0.90 0.98 1.00 W V (V) : 10 Z-25°C/Z+20°C : 3 2 2 2 2 2 Z-40°C/Z+20°C : 6 4 4 4 4 3 MULTIPLIER FOR RIPPLE CURRENT FREQUENCY (Hz) 120 Cap ≤ 10μF 1K 16 25 35 50 63 Endurance: After the rated voltage and rated ripple current have been applied at 125°C for 2000~5000 hours, the capacitors shall meet the following requirements. Dø : 8ø 10ø ≥13ø Load Life : 2000hrs 3000hrs 5000hrs (a) Capacitance Change: Within ±30% of Initial Value (b) Dissipation Factor: 300% or Less of Initial Specified Value (c) Leakage Current: Initial Specified Value or Less Shelf Life: After leaving capacitors under no load at 125°C for 1000 hours. (a) Capacitance Change: Within ±30% of Initial Value (b) Dissipation Factor: 300% or Less of Initial Specified Value (c) Leakage Current: 500% or Less of Initial Specified Value diagram of dimensions Dimensions: mm Rubber End Seal Vinyl Sleeve F±0.5 F±0.5 Dø±0.5 dø Dø F dø 8.0 1.5 0.6 10.0 13.0 L Dø < 20 Dø + 0.5 Dø ≥ 20 Dø + 1 15Min. 4Min. 16.0 18.0 2.0 0.8 95 CASE SIZE & PERMISSIBLE RIPPLE CURRENT OF STANDARD PRODUCTS CAP. (µF) D x L: mm RATED VOLTAGE W V (SURGE VOLTAGE W V) 10 (13) SIZE RIPPLE ESR 16 (20) SIZE RIPPLE ESR 100 25 (32) SIZE RIPPLE ESR 35 (44) SIZE RIPPLE ESR 8 x 11 340 0.200 10 x 12 340 0.140 220 8 x 11 340 0.200 8 x 11 340 0.200 10 x 12 500 0.140 10 x 15 500 0.090 330 10 x 12 500 0.140 10 x 12 500 0.140 10 x 15 630 0.090 10 x 19 770 0.070 470 10 x 15 630 0.090 10 x 19 770 0.070 10 x 19 770 0.070 13 x 20 920 0.042 1000 10 x 19 770 0.070 13 x 20 920 0.042 13 x 25 1250 0.038 16 x 25 1380 0.028 2200 13 x 25 1250 0.038 16 x 25 1380 0.028 16 x 32 1450 0.025 3300 16 x 25 1380 0.028 16 x 32 1450 0.025 4700 16 x 32 1450 0.025 18 x 32 1720 0.018 Note: 1. Ripple Current: (mA/rms) 125°C, 100KHz 2. ESR: 100KHz / 20°C (Ω) 96 CASE SIZE & PERMISSIBLE RIPPLE CURRENT OF STANDARD PRODUCTS CAP. (µF) D x L: mm RATED VOLTAGE W V (SURGE VOLTAGE W V) 50 (63) SIZE RIPPLE ESR 63(79) SIZE RIPPLE ESR 47 8 x 11 245 0.680 8 x 11 245 0.068 100 10 x 12 415 0.360 10 x 15 455 0.300 220 10 x 19 491 0.180 13 x 20 665 0.120 330 13 x 20 665 0.120 13 x 25 995 0.100 470 13 x 25 995 0.100 16 x 25 1000 0.084 1000 16 x 32 1280 0.078 Note: 1. Ripple Current: (mA/rms) 125°C, 100KHz 2. ESR: 100KHz / 20°C (Ω)