SPU100 1 0 0 Wa t t D e s k t o p Switching Power Supplies series Wide Input Voltage 90 to 264 VAC, 47 to 63 Hz IEC-320-C14 Input Inlet Single Output Class I Input Surge Current, Over Voltage and Over Current Protection LPS Efficiency Level V Active Power Factor Correction Model Number Output Voltage Output Amps Output Connector SPU100-105 SPU100-106 SPU100-107 SPU100-108 SPU100-109 SPU100-110 SPU100-111 12 Volts(DC) 15 Volts(DC) 18 Volts(DC) 24 Volts(DC) 30 Volts(DC) 36 Volts(DC) 48 Volts(DC) 8.33 Amps 6.66 Amps 5.55 Amps 4.16 Amps 3.33 Amps 2.77 Amps 2.08 Amps 5 Pin DIN 5 Pin DIN 5 Pin DIN 2.1mm Coax. 2.1mm Coax. 2.1mm Coax. 2.1mm Coax. WWW.ASTRODYNE.COM ASTRODYNE USA: 1-800-823-8082 ASTRODYNE PACIFIC: 886-2-26983458 SPU100 1 0 0 Wa t t D e s k t o p Switching Power Supplies INPUT SPECIFICATIONS Input Voltage Range Frequency Range Input Current @ FL Inrush Current @ FL (Cold Start) Leakage Current @ FL Power Factor @ FL PHYSICAL SPECIFICATIONS 90-260 VAC 47-63 Hz Low Line 1.35Amps @ 115VAC High Line 0.5Amps @ 230VAC Low Line 50Amps max @ 115VAC High Line 100Amps max @ 230VAC 0.75 mAmps max.@ 240VAC/60 Hz 0.95 min. @ 230VAC OUTPUT SPECIFICATIONS Voltage and Current Load Regulation @ FL Line Regulation @ FL Transient Response Ripple/Noise @ FL Start Up @ FL Hold Up Time @ FL Over Current Protection Over Voltage Protection series See Selection Charts ± 5%, max. @ 230VAC ± 0.5% typ. 4mS @ 100VAC 1% max. pk-pk @ 90VAC 2S max. @ 100VAC 12mS min @ 110VAC 110~150% 112~132% Size Weight 146 x 76 x 43 mm 5.75” x 3” x 1.69” 17.28-23.63 oz (490-670g) ENVIRONMENTAL SPECIFICATIONS Oper. Temperature Storage Temperature Relative Humidity MTBF Temperature Coefficient Isolation Resistance Efficiency Level 0 to +70°C (See derate curve) -40 to +85°C 5% to 95%, non-cond 0.1 MHrs MIL-HDBK-217F(25°C) ±0.04%/°C 50 MΩ / 2100VDC Test Voltage V DERATE CURVE GENERAL SPECIFICATIONS Isolation Efficiency @ FL @230VAC EMI 4242 Volts(DC) Input-Output 2121 Volts(DC) Input-Ground 87% typ. CISPR-11 Class B @ 220VAC FCC PART-15 Class B @ 120VAC All specifications are typical at nominal input, full load, and 25°C unless otherwise noted WWW.ASTRODYNE.COM Astrodyne products are not authorized or warranteed for use as critical components in life support systems, equipment used in hazardous environments, nuclear controls systems, or other mission-critical applications. ASTRODYNE USA: 1-800-823-8082 ASTRODYNE PACIFIC: 886-2-26983458 SPU100 1 0 0 Wa t t D e s k t o p Switching Power Supplies series MECHANICAL DIMENSIONS Output Cord Length 48” WWW.ASTRODYNE.COM ASTRODYNE USA: 1-800-823-8082 ASTRODYNE PACIFIC: 886-2-26983458