Magnetorque II Datasheet

Non-contacting Sensors
Model SX-4428
· Magnetorque II non-contacting
steering torque sensor
· Magnetorque II is ideally suited for demanding
Electric Power Steering Systems.
Electrical
Linearity
±3%
Hysteresis
±1.3%
Microgradient
±30% of theoretical slope over 0.4° interval
Sensed Angle
±5°
Supply Current
8 to 16 mA
Clamp Low
8 to 12%
Clamp High
88 to 92%
Sensitivity
0.388 to 0.412 V/°
Mechanical
Mechanical Travel, Input Rotor
Continuous
Mechanical Travel, Output Rotor
Continuous
Turning Torque (rotor to rotor)
0 NM (non-contacting)
Turning Torque (input rotor to housing)
0 NM (non-contacting)
Turning Torque (output rotor to housing)
0.05 NM maximum
Weight
105 grams maximum
Environmental
Operating Temperature Range
-40°C to +85°C
Vibration
10 to 55 Hz with 1 mm P-P constant displacement, 120 hours each of 3 planes
Input Rotor Rotational Life
Infinite (floating)
Output Rotor Rotational Life
10 million cycles
Storage Temperature Range
-55°C to +125°C
Design can be programmed to meet other angles and amplitudes
General Note
TT electronics reserves the right to make changes in product specification without notice or liability.
All information is subject to TT electronics’ own data and is considered accurate at time of going to print.
www.bitechnologies.com
© TT electronics plc
12.12
Non-contacting Sensors
Model SX-4428
Output Chart
Typical Torque Outputs
100%
90%
80%
70%
O utputs ( % of V t)
60%
50%
T1
T2
40%
30%
20%
10%
CW direction ->
0%
-6
-4
-2
0
Relative angle (degrees)
2
4
6
Pinouts & Recommended Interface
PIN No. SIGNAL
1
VCC
3
N/A
2
4
5
WIRE COLOR
RED
GND
BLACK
T1
BLUE
N/A
T2
6
PURPLE
N/A
N/A
1
3
2
4
5
6
YASAKI MATING CONNECTOR #7123-8365
CONNECTOR FRONT VIEW
General Note
TT electronics reserves the right to make changes in product specification without notice or liability.
All information is subject to TT electronics’ own data and is considered accurate at time of going to print.
www.bitechnologies.com
© TT electronics plc
12.12
Non-contacting Sensors
Model SX-4428
Outline Drawing
Tolerances ±1 mm unless otherwise specified.
General Note
TT electronics reserves the right to make changes in product specification without notice or liability.
All information is subject to TT electronics’ own data and is considered accurate at time of going to print.
www.bitechnologies.com
© TT electronics plc
12.12