A-1130 Wien Lilienberggasse 13 Tel.: +43-1-403 08 12 Fax: +43-1-408 72 13 e-mail: [email protected] http://www.knap.at Wolfgang Knap Gesellschaft m.b.H. & Co.KG DI Series DIP-Switch 1-10 Position contact rating: insulation resistance: contact resistance: operating life: operating force: actuator travel: dielectric strength: capacitance: temperature range: vibration: shock: pin plating: soldering recommendation: switch 25 mA @ 24 VDC, carry 100 mA @ 50VDC 100 MW min @ 500 VDC initial 20 mW @ 2-4 VDC @ 100 mA after life 20 mW @ 2-4 VDC @ 100 mA 2000 make-and-break cycle each circuit 1000 gf max. 1,0 mm typ. 500 V rms min @ sea level between adjacent terminals 5 pF max. between adjacent terminals operating and storage -40 to +85°C MIL-STD-202F, method 201A MIL-STD-202F, method 213B, condition A tin plated wave +260°C for 5 s 30 W hand soldering iron +320°C for 2 s typical keep all switches in the OFF position during soldering and cleaning process! PCB mounting straight "H" schematic splay "S" for IC machine insertion positions mm "A" (inch) mm "B" (inch) 1 3,84 (0,137) 2 6,02 (0,237) 2,54 (0,100) 4 11,10 (0,437) 7,62 (0,300) 6 16,18 (0,637) 12,70 (0,500) 8 21,26 (0,837) 17,78 (0,700) 10 26,34 (1,037) 22,86 (0,900) model no. actuator positions pin spacing seal DI _ __ _ _ none = raised R = recessed 01, 02, 04, 06, 08, 10 H = 7,62 mm straight pin none = standard tube S = 9,84 mm splay IC pin T = top tape seal *) *) top tape seal is not available for 01 position or extended actuator Dokumentname: dldi.doc Seite 1 von 1 Ausgabedatum: 02-03-23