SPU131 1 3 0 Wa t t D e s k t o p Switching Power Supplies series Wide Input Voltage 90 to 264 VAC, 47 to 63 Hz IEC-320-C14 Input Inlet Single Output Class I Input Surge Current, Over Voltage and Over Current Protection LPS Efficiency Level V Active Power Factor Correction Optional ON/OFF Switch Model Number Output Voltage Output Amps Output Connector SPU131-105(S) SPU131-106(S) SPU131-107(S) SPU131-108(S) SPU131-109(S) SPU131-110(S) SPU131-111(S) SPU131-112(S) 12 Volts(DC) 15 Volts(DC) 18 Volts(DC) 24 Volts(DC) 30 Volts(DC) 36 Volts(DC) 48 Volts(DC) 55 Volts(DC) 10.84 Amps 8.66 Amps 7.22 Amps 5.42 Amps 4.33 Amps 3.61 Amps 2.70 Amps 2.36 Amps 5 Pin DIN 5 Pin DIN 5 Pin DIN 5 Pin DIN 2.1mm Coax. 2.1mm Coax. 2.1mm Coax. 2.1mm Coax. Note: “(S)” Denotes that there is an ON/OFF Switch option available for the SPU131 family of products. To order an SPU131 product with the optional ON/OFF Switch, simply add an “S” to the end of the standard Part Number. For example SPU131-105S. WWW.ASTRODYNE.COM ASTRODYNE USA: 1-800-823-8082 ASTRODYNE PACIFIC: 886-2-26983458 SPU131 1 3 0 Wa t t D e s k t o p Switching Power Supplies INPUT SPECIFICATIONS Input Voltage Range Frequency Range Input Current @ FL Inrush Current @ FL (Cold Start) Leakage Current @ FL Power Factor @ FL PHYSICAL SPECIFICATIONS 90-260 VAC 47-63 Hz Low Line 1.32Amps @ 115VAC High Line 0.66Amps @ 230VAC Low Line 30Amps max @ 115VAC High Line 50Amps max @ 230VAC 0.75 mAmps max.@ 240VAC/60 Hz 0.95 min. @ 230VAC OUTPUT SPECIFICATIONS Voltage and Current Load Regulation @ FL Line Regulation @ FL Transient Response Ripple/Noise @ FL Start Up @ FL Hold Up Time @ FL Over Current Protection Over Voltage Protection series See Selection Charts ± 5%, max. @ 230VAC ± 5%, typ. ± 0.5% typ. 4mS @ 100VAC 1% max. pk-pk @ 90VAC 2S max. @ 100VAC 16mS min @ 110VAC 110~150% 112~132% Size Weight 188.9 x 89.5 x 45.5 mm 7.44” x 3.52” x 1.79” 27.44-28.22 oz (778-800g) ENVIRONMENTAL SPECIFICATIONS Oper. Temperature Storage Temperature Relative Humidity MTBF Temperature Coefficient Isolation Resistance Efficiency Level 0 to +70°C (See derate curve) -40 to +85°C 5% to 95%, non-cond 0.1 MHrs MIL-HDBK-217F(25°C) ±0.04%/°C 50 MΩ / 230VAC V DERATE CURVE GENERAL SPECIFICATIONS Isolation Efficiency @ FL @230VAC EMI 4242 Volts(DC) Input-Output 2121 Volts(DC) Input-Ground 88% typ. CISPR-22 Class B @ 220VAC FCC PART-15 Class B @ 110VAC All specifications are typical at nominal input, full load, and 25°C unless otherwise noted WWW.ASTRODYNE.COM Astrodyne products are not authorized or warranteed for use as critical components in life support systems, equipment used in hazardous environments, nuclear controls systems, or other mission-critical applications. ASTRODYNE USA: 1-800-823-8082 ASTRODYNE PACIFIC: 886-2-26983458 SPU131 1 3 0 Wa t t D e s k t o p Switching Power Supplies series MECHANICAL DIMENSIONS 5 Pin DIN 1 3 4 2 5 1. COM 2. COM 3. Vout 4. COM 5. Vout Shell = GND COAXIAL PLUG: 5.5mm outer diameter 2.1mm inner diameter, female 11mm length, center “+” -Vout +Vout SPU131-105~110 Output Cord Length 48”, 16AWG SPU131-111~112 Output Cord Length 48”, 18AWG WWW.ASTRODYNE.COM ASTRODYNE USA: 1-800-823-8082 ASTRODYNE PACIFIC: 886-2-26983458