0805 SMD TYPE LED VAOL-S8SYGC-2012511-C Features ․Fit automatic placement equipment. ․Fit Compatible with infrared and vapor phase reflow solder process. ․Pb-free. ․RoHS compliant. Descriptions ․For higher packing density . ․For minature applications . ․Water clear lens . ․Chip material : AlGaInP . ․Emitting color : Yellow Green . Package Outline Dimensions Note: The tolerances unless mentioned is ±0.1mm ,Unit = mm 0805 SMD TYPE LED VAOL-S8SYGC-2012511-C Absolute Maximum Ratings (Ta=25℃) Parameter Symbol Rating Unit Reverse Voltage VR 5 V Forward Current Operating Temperature IF Topr 25 -40 ~ +85 mA ℃ Storage Temperature Tstg -40~ +90 ℃ ESD 2000 V Pd 60 mW IFP 60 mA Electrostatic Discharge(HBM) Power Dissipation Peak Forward Current (Duty 1/10 @1KHz) Reflow Soldering : 260 Soldering Temperature Tsol Hand Soldering : 350 ℃ for 10 sec. ℃ for 3 sec. Electro-Optical Characteristics (Ta=25℃) Parameter Luminous Intensity Symbol Iv *Chip Rank Min. Typ. Max. E1 12 17 ----- E2 17 23 ----- E3 22 31 ----- E4 27 41 ----- Unit Condition mcd Viewing Angle Peak Wavelength 2θ1/2 λp --------- --------- 140 575 --------- deg nm Dominant Wavelength λd ----- ----- 573 ----- nm Spectrum Radiation Bandwidth △λ ----- ----- 20 ----- nm Forward Voltage VF ----- 1.7 2.0 2.4 V Reverse Current IR ----- ----- ----- 10 μA IF=20 mA VR=5V 0805 SMD TYPE LED VAOL-S8SYGC-2012511-C Typical Electro-Optical Characteristics Curves 0805 SMD TYPE LED VAOL-S8SYGC-2012511-C Reel Dimensions Note: The tolerances unless mentioned is ±0.1mm ,Unit = mm 0805 SMD TYPE LED VAOL-S8SYGC-2012511-C Carrier Tape Dimensions: Loaded quantity3000 PCS per reel Note: The tolerances unless mentioned is ±0.1mm , Unit = mm Moisture Resistant Packaging Label Aluminum moisture-proof bag Desiccant Label 0805 SMD TYPE LED VAOL-S8SYGC-2012511-C Soldering Condition 1.Pb-free solder temperature profile 2.Reflow soldering should not be done more than two times. 3 When soldering, do not put stress on the LEDs during heating. 4 After soldering, do not warp the circuit board. Soldering Iron Each terminal is to go to the tip of soldering iron temperature less than 350℃ for 3 seconds within once in less than the soldering iron capacity 25W. Leave two seconds and more intervals, and do soldering of each terminal. Be careful because the damage of the product is often started at the time of the hand solder.