CS33xx Model 5×7 mm SMD, 3.3V, HCMOS Frequency Range: 1.544 MHz to 156.250 MHz Frequency Stability: ±20ppm to ±100ppm Temperature Range: 0°C to 70°C (Option M) -20°C to 70°C (Option E) -40°C to 85°C Storage: -45°C to 90°C Input Voltage: 3.3V ± 0.3V Input Current: 1.544~34.00 MHz 18mA Max 35.00~50.00 MHz 25mA Max 51.00~69.00 MHz 30mA Max 70.00~156.25 MHz 45mA Max Standby Current 3uA Typ., 10uA Max Output: HCMOS Symmetry: 45/55% Max @ 50% Vdd Rise/Fall Time (into 15pF Load): 1.54~10.00 MHz 5ns Max @ 20% to 80% 10.10~30.00 MHz 4ns Max @ 20% to 80% 30.10~50.00 MHz 3ns Max @ 20% to 80% 50.10~80.00 MHz 2.5ns Max @ 20% to 80% 80.10~156.25 MHz 2ns Max @ 20% to 80% Logic: "0" = 10% Vdd Max "1" = 90% Vdd Min Start-up Time: 10ms Max Load: 30pF Max, >125MHz 15pF Max Jitter RMS: 12kHz~80MHz 0.5ps Typ, 1ps Max Aging: <3ppm 1st/yr, <1ppm every year thereafter SUGGESTED PAD LAYOUT Dimensions inches (mm) All dimensions are Max unless otherwise specified. 0.283 (7.20) P/N XXXX Frequency XX 0.055 Typ. (1.40 Typ.) 0.071 (1.80) 0.204 (5.02) The CS33xx Series utilizes fundamental and 3rd overtone crystal technology to provide a low jitter output frequency. The oscillator is equipped with power saving standby feature for battery and other low drain applications. Available on 16mm tape and reel in quantities of 1K. 0.071 SQ (1.80) #1 #2 #4 #3 0.045 ±0.008 (1.14 ±0.20) 0.165 (4.19) 0.200 (5.08) 0.01uF Bypass Capacitor Recommended 0.200 ±0.005 (5.08 ±0.13) Denotes pad 1 XXXX=Date Code XX=Lot Code RECOMMENDED REFLOW SOLDERING PROFILE TEMPERATURE Ramp-Up 3°C/Sec Max. Critical Temperature Zone Ramp-Down 6°C/Sec. 260°C Crystek Part Number Guide Example: CS3392-44.736MHZ Example: CSM3392-44.736MHZ Example: CSE3392-44.736MHZ 217°C 200°C 150°C Temperature Preheat 180 Secs. Max. 8 Minutes Max. 90 Secs. Max. 260°C for 10 Secs. Max. Frequency Stability 0/70°C -20/70°C -40/85°C CS3390 CS3392 CS3391 CS3398 CSM3390 CSM3392 CSM3391 N/A CSE3390 CSE3392 CSE3391 N/A +/- 100ppm +/- 50ppm +/- 25ppm +/- 20ppm NOTE: Reflow Profile with 240°C peak also acceptable. Standby Function TEST CIRCUIT mA M pin 4 OUT pin 3 Vdd PWR Supply VM Bypass Cap. OSC. E/D pin 1 High Impedance GND or "LOW" O/P Load incl Probe Cl OUT GND pin 2 Oscillation OPEN or "HIGH" CRYSTEK CORPORATION Function pin 1 Oscillator State Open "1" level 0.7×Vdd Min "0" level 0.3×Vdd Max Oscillator Active Oscillator Active Oscillator Stopped Specifications subject to change without notice. TD-052703 Rev.H 12730 Commonwealth Drive • Fort Myers, Florida 33913 Phone: 239-561-3311 • 800-237-3061 Fax: 239-561-1025 • www.crystek.com