SPU131 130 Wa t t D e s k t o p S w i t c hi ng P ow er S upplie s series Wide Input Voltage 90 to 264 VAC, 47 to 63 Hz IEC-320-C14 Input Inlet Single Output Class I Input Surge Current, Over Voltage and Over Current Protection LPS Efficiency Level V Active Power Factor Correction Optional ON/OFF Switch Model Number Output Voltage Output Amps Output Connector SPU131-105(S) SPU131-106(S) SPU131-107(S) SPU131-108(S) SPU131-109(S) SPU131-110(S) SPU131-111(S) SPU131-112(S) 12 Volts(DC) 15 Volts(DC) 18 Volts(DC) 24 Volts(DC) 30 Volts(DC) 36 Volts(DC) 48 Volts(DC) 55 Volts(DC) 10.84 Amps 8.66 Amps 7.22 Amps 5.42 Amps 4.33 Amps 3.61 Amps 2.70 Amps 2.36 Amps 5 Pin DIN 5 Pin DIN 5 Pin DIN 5 Pin DIN 2.1mm Coax. 2.1mm Coax. 2.1mm Coax. 2.1mm Coax. Note: “(S)” Denotes that there is an ON/OFF Switch option available for the SPU131 family of products. To order an SPU131 product with the optional ON/OFF Switch, simply add an “S” to the end of the standard Part Number. For example SPU131-105S. WWW.ASTRODYNETDI.COM ASTRODYNE USA: 1-800-823-8082 ASTRODYNE PACIFIC: 886-2-26983458 SPU131 130 Wa t t D e s k t o p S w i t c hi ng P ow er S upplie s INPUT SPECIFICATIONS Input Voltage Range Frequency Range Input Current @ FL Inrush Current @ FL (Cold Start) Leakage Current @ FL Power Factor @ FL PHYSICAL SPECIFICATIONS 90-260 VAC 47-63 Hz Low Line 1.32Amps @ 115VAC High Line 0.66Amps @ 230VAC Low Line 30Amps max @ 115VAC High Line 50Amps max @ 230VAC 0.75 mAmps max.@ 240VAC/60 Hz 0.95 min. @ 230VAC OUTPUT SPECIFICATIONS Voltage and Current Load Regulation @ FL Line Regulation @ FL Transient Response Ripple/Noise @ FL Start Up @ FL Hold Up Time @ FL Over Current Protection Over Voltage Protection series See Selection Charts ± 5%, max. @ 230VAC ± 5%, typ. ± 0.5% typ. 4mS @ 100VAC 1% max. pk-pk @ 90VAC 2S max. @ 100VAC 16mS min @ 110VAC 110~150% 112~132% Size Weight 188.9 x 89.5 x 45.5 mm 7.44” x 3.52” x 1.79” 27.44-28.22 oz (778-800g) ENVIRONMENTAL SPECIFICATIONS Oper. Temperature Storage Temperature Relative Humidity MTBF Temperature Coefficient Isolation Resistance Efficiency Level 0 to +70°C (See derate curve) -40 to +85°C 5% to 95%, non-cond 0.1 MHrs MIL-HDBK-217F(25°C) ±0.04%/°C 50 MΩ / 230VAC V DERATE CURVE GENERAL SPECIFICATIONS Isolation Efficiency @ FL @230VAC EMI 4242 Volts(DC) Input-Output 2121 Volts(DC) Input-Ground 88% typ. CISPR-22 Class B @ 220VAC FCC PART-15 Class B @ 110VAC All specifications are typical at nominal input, full load, and 25°C unless otherwise noted WWW.ASTRODYNETDI.COM ASTRODYNE USA: 1-800-823-8082 ASTRODYNE PACIFIC: 886-2-26983458 SPU131 130 Wa t t D e s k t o p S w i t c hi ng P ow er S upplie s series MECHANICAL DIMENSIONS 5 Pin DIN 1 3 4 2 5 1. COM 2. COM 3. Vout 4. COM 5. Vout Shell = GND COAXIAL PLUG: 5.5mm outer diameter 2.1mm inner diameter, female 11mm length, center “+” -Vout +Vout SPU131-105~110 Output Cord Length 48”, 16AWG SPU131-111~112 Output Cord Length 48”, 18AWG WWW.ASTRODYNETDI.COM 3113 ASTRODYNE USA: 1-800-823-8082 ASTRODYNE PACIFIC: 886-2-26983458