A-1130 Wien Lilienberggasse 13 Tel.: +43-1-403 08 12 Fax: +43-1-408 72 13 e-mail: [email protected] http://www.knap.at Wolfgang Knap Gesellschaft m.b.H. & Co.KG DS Series DIP-Switch 2-12 Position contact rating: insulation resistance: switch 25 mA @ 24 VDC, carry 100 mA @ 50VDC 100 MW min @ 500 VDC initial 50 mW @ 2-4 VDC @ 100 mA after life 100 mW @ 2-4 VDC @ 100 mA 2000 make-and-break cycle each circuit 1000 gf max. 2,0 mm typ. 500 V rms min @ sea level between adjacent terminals 5 pF max. between adjacent terminals operating and storage -40 to +85°C MIL-STD-202F, method 201A MIL-STD-202F, method 213B, condition A gold plated wave +260°C for 5 s 30 W hand soldering iron +320°C for 2 s typical keep all switches in the OFF position during soldering and cleaning process! contact resistance: operating life: operating force: actuator travel: dielectric strength: capacitance: temperature range: vibration: shock: pin plating: soldering recommendation: top tape seal option PCB mounting "N" extended actuator schematic "R" recessed actuator positions "A" (mm) "B" (mm) 2 6,44 2,54 3 8,89 5,08 4 11,52 7,62 5 14,06 10,16 6 16,60 12,70 7 19,14 15,24 8 21,68 17,78 9 24,22 20,32 10 26,76 22,86 12 31,84 27,94 model no. actuator positions color of cover seal soldering DS _ __ _ _ V N*) = extended 02, 03, 04, 05, 06, 07, 08, 09, 10, 12 R = recessed * or left blank = red (standard) = unsealed (standard) B = blue T = top tape sealed K = black Dokumentname: dlds.doc Seite 1 von 1 V = lead free Ausgabedatum: 05-11-22