Crane Aerospace & Electronics Microwave Solutions 7200 & 8200 SERIES – DIELECTRIC RESONATOR OSCILLATORS TECHNICAL FEATURE FEATURES High stability, fundamental oscillator Electronic tuning (option) Excellent phase noise characteristics 7200 Series for harsh, military environments Low spurious under vibration 8200 series for low cost industrial applications Mechanical tuning Compact size Frequency Range (GHz) 3 to 4 4 to 5 5 to 7 Mechanical Tuning RF Output Power (dBm) +10 (min) t0 13 (typ) 9 to 15 15 to 20 +10 (min) to 13 (typ) Frequency Accuracty Frequency Stability 7 to 9 20 to 26 0.5% (typ) +10 (min) ±1 MHz (typ) (3) 550 ppm (max) Harmonic Levels -20 dBc (max) Spurious Levels -70 dBc (max) Phase Noise Offset Freq. @3.5 @4.5 @6.0 @8.0 @12.0 @17.0 @22.0 (SSB) dBc/Hz 10 kHz -92 -91 -90 -90 -87 -84 -70 (typ) 100 Khz -122 -121 -120 -115 -112 -109 -95 1 MHz <-140 <-140 <-140 <-130 <-130 <-130 -115 Load Pulling into 1.5:1 VSWR 0.02% (typ) Pushing 2 kHz/Volt (typ) Electronic Tuning (option) Tuning Range 0.2% (typ) Tuning Voltage +1 to +10 Vdc DC Current @ +15V 60 to 150 mA Operating Temperature Range Mechanical Dimensions (inches) 2.0 x 2.5 x 1.0 (1) (1) -20°C to +70°C (industrial grade) (8200 series) (2) -45°C to +85°C (military grade) (7200 series) 1.25 x 1.75 x 0.65 or 0.75 x 1.5 x 0.75 x 1.50 x 0.48 0.48 (1) Depends on frequency and RF output power level chosen. (2) Hermetically sealed (3) Stability is typically ±25 PPM for optional temperature compensated version Crane Aerospace & Electronics Microwave Solutions – Signal Technology 340 North Roosevelt Avenue, Chandler, AZ 85226 +1.480.961.6269 [email protected] www.craneae.com/mw 80 to 200 mA Page 1 of 2 0.70 x 1.06 x 0.35 Crane Aerospace & Electronics Microwave Solutions 7200 & 8200 SERIES – DIELECTRIC RESONATOR OSCILLATORS Low Noise, Dielectric Resonator Oscillator (DRO) or Coaxial Resonator Oscillator (CRO) Analog phase-locked loop using a high performance sampling phase detector Internal voltage regulator High stability, low noise crystal reference oscillator Military designs for Hi-Rel, harsh environment applications Frequency Coverage .75 GHz to 18.0 GHz Power Output +10 dBm nominal Harmonics -30 dBc, maximum Spurious -80 dBc, maximum Frequency Stability Same as external reference Phase Noise Reference noise plus 20 log (N) +3 dB (Note 1) Lock Alarm TTL DC Power +15 Volts @ 350 mA (max) Temperature Range -40° C to +85°C RF Connectors DC Connectors Dimensions SMA female Feedthru 7505 Series: 3.0” x 4.0” x 1.0” 7515 Series: 2.5” x 3.0” x 1.0” EXTERNAL REFERENCE INPUT Frequency Range 100 MHz nominal (Note 2) Power Input 0 dBm nominal Input Impedance 50 ohms NOTES: 1. Where “(N)” equals output frequency divided by input frequency. Formula valid except ± decade of LBW it is typically 20 Log N + 6 dB to 10 dB. 2. Depending on final multiplication required, reference frequency may vary from 5 MHz to 300 MHz. 3. Improved performance available – consult your factory representative. The information in this document is a derivative of a document cleared by the Department of Defense (DoD) Office of Security Review (OSR) for public release. OSR case number 10-S-0983 dated March 11, 2010. DS_7200_8200_Dielectric Resonator Oscillators_MW_2010.doc. This revision supersedes all previous releases. All technical information is believed to be accurate, but no responsibility is assumed for errors. We reserve the right to make changes in products or specifications without notice. Copyright © 2010 Crane Electronics, Inc. All rights reserved. Page 2 of 2