BeRex BG17C 5-4000 MHz Cascadeable InGaP HBT Gain Block Device Features • 31 dBm Output IP3 at 2dBm/tone • 17 dB Gain • 17 dBm P1dB • Highly Reliable InGaP/GaAs HBT Technology • SOT-89 Surface Mount Package • 50 ohm Cascadeable Target Device Performance (Ta = 25°C) Symbols Parameters Test Conditions S11 S22 OIP3 P1dB Ic Vc dG/dT Rth BeRex Input Min 500 MHz 900 MHz 1900 MHz 2450 MHz 500 MHz 900 MHz 1900 MHz 2450 MHz 500 MHz 900 MHz 1900 MHz 2450 MHz 500 MHz 900 MHz 1900 MHz 2450 MHz 500 MHz 900 MHz 1900 MHz 2450 MHz Vc = 5.0V Ground Typ 5 17.0 16.8 15.0 14.5 Frequency Range Gain Ground 18.0 17.8 16.0 15.5 -15.0 -14.0 -24.0 -14.0 -14.0 -22.0 -12.0 -10.0 31.0 31.0 30.0 29.0 17.1 17.5 17.0 16.1 55 5.0 -0.004 50 16.1 16.5 16.0 15.1 45 Thermal Resistance Output Max Unit 4000 MHz dB dB dB dBm dBm 65 mA V dB/°C °C/W Test conditions unless otherwise noted. 1. T = 25°C, Icq = 55 mA, 50 ohm system. 2. OIP3 measured with two tones at an output power of 2 dBm/tone separated by 1 MHz. Absolute Maximum Ratings Parameter Rating Operating Case temperature Storage Temperature Junction Temperature Operating Voltage Supply Current Input RF Power -40 to +85°C -40 to +155°C +220°C 6.5V 150 mA 6dB above input P1dB Operation of this device above any of these parameters may result in permanent damage. Rev B60803 MMIC Innovator http: //www.berex.com BeRex BG17C 100 +25C -30C +85C Icc [m A 80 BeRex 60 Evaluation Board 40 RF Input RF Output 20 MMIC Innovator 0 0 1 2 3 4 5 6 31mil thick, FR4 Vcc [V] Application Circuit: 5 - 4000 MHz Typical Performance (Vc = 5V, Ic = 55mA, Ta = 25°C) Freq MHz 500 900 1900 S21 dB 18.0 17.8 16.4 S11 dB -15 -14 -24 S22 dB -14 -22 -12 P1 dBm 17.1 17.5 17.0 OIP3 dBm 31.0 31.0 30.0 NF dB 3.8 3.9 4.0 2140 16.2 -16 -11 17.0 30.0 4.0 Schematic Diagram C3 C4 BOM C5 +5V L1 RFin C2 C1 2450 15.6 -14 -10 16.1 29.0 4.0 RFout BG17C 3000 15 -11 -9 15.2 28.0 4.2 Tolerance C1 100pF ±0.25pF C2 100pF ±0.25pF C3 100pF ±0.25pF C4 1000pF ±0.25pF C5 10uF ±20% *L1 33nH 5% *Note: Less than 20nH improves RF performance at frequencies over 1.9GHz. 40nH or higher value L1 improves RF performance at frequencies under 500MHz. Optimum value of L1 may vary with board design. Rev B60803 MMIC Innovator http: //www.berex.com BeRex BG17C Device Performance Pin-Pout-Gain 35% 30% 20 25 30% 20 25% 10 15% 20% Po/G 20% PAE Po/G 25% 15 15 15% 10 10% 10% 5 5% 0 -15 0% -10 -5 0 5 5 5% 0 -15 Pin [dBm] 0% -10 -5 0 5 Pin [dBm] 900MHz, 5V/55mA Rev B60803 PAE 25 1900 MHz, 5V/55mA MMIC Innovator http: //www.berex.com BeRex BG17C OIP3 F1=900, F2=901MHz 35 35 33 33 OIP3 [dBm OIP3 [dBm F1=500, F2=501MHz 31 29 31 29 27 27 +25C -30C +25C +85C 4 6 8 10 4 12 6 8 10 12 F1=2140, F2=2141MHz F1=1900, F2=1901MHz 35 35 +25C -30C +25C +85C 33 -30C +85C 33 OIP3 [dBm OIP3 [dBm +85C Po,tot [dBm] Po,tot [dBm] 31 29 31 29 27 27 25 25 4 6 8 10 12 4 6 Po,tot [dBm] 8 10 12 Po,tot [dBm] F1=2450, F2=2451MHz OIP3 Po=2dBm/tone, ΔF=1MHz 35 32 +25C -30C +85C 33 OIP3 [dBm 30 OIP3 [dBm -30C 25 25 28 26 31 29 24 27 22 25 500 +25C 4 6 8 10 12 Po,tot [dBm] Rev B60803 1000 -30C 1500 +85C 2000 Freq [MHz] MMIC Innovator http: //www.berex.com 2500 BeRex BG17C ACPR F=500MHz, IS-95A, 9CH-FWD 885KHz Offset F=900MHz, IS-95A, 9CH-FWD 885KHz Offset 0 0 +25C -30C +85C +25C -10 -10 -30C +85C ACPR [dB ACPR [dB -20 -20 -30 -40 -50 -30 -40 -50 -60 -60 -70 -70 -80 4 6 8 12 10 4 6 8 Po [dBm] 12 10 Po [dBm] F=1900MHz, IS-95A, 9CH-FWD 885KHz Offset IS-95A, 9CH-FWD, 885KHz Offset Po satisfies -45dBc 0 10 +25C -30C +85C -10 Po [dBm ACPR [dB 8 -20 -30 -40 6 4 -50 2 -60 +25C -70 4 6 8 10 0 500 12 -30C 1000 Po [dBm] +85C 1500 Freq [MHz] Gain vs Temperature 20 S21 [dB 18 16 14 12 +25C -30C +85C 10 0 500 1000 1500 2000 2500 3000 3500 4000 Freq [MHz] Rev B60803 MMIC Innovator http: //www.berex.com 2000 BeRex BG17C S-Parameter (Vdevice = 5.0V, Icc = 55mA, T = 25 °C) Freq [MHz] 100 500 1000 1500 2000 2500 3000 3500 4000 S11 Mag S11 Ang 0.69 0.18 0.05 0.01 0.09 0.20 0.27 0.25 0.11 -38.43 -118.50 160.30 37.15 -127.10 -163.40 168.40 137.30 108.30 S21 Mag 4.94 7.99 7.76 7.31 6.49 6.07 5.57 5.33 5.18 S21 Ang -122.90 126.10 48.67 -22.00 -91.16 -156.00 142.10 76.86 10.32 S12 Mag 0.04 0.08 0.08 0.08 0.08 0.08 0.08 0.09 0.09 S12 Ang S22 Mag 86.86 -28.03 -90.43 -144.70 162.40 111.90 61.34 9.56 -45.02 0.77 0.18 0.08 0.16 0.25 0.31 0.35 0.31 0.16 S22 Ang 170.20 39.68 -78.90 -154.80 175.50 156.20 134.50 104.60 47.31 Tape & Reel SOT89 Packaging information: Tape Width (mm): 12 Reel Size (inches): 7 Device Cavity Pitch (mm): 8 Devices Per Reel: 1000 MSL / ESD Rating Rev B60803 ESD Rating: Value: Test: Standard: Class 2 Passes <4000V Human Body Model (HBM) JEDEC Standard JESD22-A114B MSL Rating: Standard: Level 1 at +265°C convection reflow JEDEC Standard J-STD-020 MMIC Innovator http: //www.berex.com