SMR Series PRODUCT SELECTION Control Voltage 8-32 VDC 25A 50A 90A SMR2425 SMR2450 SMR2490 60-280 600 10 500 25 40 250 1.6 1.02 260 60-280 600 10 500 50 40 625 1.6 0.63 1620 60-280 600 10 500 90 40 1200 1.6 0.28 6000 0.5 0.5 0.5 bs AVAILABLE OPTIONS ol et e • System monitoring solid-state relay • Ratings from 25A to 90A @ 60-280 V AC • DC control • LED status indicators • Alarm output signal • Inverting or non-inverting input • Normally open or normally closed alarm output O OUTPUT SPECIFICATIONS (1) Description Operating Voltage (47-63Hz) [Vrms] Transient Overvoltage [Vpk] Maximum Off-State Leakage Current @ Rated Voltage [mArms] Minimum Off-State dv/dt @ Maximum Rated Voltage [V/µsec] (2) Maximum Load Current (3) [Arms] Minimum Load Current [mArms] Maximum Surge Current (16.6ms) [Apk] Maximum On-State Voltage Drop @ Rated Current [Vpk] Thermal Resistance Junction to Case (Rjc) [°C/W] Maximum I2 t for Fusing (8.3 msec) [A2 sec] Minimum Power Factor (with Maximum Load) INPUT SPECIFICATIONS (1) DC Control Control Voltage Range Minimum Turn-Off Voltage (pin 6) DC Suply Current @ 12 VDC DC Control Current @ 12 VDC Maximum Alarm Output Current Alarm On Output Voltage (Open), (pin 7) Maximum Alarm Off Output Voltage @ 100 mA (Active Low),(pin 7) AlarmDelay (Min.-Max.) Maximum Turn-On Time [msec] Maximum Turn-Off Time [msec] 8-32 VDC 0.4 VDC 8 mA 6 mA 100 mA Supply Voltage 1.5 VDC 30-100 msec 1/2 Cycle 1/2 Cycle ol et e Description GENERAL SPECIFICATIONS Description Dielectric Strength, Input/Output/Base (50/60Hz) Minimum Insulation Resistance (@ 500 V DC) Maximum Capacitance, Input/Output Ambient Operating Temperature Range Ambient Storage Temperature Range Weight (typical) Encapsulation Output Terminals: Input Connector (locking): Mating Connector (supplied): Recommended Terminal Screw Torque Range: GENERAL NOTES 1) All parameters at 25°C unless otherwise specified. 2) Off-State dv/dt test method per EIA/NARM standard RS-443, paragraph 13.11.1 3) Heat sink ing required, see derating curves. O bs MECHANICAL SPECIFICATIONS Parameters 4000 Vrms 109 Ohm 8 pF -40 to 80°C -40 to 125 °C 3.0 oz (86.5g) Thermally conductive Epoxy Screws and Saddle Clamps Furnished, Unmounted Panduit No. MLSS100-5 or Equivalent Panduit No. CT00F22-5 or Equivalent 8-32 & 10-32 Screws - 20 in. lbs. (Screws dry without grease) ol et e WIRING DIAGRAM bs THERMAL DERATE INFORMATION O STATUS CHART AGENCY APPROVALS UL E116949 CSA LR81689 VDE 10143 UG Rev. 112210 bs O ol et e O bs ol et e ANNEX - ENVIROMENTAL INFORMATION