8 PIN DIP DUAL CHANNEL HIGH SPEED 1Mbit/s TRANSISTOR PHOTOCOUPLER EL253X series Schematic Features • High speed 1Mbit/s • 10kV/μs min. common mode transient immunity (EL2611) • Guaranteed performance from -40 to 85℃ • Logic gate output • High isolation voltage between input and output (Viso=5000 V rms ) • Pb free and RoHS compliant. • UL and cUL approved(No. E214129) • VDE approved (No. 132249) • SEMKO approved • NEMKO approved • DEMKO approved • FIMKO approved Pin Configuration 1. Anode 2. Cathode 3. Cathode 4. Anode 5. Gnd 6. Vout2 7. Vout1 8. VCC Description The EL2530 and EL2531 dual channel devices each consist of an infrared emitting diode, optically coupled to a high speed photo detector transistor. A separate connection for the photodiode bias and output-transistor collector increase the speed by several orders of magnitude over conventional phototransistor couplers by reducing the base-collector capacitance of the input transistor. The devices are packaged in an 8-pin DIP package and available in wide-lead spacing and SMD option. Applications • Line receivers • Telecommunication equipments • Power transistor isolation in motor drives • Replacement for low speed phototransistor photo couplers • Feedback loop in switch-mode power supplies • Home appliances • High speed logic ground isolation 1 Truth Table (Positive Logic) Input H L H L H L Copyright © 2010, Everlight All Rights Reserved. Release Date : May 13, 2013. Issue No: DPC-0000148 Rev.2 Enable H H L L NC NC Output L H H H L H www.everlight.com DATASHEET 8 PIN DIP DUAL CHANNEL HIGH SPEED 1Mbit/s TRANSISTOR PHOTOCOUPLER EL253X series Absolute Maximum Ratings (TA=25℃) Parameter Symbol Rating Unit IF 25 mA IFP 50 mA IFtrans 1 A Reverse voltage VR 5 V Power dissipation PIN 45 mW Power dissipation PO 35 mW Average Output current IO(AVG) 8 mA Peak Output current IO(PK) 16 mA Output voltage VO -0.5 to 20 V Supply voltage VCC -0.5 to 30 V VISO 5000 V rms Operating temperature TOPR -40 ~ +100 °C Storage temperature TSTG -40 ~ +125 °C TSOL 260 °C Forward current Input Output Peak forward current (50% duty, 1ms P.W) Peak transient current (≤1μs P.W,300pps) Isolation voltage *1 Soldering temperature *2 Notes: *1 AC for 1 minute, R.H.= 40 ~ 60% R.H. In this test, pins 1, 2, 3 & 4 are shorted together, and pins 5, 6, 7 & 8 are shorted together. *2 For 10 seconds. 2 Copyright © 2010, Everlight All Rights Reserved. Release Date : May 13, 2013. Issue No:DPC-0000148 Rev.2 www.everlight.com DATASHEET 8 PIN DIP DUAL CHANNEL HIGH SPEED 1Mbit/s TRANSISTOR PHOTOCOUPLER EL253X series Electrical Characteristics (TA=0 to 70°C unless specified otherwise) Input Symbol Min. Typ. Max. Unit Forward voltage VF - 1.45 1.8 V IF = 16mA, TA=25℃ Reverse voltage VR 5.0 - - V IR = 10μA VF/TA - -1.9 - mV/°C IF = 16mA CIN - 60 - pF VF=0V, f=1MHz Parameter Temperature coefficient of forward voltage Input capacitance Condition Output Parameter Logic High Output Current Logic Low Supply Current Logic High Supply Current Symbol Min. Typ.* Max. - 0.001 0.5 µA IOH ICCL Unit - - 50 - 140 400 - 0.01 1 - - IF=0mA, VO=VCC=5.5V, TA=25°C IF=0mA, VO=VCC=15V TA=25°C µA µA ICCH Conditions IF1=IF216mA, VO=Open, VCC=15V IF=0mA, VO=Open, VCC=15V, TA=25°C IF=0mA, VO=Open, VCC=15V 4 * Typical values at TA = 25°C Transfer Characteristics (TA=0 to 70°C unless specified otherwise) Parameter Symbol Min. Typ.* Max. 7 - 50 19 - 50 EL2530 5 - - EL2531 15 - - EL2530 - 0.18 0.5 IF = 16mA ,IO = 1.1mA, VCC=4.5V, TA=25°C EL2531 - 0.25 0.5 IF = 16mA ,IO = 3mA, VCC=4.5V, TA=25°C EL2530 - - 0.5 IF = 16mA ,IO = 0.8mA, VCC=4.5V EL2531 - - 0.5 IF=16mA ,IO=2.4mA, VCC=4.5V EL2530 Current Transfer Ratio EL2531 Logic Low Output Voltage 3 CTR Unit IF = 16mA ,VO = 0.4V, VCC=4.5V, TA=25°C % IF = 16mA ,VO = 0.5V, VCC=4.5V V VOL Conditions Copyright © 2010, Everlight All Rights Reserved. Release Date : May 13, 2013. Issue No:DPC-0000148 Rev.2 www.everlight.com DATASHEET 8 PIN DIP DUAL CHANNEL HIGH SPEED 1Mbit/s TRANSISTOR PHOTOCOUPLER EL253X series Switching Characteristics (TA=0 to 70°C unless specified otherwise, IF=16mA, Vcc=5V) Parameter Propagation Delay Time to Logic Low (Fig.8) Propagation Delay Time to Logic High (Fig.8) Common Mode Transient Immunity at Logic High *3 (Fig.9) Common Mode Transient Immunity at Logic Low (Fig.9)*3 Symbol EL2530 tPHL EL2531 EL2530 tPLH Min. Typ.* Max. - 0.35 1.5 - - 2.0 - 0.35 0.8 RL=1.9KΩ, TA=25°C - - 1.0 RL=1.9KΩ - 0.5 1.5 RL=4.1KΩ, TA=25°C - - 2.0 - 0.3 0.8 - - 1.0 1,000 10,000 - Unit RL=4.1KΩ, TA=25°C µs RL=1.9KΩ, TA=25°C RL=1.9KΩ V/µs CMH RL=4.1KΩ RL=4.1KΩ µs EL2531 EL2530 Conditions IF = 0mA , VCM=10Vp-p, RL=4.1KΩ, TA =25°C EL2531 1,000 10,000 - IF = 0mA , VCM=1000Vp-p, RL=1.9KΩ, TA =25°C EL2530 1,000 10,000 - IF = 16mA , VCM=10Vp-p, RL=4.1KΩ, TA =25°C V/µs CML EL2531 1,000 10,000 - IF = 16mA , VCM=1000Vp-p, RL=1.9KΩ, TA=25°C * Typical values at TA = 25°C 4 Copyright © 2010, Everlight All Rights Reserved. Release Date : May 13, 2013. Issue No:DPC-0000148 Rev.2 www.everlight.com DATASHEET 8 PIN DIP DUAL CHANNEL HIGH SPEED 1Mbit/s TRANSISTOR PHOTOCOUPLER EL253X series Typical Electro-Optical Characteristics Curves 5 Copyright © 2010, Everlight All Rights Reserved. Release Date : May 13, 2013. Issue No:DPC-0000148 Rev.2 www.everlight.com DATASHEET 8 PIN DIP DUAL CHANNEL HIGH SPEED 1Mbit/s TRANSISTOR PHOTOCOUPLER EL253X series Fig. 8 Switching Time Test Circuit & Waveform Fig. 9 Transient Immunity Test Circuit & Waveform Note: *3 Common mode transient immunity in logic high level is the maximum tolerable (positive) dVcm/dt on the leading edge of the common mode pulse signal VCM, to assure that the output will remain in a logic high state (i.e., V O > 2.0V). Common mode transient immunity in logic low level is the maximum tolerable (negative) dVcm/dt on the trailing edge of the common mode pulse signal, VCM, to assure that the output will remain in a logic low state (i.e., VO < 0.8V). 6 Copyright © 2010, Everlight All Rights Reserved. Release Date : May 13, 2013. Issue No:DPC-0000148 Rev.2 www.everlight.com DATASHEET 8 PIN DIP DUAL CHANNEL HIGH SPEED 1Mbit/s TRANSISTOR PHOTOCOUPLER EL253X series Order Information Part Number EL253XY(Z)-V Note X Y Z V 7 = Part no. (0 or 1) = Lead form option (S, S1, M or none) = Tape and reel option (TA, TB or none) = VDE (optional) Option None M S (TA) Description Standard DIP-8 Wide lead bend (0.4 inch spacing) Surface mount lead form + TA tape & reel option Packing quantity 45 units per tube 45 units per tube 1000 units per reel S (TB) Surface mount lead form + TB tape & reel option 1000 units per reel S1 (TA) S1 (TB) Surface mount lead form (low profile) + TA tape & reel option Surface mount lead form (low profile) + TB tape & reel option 1000 units per reel 1000 units per reel Copyright © 2010, Everlight All Rights Reserved. Release Date : May 13, 2013. Issue No:DPC-0000148 Rev.2 www.everlight.com DATASHEET 8 PIN DIP DUAL CHANNEL HIGH SPEED 1Mbit/s TRANSISTOR PHOTOCOUPLER EL253X series Package Dimension (Dimensions in mm) Standard DIP Type Option M Type 8 Copyright © 2010, Everlight All Rights Reserved. Release Date : May 13, 2013. Issue No:DPC-0000148 Rev.2 www.everlight.com DATASHEET 8 PIN DIP DUAL CHANNEL HIGH SPEED 1Mbit/s TRANSISTOR PHOTOCOUPLER EL253X series Option S Type Option S1 Type 9 Copyright © 2010, Everlight All Rights Reserved. Release Date : May 13, 2013. Issue No:DPC-0000148 Rev.2 www.everlight.com DATASHEET 8 PIN DIP DUAL CHANNEL HIGH SPEED 1Mbit/s TRANSISTOR PHOTOCOUPLER EL253X series Recommended pad layout for surface mount leadform Device Marking EL 2530 YWWV Notes EL 2530 Y WW V 10 denotes EVERLIGHT denotes Device Number denotes 1 digit Year code denotes 2 digit Week code denotes VDE (optional) Copyright © 2010, Everlight All Rights Reserved. Release Date : May 13, 2013. Issue No:DPC-0000148 Rev.2 www.everlight.com DATASHEET 8 PIN DIP DUAL CHANNEL HIGH SPEED 1Mbit/s TRANSISTOR PHOTOCOUPLER EL253X series Tape & Reel Packing Specifications Option TB Option TA Direction of feed from reel Direction of feed from reel Tape dimension 11 Dimension No. A B Do D1 E F Dimension(mm) 10.4±0.1 10.0±0.1 1.5+0.1/-0 1.5±0.25/-0 1.75±0.1 7.5±0.1 Dimension No. Po P1 P2 t W K Dimension(mm) 4.0±0.1 12.0±0.1 2.0±0.05 0.4±0.05 16.0±0.3/ 4.5±0.1 Copyright © 2010, Everlight All Rights Reserved. Release Date : May 13, 2013. Issue No:DPC-0000148 Rev.2 www.everlight.com DATASHEET 8 PIN DIP DUAL CHANNEL HIGH SPEED 1Mbit/s TRANSISTOR PHOTOCOUPLER EL253X series Precautions for Use 1. Soldering Condition 1.1 (A) Maximum Body Case Temperature Profile for evaluation of Reflow Profile Note: Reference: IPC/JEDEC J-STD-020D Preheat Temperature min (Tsmin) 150 °C Temperature max (Tsmax) 200°C Time (Tsmin to Tsmax) (ts) Average ramp-up rate (Tsmax to Tp) 60-120 seconds 3 °C/second max Other Liquidus Temperature (TL) 217 °C Time above Liquidus Temperature (t L) 60-100 sec Peak Temperature (TP) 260°C Time within 5 °C of Actual Peak Temperature: T P - 5°C 30 s Ramp- Down Rate from Peak Temperature 6°C /second max. Time 25°C to peak temperature Reflow times 8 minutes max. 3 times 12 Copyright © 2010, Everlight All Rights Reserved. Release Date : May 13, 2013. Issue No:DPC-0000148 Rev.2 www.everlight.com DATASHEET 8 PIN DIP DUAL CHANNEL HIGH SPEED 1Mbit/s TRANSISTOR PHOTOCOUPLER EL253X series DISCLAIMER 1. Above specification may be changed without notice. EVERLIGHT will reserve authority on material change for above specification. 2. When using this product, please observe the absolute maximum ratings and the instructions for using outlined in these specification sheets. EVERLIGHT assumes no responsibility for any damage resulting from use of the product which does not comply with the absolute maximum ratings and the instructions included in these specification sheets. 3. These specification sheets include materials protected under copyright of EVERLIGHT corporation. Please don’t reproduce or cause anyone to reproduce them without EVERLIGHT’s consent. 13 Copyright © 2010, Everlight All Rights Reserved. Release Date : May 13, 2013. Issue No:DPC-0000148 Rev.2 www.everlight.com