Series CX - MS11
5 Amp • 240, 480 Vac • AC Output
Crydom's family of SPST-NO relays
achieves the highest power switching
capability in a DIN mounted air-cooled
package. Advanced features include
exceptional steady state current, plus
ultra-high surge ratings. Models are
available to switch up to 530 Vrms with
AC or DC control, and either zero-cross
or random turn-on ("R") switching versions.
• DIN Rail Mount (TS-35)
• SCR Output Rating
• Ultra High Surge
• Crydom’s Patented Design
• Input Status LED (DC Control only)
MODEL NUMBERS
AC CONTROL (120Vac)
(24Vac)
CX240A5 - MS11
CXE240A5 - MS11
(5Vdc)
(24Vdc)
CX240D5 - MS11
CXE240D5 - MS11
DC CONTROL
CX380D5 - MS11
CXE380D5 - MS11
OUTPUT SPECIFICATIONS (1)
12-280
48-530
Load Current Range [Arms]
.06-5
.06-5
Transient Overvoltage [Vpk]
600
1200
Max. Surge Current, (16.6ms) [Apk]
250
250
Max. On-State Voltage Drop @ Rated Current [Vpk]
1.4
1.4
Maximum I 2 t for Fusing, (8.3 msec.) [A 2sec]
260
260
Max. Off-State Leakage Current @ Rated Voltage [mArms]
0.1
0.1
Min. Off-State dv/dt @ Max. Rated Voltage [V/µsec] (2)
500
500
Operating Voltage (47-63 Hz) [Vrms]
Max. Turn-On Time (3)
1/2 Cycle (DC Control), 10.0 msec (AC Control)
Max. Turn-Off Time
1/2 Cycle (DC Control), 40.0 msec (AC Control)
0.5
Power Factor (Min.) with Max. Load
INPUT SPECIFICATIONS (1)
DC CON T R OL
Nominal Voltage
MODEL NUMBERS
5Vdc
24Vdc
CX240D5 - MS11 CXE240D5 - MS11
CX380D5 - MS11 CXE380D5 - MS11
0.5
AC CON T R OL (4)
120Vac
24Vac
CX240A5 - MS11 CXE240A5 - MS11
Control Voltage Range
3-15 Vdc
15-32 Vdc
90-140 Vrms
18-36 Vrms
Max. Turn-On Voltage
3.0 Vdc
15.0 Vdc
90.0 Vrms
18.0 Vrms
Min. Turn-Off Voltage
1.0 Vdc
1.0 Vdc
10.0 Vrms
2.0 Vrms
Nominal Input Impedance
300 Ohm
1.0k Ohm
14.1k Ohm
4.2k Ohm
Typical Input Current @ Nominal Voltage
15 mAdc
8 mAdc
10 mArms
5 mArms
©2008 CRYDOM Inc, Specifications subject to change without notice.
(1) All parameters at 25ºC unless otherwise specified.
(2) Off-State dv/dt test method per EIA/NARM standard RS-443, paragraph 13.11.1
GENERAL NOTES
(3) Turn-On Time for Random Turn-On versions 0.1msec (DC Control Models).
(4) No input status LED on AC control modules.
SERIES CX-MS11.
Rev. 180608
PAGE 1 OF 4
For recommended applications and more information contact:
USA: Sales Support (877) 502-5500 Tech Support (877) 702-7700 FAX (619) 710-8540
Crydom Inc, 2320 Paseo de las Americas, Ste. 201, San Diego, CA 92154
Email: [email protected] WEB SITE: http://www.crydom.com
UK: +44 (0)1202 606030 • FAX +44 (0)1202 606035 Crydom SSR Ltd., Arena Business Centre,
Holyrood Close, Poole, Dorset BH17 7FJ, Email: [email protected], [email protected]
GERMANY: +49 (0)180 3000 506
Series CX - MS11
5Amp • 240, 480Vac • AC Output
GENERAL SPECIFICATIONS
Dielectric Strength 50/60Hz Input/Output/Base
2500 Vrms
109 Ohm
Insulation Resistance (Min.) @ 500 Vdc
Max. Capacitance Input/Output
10 pF
Ambient Operating Temperature Range
-30 to 80 ºC
Ambient Storage Temperature Range
-30 to 80 º C
M ECHANICAL SPECIFICATIONS
Weight: (typical)
Encapsulation (SSR):
30 grms
Thermally Conductive Epoxy
CURRENT DERATING CURVE
CRYDOM
Solid State Relay
5.0
-A2 +A1
CX Series
4.0
Input
3.0
Output
54.0
2.0
29.0
LOAD CURRENT [AMPS]
6.0
1.0
0
20
40
60
80
DIN Rail TS35
AMBIENT TEMPERATURE [°C]
85.0
Max. Load Current vs. Temp.
All dimensions are in millimeters (not to scale)
Colour of carrier and termination housing - orange
Input status LED is on DC control module only
©2008 CRYDOM Inc, Specifications subject to change without notice.
AVAILABLE OPTIONS
R
Random Turn-On Switching
Example: CX240D5R-MS11, CX240A5R-MS11
-MOV
With MOV over voltage protection accross output
terminals.
Example: CX240D5-MS11-MOV
APPROVALS - SSR ONLY
UL
E116949
CSA LR81689
VDE 70938 (240V, DC Control Only)
SERIES CX-MS11
Rev. 180608
PAGE 2 OF 4
For recommended applications and more information contact:
USA: Sales Support (877) 502-5500 Tech Support (877) 702-7700 FAX (619) 710-8540
Crydom Inc, 2320 Paseo de las Americas, Ste. 201, San Diego, CA 92154
Email: [email protected] WEB SITE: http://www.crydom.com
UK: +44 (0)1202 606030 • FAX +44 (0)1202 606035 Crydom SSR Ltd., Arena Business Centre,
Holyrood Close, Poole, Dorset BH17 7FJ, Email: [email protected], [email protected]
GERMANY: +49 (0)180 3000 506
12.5
DANGER / PELIGRO / DANGER /GEFAHR / PERICOLO / PERIGO
HAZARD OF
ELECTRIC
SHOCK,
EXPLOSION,
OR ARC FLASH.
• Disconnect all
power before
installing or
working with
this equipment.
• Verify all
connections
and replace all
covers before
turning on
power.
Failure to follow
these
instructions will
result in death
or serious injury.
RIESGO DE
DESCARGA
ELECTRICA O
EXPLOSION.
• Desconectar
todos los
suministros de
energia a este
equipo antes
de trabajar
con este equipo.
• Verificar todas
las conexiones
y colocar todas
las tapas antes
de energizer
el equipo.
El
incumplimiento
de estas
instrucciones
puede provocar
la muerte o
lesiones serias.
RISQUE DE
DESCHARGE
ELECTRIQUE
OU EXPLOSION
• Eteindre
toutes les
sources
d'énergie de
cet appareil
avant de
travailler
dessus de cet
appareil
• Vérifier tous
connections, et
remettre tous
couverts en
olace avant de
mettre sous
De non-suivi de
ces instructions
provoquera la
mort ou des
lésions sérieuses
sérieuses.
GEFAHR EINES
ELEKTRISCHE
N SCHLAGES
ODER EINER
EXPLOSION.
• Stellen Sie
jeglichen
Strom ab, der
dieses Gerät
versorgt, bevor
Sie an dem
Gerät Arbeiten
durchführen
• Vor dem
Drehen auf
Energie alle
Anschlüsse
überprüfen
und alle
Abdeckungen
ersetzen.
RISCHIO DI
SCOSSA
ELETTRICA O
DELL’ESPLOSI
ONE.
• Spenga tutta
l'alimentazion
e che fornisce
questa
apparecchiatu
ra prima del
lavorare a questa
apparecchiatu ra
• Verificare tutti
i collegamenti
e sostituire
tutte le coperture
prima della
rotazione
sull'alimentazi one
Unterlassung
dieser
Anweisungen
können zum
Tode oder zu
schweren
Verletzungen
führen.
L'omissione di
seguire queste
istruz ioni
provocherà la
morte o di
lesioni serie
RISCO DE
DESCARGA
ELÉTTRICA OU
EXPLOSÃO
• Desconectar
o equipamento
de toda á
energia antes
de instalar ou
trabalhar com
este equipamen
to
• Verificar todas
as conexões e
recolocar todas
as tampas
antes de religar
o equipamento
O não cumprimento
destas instruções
pode levar á morte
ou lesões sérias.
WARNING / AVERTISSEMENT / WARNUNG /ADVERTENCIA / AVVERTENZA / AVISO
RISK OF MATERIAL DAMAGE AND HOT
ENCLOSURE
RISQUE DE DOMMAGE MATERIEL ET DE
SURCHAUFFE DU BOITIER
GEFAHR VON MATERIALSCHÄDEN UND
GEHÄUSEERHITZUNG
• The product's side panels may be hot, allow
time for product to cool before touching.
• Follow proper mounting instructions including
torque values.
• Do not allow liquids or foreign objects to enter
this product.
• Les panneaux latéraux du produit peuvent être
chauds. Laisser le produit refroidir avant de le
toucher.
• Respecter les consignes de montage, et
notamment les couples de serrage.
• Ne pas laisser pénétrer de liquide ni de corps
étrangers à l'intérieur du produit.
• Die Seitenwände können heiß sein. Lassen Sie
das Produkt abkühlen, bevor Sie es berühren.
• Beachten Sie die Montageanweisungen,
• Führen Sie keine Flüssigkeiten oder
Fremdkörper in das Produkt ein.
Failure to follow this instruction can result in
serious injury, or equipment damage.
Le non-respect de cette directive peut entraîner,
des lésions corporelles graves ou des
dommages matériels.
Die Nichtbeachtung dieser Anweisung kann
Körperverletzung oder Materialschäden
zur Folge haben.
RIESGO DE DAÑOS MATERIALES Y DE
SOBRECALENTAMIENTO DE LA UNIDAD
RISCHIO DI DANNI MATERIALI E D'INVOLUCRO
CALDO
RISCO DE DANO MATERIAL E DE AQUECIMENTO
• Los paneles laterales del producto pueden
estar calientes. Esperar que el producto se
enfríe antes de tocarlo.
• Respetar las instrucciones de montaje, y en
particular los pares de apretado.
• No dejar que penetren líquidos o cuerpos
extraños en el producto.
• I pannelli laterali dell'apparecchio possono
scottare; lasciar quindi raffreddare il prodotto
prima di toccarlo.
• Seguire le istruzioni di montaggio corrette.
• Non far entrare liquidi o oggetti estranei in questo
apparecchio.
Si no se respetan estas precauciones pueden
producirse graves lesiones, daños materiales.
La mancata osservanza di questa precauzione può
causare gravi rischi per l'incolumità personale o
danni alle apparecchiature.
SERIES CX-B.
Rev. 102607
PAGE 2 OF 2
• Os painéis laterais do produto podem estar
quentes; dê tempo ao produto para arrefecer
antes de lhe tocar.
• Siga devidamente as instruções de montagem.
• Não permita a entrada de líquidos e de objectos
estranhos no produto.
A não observância destas precauções pode
provocar a morte, ferimentos graves ou
danos materiais.
ANNEX – ENVIRONMENTAL INFORMATION:
The environmental information disclosed in this annex including the EIP
Pollution logo are in compliance with People’s Republic of China Electronic
Industry Standard SJ/T11364 – 2006, Marking for Control of Pollution
Caused by Electronic Information Products.
Part
Toxic or hazardous Substance and Elements
Name
Lead Mercury Cadmium Hexavalent Polybrominated Polybrominated
(Pb) (Hg)
(Cd)
Chromium
biphenyls
diphenyl ethers
(Cr (VI))
(PBB)
(PBDE)
Semiconductor
X
O
O
O
O
O
die
Solder
X
O
O
O
O
O
䰘ӊ - ⦃ֱֵᙃ:
䚼ӊ
ৡ⿄
ञᇐԧ㢃⠛
⛞⚍
ℸ䰘ӊ᠔ᷛ⼎ⱘࣙᣀ⬉ᄤֵᙃѻક∵ᶧᷛⱘ⦃ֱֵᙃ
ヺড়ЁढҎ⇥݅⬉ᄤ㸠Ϯᷛ ޚSJ/T11364 - 2006, ⬉ᄤֵᙃѻક∵ᶧࠊᷛ䆚㽕∖
᳝↦᳝ᆇ⠽䋼ܗ㋴
䪙
∲
䬝
݁Ӌ䫀
⒈㘨㣃
⒈Ѡ㣃䝮
(Pb) (Hg) (Cd) (Cr (VI))
(PBB)
(PBDE)
X
O
O
O
X
O
O
O
O
O
O
O
© 2007 CRYDOM Inc., Specifications subject to change without notice.