RF Filter 100 KHz to 5.8 GHz SMD package

RF Filter 100 KHz to 5.8 GHz SMT package
Wide Band
RF Eliminate Filter
KHLC-04d
Isolation vs Frequency
Feature
⋅ SMT Package in Thin Thickness
⋅ Broad Bandwidth: 100 kHz to 5.8 GHz (-20 dB)
⋅ Comply with Large Current (1.5 A)
0
-10
Getting along with high speed orientation of commercial
electronic apparatus, high harmonic wave (noise) delivered to the
DC power supply extends the frequency from several GHz to
several GHz times by ten. Under such a high frequency
orientation at rapid constant progress, the circuit method like using
a bypass capacitor cannot remove actually high harmonic wave
which is transmitted to the power supplies.
In order to perform high speed transmission of a digital signal,
the power filter KHLC-04d should be put in series to the bias
(power supply terminal) of the electric device (ICs and etc) and
needs to cut high harmonic wave signal which is leaked in the
power supply line. KHLC-04d has an usable frequency range of
100 kHz to 5.8 GHz (-20 dB), which has RF preventive band
characteristics in the wide range and is very ideal for mounting
position electrically as this power filter in SMT package can be
mounted near the power supply terminals of ICs and etc.
-20
-30
-40
-50
-60
-70
1M
Absolute Maximum Rating
Parameter
Electrical Specifications
Value (max.)
Unit
1,500
mA
Rated Current
Rated Voltage
10G
Frequency [ Hz ]
25
V
Soldering Temperature
+265 (10 sec)
C
Operating Temperature
−40 ~ +85
C
Storage Temperature
−65 ~ +150
C
Parameter
Band Width
Dimensions
4.0
400 kHz ~ 3.0 GHz (Typ.)
−30 dB
0.13 Ω max.
−
UNIT : mm
4.5
0.05
1
C1
Cp2
2
2.2
3
Cp3
0.7
5.0
0.30
3
4
4.3
KF2
5.5 ±0.1
Lo
1
Cp1
−20 dB
4
6
KF1
Condition
DC Resistance
Schematics
6
Value
100 kHz ~ 5.8 GHz (Typ.)
0.15
1.27
1.8 ± 0.05
1.27
2
0.40
1: Vcc (IN)
2: GND
3: Vcc (OUT)
4: NONE
6: NONE
The content of this specification may change without notification 09/18/08
American Accurate Components, Inc.
188 Technology Drive, Unit H, Irvine, CA 92618
TEL: 949-453-9888 FAX: 949-453-8889
0.6
Please do not wire
in this area.