FACT SHEET | EM4095 Subject to change without notice Version 1.0, 7-Oct-14 Copyright © 2014, EM Microelectronic-Marin SA www.emmicroelectronic.com Read/Write analog front end for 125 kHz RFID Basestation General Description Features The EM4095 (previously named P4095) chip is a CMOS integrated transceiver circuit intended for use in an RFID basestation to perform the following functions: Iantenna driving with carrier frequency IAM modulation of the field for writable transponder IAM demodulation of the antenna signal modulation induced by the transponder I Integrated PLL system to achieve self adaptive carrier frequency to antenna resonant frequency I No external quartz required I 100 to 150 kHz carrier frequency range I Direct antenna driving using bridge drivers communicate with a microprocessor via simple interface. I Data transmission by OOK (100% Amplitude Modulation) using bridge driver Applications I Data transmission by Amplitude Modulation with externally adjustable modulation index using single ended driver I Car immobiliser I Multiple transponder protocol compatibility (Ex: EM4102, EM4200, EM4450 and EM4205/ EM4305) I Hand held reader I Low cost reader I Sleep mode 1µA Typical Operating Configuration I USB compatible power supply range Read Only Mode I -40 to +85°C temperature range RDY/CLK +5V 16 2 15 3 14 4 13 LA CRES +5V CDV1 I Small outline plastic package SO16 1 EM4095 5 12 6 11 7 10 8 9 CDC2 CFCAP Pin Assignment SHD DEMOD_OUT MOD µP SO16 CAGND VSS DC2 CDEC CDV2 RDY/CLK Read/Write Mode FCAP ANT1 SHD DVDD DEMOD_OUT RDY/CLK 16 CDC2 2 15 CFCAP 3 14 1 +5V 4 LA 5 CRES CDV1 +5V EM4095 13 12 6 11 7 10 8 9 SHD DEMOD_OUT MOD CAGND CDEC CDV2 µP DVSS MOD ANT2 AGND VDD DEMOD_IN CDEC_IN CDEC_OUT