Introduction bus ic dc/dc converter motor driver ic ripple counter driver ic I/O ic Sensor interface ic sensor ic ip’s E 910.16 Fan control E 910.17 Fan control E 910.69 Controller for 3 pfb E 910.63 8-channel half bridge driver ÿ E 910.64/65 DC motor H-bridge controller E 910.68 VirtuHall® PMSM/BLDC E 910.88 VirtuHall® PMSM/PWM E 910.87 EC motor controller ÿ DC Motor Full Bridge Driver / Controller The E910.64/65 is a PWM DC Motor Bridge Controller to drive ex- ÿ Single voltage supply in the range of ternal N-channel power-FETs in a full bridge or double independ- Vbat = 6.0V to 40V ent half bridge configuration. The IC is designed for motor appli- ÿ Sleep mode current less than 50μA cations in the automotive world as well as for general purposes. ÿ High power efficiency of the whole motor regulator A digital algorithm for EMC optimation is implemented to reduce system (up to 96% @ fPWM = 20kHz) the generation of high frequency oscillations. The E910.64/65 fea- pinning package Pin Pin 1 1 ST Step up converter output 2 2 DG Diagnostic output 3 3 PWM PWM input 4 4 EN Enable input 5 5 DIR Direction select input 6 6 C12 Output of 12V-regulator, capacitor connection E910.64 E910.65 Name Description ÿ Automatically cross conduction protection tures several registers for programing the parameters of the slew ÿ PWM frequency up to 30kHz rate regulation. The special switching technology provides two ÿ Protection against over current (short circuit), main advantages: 7 7 RX K-Line interface, receiver output 8 8 TX K-Line interface, transmitter input 9 9 K _ LINE 10 10 VS Suplly voltage 11 15 CP Charge pump output 12 16 GH1 Gate drive output high side switch half bridge 1 13 17 CB1 Bootstrap capacitor half bridge 1 14 18 S1 Phase half bridge 1, sense input 15 19 GH2 Gate drive output high side switch half bridge 2 16 20 CB2 Bootstrap capacitor half bridge 2 17 21 S2 Phase half bridge 2, sense input 18 22 GL2 Gate drive output low side switch half bridge 2 19 23 GL1 Gate drive output low side switch half bridge 1 20 24 GND 11 DSENSE 12 GND2 Ground 2 13 INHIB Power down / wake up output 14 CFGB K-LINE or LIN configuration pin over voltage, under voltage and over temperature ÿ Diagnostic output and failure registers ÿ Excellent EMC behavior due to the very low RF emission ÿ Configurable via SPI ÿ High power efficiency up to 96% (both full and rise time ÿ Control of external reverse protection device ÿ K-Line or LIN Interface ÿ SO20 package/SO24 down up to < 200ns) With the EMC Performance the module developer will be able to save additional filter components in the power lines by driv- application ing a DC motor. Via SPI access it is possible to get data related to ÿ Electro-Hydraulic Power steering the diagnosis, treatment of motor and the Power FET failures. ÿ Parking brakes The IC is able to detect and to handle the follwing failures such ÿ Closure Systems as over current, short circuit, open load, over/under voltage and ÿ Wiper Systems over temperature. A K-Line or LIN 2.0 Interface connects the ap- plication to the bus system. There are two versions both with supply voltages up to 40V : E910.64 delivered in SO20 package and E910.65 delivered in SO24 package. Block diagram K-Line interface SO20 Ground Drain voltage of the high side power FETs SO24 THIS PRODUCT IS UNDER DEVELOPMENT description ÿ ÿ features E910.64 | 65 ÿ THIS PRODUCT IS UNDER DEVELOPMENT THIS PRODUCT IS UNDER DEVELOPMENT ÿ DC motor H-bridge controller, EMC optimized Note ELMOS Semiconductor AG (below ELMOS) reserves the right to make changes to the product contained in this publication without notice. ELMOS assumes no responsibility for the use of any circuits described herein, conveys no licence under any patent or other right, and makes no representation that the circuits are free of patent infringement. While the information in this publication has been checked, no responsibility, however, is assumed for inaccuracies. ELMOS does not recommend the use of any of its products in life support applications where the failure or malfunction of the product can reasonably be expected to cause failure of a life-support system or to significantly affect its safety or effectiveness. Products are not authorized for use in such applications. 48 Copyright © 2007 ELMOS Reproduction, in part or whole, without the prior written consent of ELMOS, is prohibited. www.elmos.de | [email protected] elmos product catalog 2007/2008 49