8 PIN DIP HIGH SPEED 10MBit/s LOGIC GATE PHOTOCOUPLER EL263X series Schematic 1 8 2 7 3 6 4 5 Features • High speed 10Mbit/s • 10kV/μs min. common mode transient immunity (EL2631) • Guaranteed performance from -40 to 85℃ • Logic gate output • High isolation voltage between input and output (Viso=5000 Vrms ) • Pb free and RoHS compliant. • UL and cUL approved(No. E214129) • VDE approved (No. 132249) • SEMKO approved • NEMKO approved • DEMKO approved • FIMKO approved A 0.1μF bypass capacitor must be *3 connected between pins 8 and 5 Pin Configuration 1, No Connection 2, Anode 3, Cathode 4. No Connection 5, Gnd 6, Vout 7, VE 8, VCC Description The EL2630 and EL2631 are consists of an infrared emitting diode optically coupled to a high speed integrated photo detector logic gate with a strobable output. It is packaged in a 8-pin DIP package and available in wide-lead spacing and SMD options. Applications • Ground loop elimination • LSTTL to TTL, LSTTL or 5 volt CMOS • Line receiver, data transmission • Data multiplexing • Switching power supplies • Pulse transformer replacement • Computer peripheral interface • High speed logic ground isolation 1 Truth Table (Positive Logic) Input H L Output L H Copyright © 2010, Everlight All Rights Reserved. Release Date : May 13, 2013. Issue No: DPC-0000144 Rev.2 www.everlight.com DATASHEET 8 PIN DIP HIGH SPEED 10MBit/s LOGIC GATE PHOTOCOUPLER EL263X series Absolute Maximum Ratings (TA=25°C) Parameter Symbol Rating Unit Forward current IF 20 mA Reverse voltage VR 5 V Power dissipation PD 40 mW Power dissipation PC 60 mW Output current IO 50 mA Output voltage VO 7.0 V Supply voltage VCC 7.0 V PO 85 mW VISO 5000 Vrms Operating temperature TOPR -40~+100 °C Storage temperature TSTG -55~+125 °C TSOL 260 °C Input Output Output Power Dissipation Isolation voltage *1 Soldering temperature *2 Notes: *1 AC for 1 minute, R.H.= 40 ~ 60% R.H. In this test, pins 1, 2, 3 & 4 are shorted together, and pins 5, 6, 7 & 8 are shorted together. *2 For 10 seconds. 2 Copyright © 2010, Everlight All Rights Reserved. Release Date : May 13, 2013. Issue No:DPC-0000144 Rev.2 www.everlight.com DATASHEET 8 PIN DIP HIGH SPEED 10MBit/s LOGIC GATE PHOTOCOUPLER EL263X series Electrical Characteristics (TA =-40 to 85°C unless specified otherwise) Input Symbol Min. Typ.* Max. Unit Forward voltage VF - 1.4 1.8 V IF = 10mA, TA=25°C Reverse voltage VR 5.0 - - V IR = 10μA VF/TA - -1.8 - mV/°C IF =10mA CIN - 60 - pF VF=0, f=1MHz Symbol Min Typ.* Max. Unit Condition Parameter Temperature coefficient of forward voltage Input capacitance Condition Output Parameter High level supply current Low level supply current ICCH - 12.5 18 mA IF=0mA, VCC=5.5V ICCL - 14.5 21 mA IF=10mA, VCC=5.5V Transfer Characteristics (TA =-40 to 85°C unless specified otherwise) Symbol Min Typ. Max. Unit Condition HIGH Level Output Current IOH - 2.1 100 µA VCC=5.5V, VO=5.5V, IF=250μA LOW Level Output Current VOL - 0.35 0.6 V VCC = 5.5V, IF=5mA, ICL=13mA Input Threshold Current IFT - 2.5 5 mA VCC= 5.5V, VO=0.6V, IOL=13mA Parameter Switching Characteristics (TA =-40 to 85°C, VCC=5V, IF=7.5mA unless specified otherwise) Parameter Propagation delay time 4 to output High level* (Fig.12) Propagation delay time 5 to output Low level* (Fig.12) Pulse width distortion Symbol Min Typ. Max. Unit Condition TPLH - 35 100 ns CL = 15pF, RL=350Ω, TA=25°C TPHL - 40 100 ns CL = 15pF, RL=350Ω, TA=25°C |TPHL–TPLH| - 5 35 ns CL = 15pF, RL=350Ω tr - 40 - ns CL = 15pF, RL=350Ω tf - 10 - ns CL = 15pF, RL=350Ω 6 Output rise time* (Fig.12) 7 Output fall time* (Fig.12) 3 Copyright © 2010, Everlight All Rights Reserved. Release Date : May 13, 2013. Issue No:DPC-0000144 Rev.2 www.everlight.com DATASHEET 8 PIN DIP HIGH SPEED 10MBit/s LOGIC GATE PHOTOCOUPLER EL263X series Switching Characteristics (TA =-40 to 85°C, VCC=5V, IF=7.5mA unless specified otherwise) Parameter Common Mode Transient Immunity at *8 Logic High Common Mode Transient Immunity at *9 Logic Low 4 Symbol EL2630 Min Typ. Max. 5,000 - V/µS CMH EL2631 10,000 20,000 - EL2630 5,000 - V/µS CML EL2631 Unit 10,000 20,000 - Copyright © 2010, Everlight All Rights Reserved. Release Date : May 13, 2013. Issue No:DPC-0000144 Rev.2 Condition IF = 0mA , VCM=1KVp-p, VOH=2.0V, RL=350Ω, TA=25°C(Fig.13) IF = 0mA , VCM=1KVp-p, VOH=2.0V, RL=350Ω, TA=25°C(Fig.13) IF = 7.5mA, VCM=1KVp-p, VOL=0.8V, RL=350Ω, TA=25°C(Fig.13) IF = 7.5mA, VCM=1KVp-p, VOL=0.8V, RL=350Ω, TA=25°C(Fig.13) www.everlight.com DATASHEET 8 PIN DIP HIGH SPEED 10MBit/s LOGIC GATE PHOTOCOUPLER EL263X series Typical Electro-Optical Characteristics Curves 5 Copyright © 2010, Everlight All Rights Reserved. Release Date : May 13, 2013. Issue No:DPC-0000144 Rev.2 www.everlight.com DATASHEET 8 PIN DIP HIGH SPEED 10MBit/s LOGIC GATE PHOTOCOUPLER EL263X series Fig. 11 Test circuit and waveforms for tPHL, tPLH, tr, and tf IF=7.5mA Input (IF) IF=3.75mA tPHL tPLH Output (Vo) 1.5V 90% Output (Vo) 10% tf 6 Copyright © 2010, Everlight All Rights Reserved. Release Date : May 13, 2013. Issue No:DPC-0000144 Rev.2 tr www.everlight.com DATASHEET 8 PIN DIP HIGH SPEED 10MBit/s LOGIC GATE PHOTOCOUPLER EL263X series Fig. 12 Test circuit Common mode Transient Immunity Peak VCM 0V 5V Vo Switching Pos. (A), IF=0 CMH VO(Min) VO(Max) Switching Pos. (B), IF=7.5mA VCM CML 0.5V Note *3 The VCC supply must be bypassed by a 0.1μF capacitor or larger. This can be either a ceramic or solid tantalum capacitor with good high frequency characteristic and should be connected as close as possible to the package VCC and GND pins *4. tPLH– Propagation delay is measured from the 3.75mA level on the HIGH to LOW transition of the input current pulse to the 1.5 V level on the LOW to HIGH transition of the output voltage pulse. *5. tPHL– Propagation delay is measured from the 3.75mA level on the LOW to HIGH transition of the input current pulse to the 1.5 V level on the HIGH to LOW transition of the output voltage pulse. *6. tr– Rise time is measured from the 90% to the 10% levels on the LOW to HIGH transition of the output pulse. *7. tf– Fall time is measured from the 10% to the 90% levels on the HIGH to LOW transition of the output pulse. *8 CMH– The maximum tolerable rate of rise of the common mode voltage to ensure the output will remain in the HIGH state (i.e., VOUT > 2.0V). *9 CML– The maximum tolerable rate of rise of the common mode voltage to ensure the output will remain in the LOW output state (i.e., VOUT < 0.8V). 7 Copyright © 2010, Everlight All Rights Reserved. Release Date : May 13, 2013. Issue No:DPC-0000144 Rev.2 www.everlight.com DATASHEET 8 PIN DIP HIGH SPEED 10MBit/s LOGIC GATE PHOTOCOUPLER EL263X series Order Information Part Number EL263XY(Z)-V Note X Y Z V 8 = (0 or 1) for EL26 part no. = Lead form option (S, S1, M or none) = Tape and reel option (TA, TB or none). = VDE (optional) Option None Description Packing quantity Standard DIP-8 45 units per tube M Wide lead bend (0.4 inch spacing) 45 units per tube S (TA) Surface mount lead form + TA tape & reel option 1000 units per reel S (TB) Surface mount lead form + TB tape & reel option 1000 units per reel S1 (TA) Surface mount lead form (low profile) + TA tape & reel option 1000 units per reel S1 (TB) Surface mount lead form (low profile) + TB tape & reel option 1000 units per reel Copyright © 2010, Everlight All Rights Reserved. Release Date : May 13, 2013. Issue No:DPC-0000144 Rev.2 www.everlight.com DATASHEET 8 PIN DIP HIGH SPEED 10MBit/s LOGIC GATE PHOTOCOUPLER EL263X series Package Dimension (Dimensions in mm) Standard DIP Type Option M Type 9 Copyright © 2010, Everlight All Rights Reserved. Release Date : May 13, 2013. Issue No:DPC-0000144 Rev.2 www.everlight.com DATASHEET 8 PIN DIP HIGH SPEED 10MBit/s LOGIC GATE PHOTOCOUPLER EL263X series Option S Type Option S1 Type 10 Copyright © 2010, Everlight All Rights Reserved. Release Date : May 13, 2013. Issue No:DPC-0000144 Rev.2 www.everlight.com DATASHEET 8 PIN DIP HIGH SPEED 10MBit/s LOGIC GATE PHOTOCOUPLER EL263X series Recommended pad layout for surface mount leadform Device Marking EL 2631 YWWV Notes EL 2631 Y WW V 11 denotes EVERLIGHT denotes Device Number denotes 1 digit Year code denotes 2 digit Week code denotes VDE (optional) Copyright © 2010, Everlight All Rights Reserved. Release Date : May 13, 2013. Issue No:DPC-0000144 Rev.2 www.everlight.com DATASHEET 8 PIN DIP HIGH SPEED 10MBit/s LOGIC GATE PHOTOCOUPLER EL263X series Tape & Reel Packing Specifications Option TB Option TA Direction of feed from reel Direction of feed from reel Tape dimension 12 Dimension No. A B Do D1 E F Dimension(mm) 10.4±0.1 10.0±0.1 1.5+0.1/-0 1.5±0.25/-0 1.75±0.1 7.5±0.1 Dimension No. Po P1 P2 t W K Dimension(mm) 4.0±0.1 12.0±0.1 2.0±0.05 0.4±0.05 16.0±0.3/ 4.5±0.1 Copyright © 2010, Everlight All Rights Reserved. Release Date : May 13, 2013. Issue No:DPC-0000144 Rev.2 www.everlight.com DATASHEET 8 PIN DIP HIGH SPEED 10MBit/s LOGIC GATE PHOTOCOUPLER EL263X series Precautions for Use 1. Soldering Condition 1.1 (A) Maximum Body Case Temperature Profile for evaluation of Reflow Profile Note: Reference: IPC/JEDEC J-STD-020D Preheat Temperature min (Tsmin) 150°C Temperature max (Tsmax) 200°C Time (Tsmin to Tsmax) (ts) Average ramp-up rate (Tsmax to Tp) 60-120 seconds 3°C/second max Other Liquidus Temperature (TL) 217°C Time above Liquidus Temperature (t L) 60-100 sec Peak Temperature (TP) 260°C Time within 5 °C of Actual Peak Temperature: TP - 5°C 30 s Ramp- Down Rate from Peak Temperature 6°C /second max. Time 25°C to peak temperature Reflow times 8 minutes max. 3 times 13 Copyright © 2010, Everlight All Rights Reserved. Release Date : May 13, 2013. Issue No:DPC-0000144 Rev.2 www.everlight.com DATASHEET 8 PIN DIP HIGH SPEED 10MBit/s LOGIC GATE PHOTOCOUPLER EL263X series DISCLAIMER 1. Above specification may be changed without notice. EVERLIGHT will reserve authority on material change for above specification. 2. When using this product, please observe the absolute maximum ratings and the instructions for using outlined in these specification sheets. EVERLIGHT assumes no responsibility for any damage resulting from use of the product which does not comply with the absolute maximum ratings and the instructions included in these specification sheets. 3. These specification sheets include materials protected under copyright of EVERLIGHT Corporation. Please don’t reproduce or cause anyone to reproduce them without EVERLIGHT’s consent. 14 Copyright © 2010, Everlight All Rights Reserved. Release Date : May 13, 2013. Issue No:DPC-0000144 Rev.2 www.everlight.com