NTS Report on Qi-Certification - Active-Semi

Test Report / MJO No. PR026358
Revision Level: 0
Page 1 of 6
www.nts.com
Receiver Final Test Report of
Active-Semi International
Active-Semi PAC5220 WPC ALL
Base Station
Wireless Power Consortium Testing
(1.1.2)
Issue Date:
January 22, 2014
Prepared for:
Active Semi
Marc Sousa
Suite 330, One Allen Center
700 Central Expressway South
Allen, TX 75013
Email: [email protected]
Prepared by:
National Technical Systems
5730 Buckingham Parkway
Culver City, CA 90230
This report and the information contained herein represent the results of testing test articles identified and selected by the client performed to specifications and/or
procedures selected by the client. National Technical Systems (NTS) makes no representations, expressed or implied, that such testing is adequate (or inadequate) to
demonstrate efficiency, performance, reliability, or any other characteristic of the articles being tested, or similar products. This report should not be relied upon as an
endorsement or certification by NTS of the equipment tested, nor does it represent any statement whatsoever as to its merchantability or fitness of the test article, or
similar products, for a particular purpose. This report shall not be reproduced except in full.
Test Report / MJO No. PR026358
Revision Level: 0
TABLE OF CONTENTS
Project Results .............................................................................................................................. 3
OVERALL RESULT ..................................................................................................................... 3
FIELD OF TESTING: ENGINEERING ........................................................................................... 3
1.
PRODUCT UNDER TEST ................................................................................... 3
2.
EQUIPMENT AND SOFTWARE USED DURING TESTING ................................ 3
3.
TEST METHODOLOGY....................................................................................... 3
4.
COMMENTS AND OBSERVATIONS................................................................... 5
5.
DETAILED TEST RESULTS ................................................................................ 5
6.
CONCLUSION ..................................................................................................... 5
CONFIDENTIAL
Page 2 of 6
Test Report / MJO No. PR026358
Revision Level: 0
PROJECT RESULTS
OVERALL RESULT
PASS
FIELD OF TESTING: ENGINEERING
The results contained within this test report relate only to the product(s) tested. This test report
shall not be reproduced except in full, without the written approval of National Technical
Systems.
1. PRODUCT UNDER TEST
The following product was tested during this certification:
Date(s) Tested:
Vendor Name:
Vendor Street Address:
City, State, Zip
Country:
Phone Number:
Contact, Title:
Product Name:
Product Version(s):
Identifier:
Transmitter Coil Type:
Qi Compliance Test ID:
Interoperability ID:
Product Information
01/22/2014
Active Semi International
Suite 330 700 Central Expressway South
Allen, TX 75013
United States
(519) 597-4473
Marc Sousa
Active-Semi PAC5220 WPC A11
C16938
A11
PR026358
IDD01140234T
2. EQUIPMENT AND SOFTWARE USED DURING TESTING
The following bench equipment was used in the testing of the product:
1. CATS Q100 BST
2. Agilent Infiniium DSO91304A Digital Storage Oscilloscope
3. TEST METHODOLOGY
The Wireless Power process has been formulated and governed by the Wireless Power
Consortium. Testing as outlined in this document only covers the Wireless Power Consortium
specifications listed below:
CONFIDENTIAL
Page 3 of 6
Test Report / MJO No. PR026358
Revision Level: 0
1. SysDescrWPT-volI-part3-1.1.2
2. SysDescrWPT-volI-part2-1.1.2
TC
Spec
Test Cases
Test #
Results
5.1 Conformance to Power Transmitter designs
5.1
[1]
TC
Spec
N/A
Conformance to Power Transmitter
Test Cases
Test #
Results
1
Pass
Test #
Results
2
Pass
Pass
Pass
5.2 Conformance to communications interface Requirements
5.2.1
[1]
Load Modulation
TC
Spec
Test Cases
5.3 Conformance to System Control Requirements
5.3.1
5.3.2
[1]
Selection Phase
Ping Phase
5.3.2.1
[1]
Digital Ping: Pwer Signal Characteristics
5.3.2.2
[1]
Digital Ping: No Response
3
4
5.3.2.3
[1]
Digital Ping: Signal Strength
5
Pass
5.3.2.4
[1]
Digital Ping: Termination I
6
Pass
5.3.2.5
[1]
Digital Ping: Termination II
7
Pass
Pass
Pass
5.3.3
Identification & Configuration Phase
5.3.3.1
[1]
Identification & configuration: Packet Sequence
5.3.3.2
[1]
Identification & configuration: Packet Timing
8
9
5.3.3.2
[1]
Identification & configuration: Packet Timing
10
N/A
5.3.3.3
[1]
Identification
Error
11
Pass
5.3.3.4
[1]
Identification & configuration: Packet I
12
N/A
5.3.3.4
[1]
Identification & configuration: Packet II
13
Pass
5.3.3.4
[1]
Identification & configuration: Packet III
14
Pass
5.3.3.5
[1]
Identification & configuration: Power Transfer
Contract
15
N/A
5.3.4
&
configuration:
Communication
Power Transfer Phase
5.3.4.1
[1]
Power Transfer: Packet Sequence
16
Pass
5.3.4.2
[1]
Power Transfer: Packet Timing I
17
Pass
CONFIDENTIAL
Page 4 of 6
Test Report / MJO No. PR026358
Revision Level: 0
5.3.4.2
[1]
Power Transfer: Packet Timing II
18
Pass
5.3.4.3
[1]
Power Transfer: Packet Content
19
N/A
5.3.4.4
[1]
Power Transfer: Packet Control I
20
Pass
5.3.4.4
[1]
Power Transfer: Packet Control II
21
Pass
5.3.4.5
[1]
Power Transfer: Termination
22
Pass
TC
Spec
Test #
Results
Test Cases
5.4 Conformance to System Performance Requirements
5.4.1
[1]
Guaranteed Power
23
Pass
5.4.2
[1]
Thermal Performance
24
Pass
5.4.3
[1]
Foreign Object Detection
25
Pass
5.4.4
[1]
User Interface: Object Placed
26
Pass
5.4.5
[1]
User Interface: Transfer in Progress
27
Pass
5.4.6
[1]
User Interface: Transfer Complete
28
Pass
5.4.7
[1]
User Interface: Fault
29
Pass
5.4.8
[1]
User Interface: Multiple Devices
30
Pass
5.4.9
[1]
User Interface: Limited Power
31
Pass
4. COMMENTS AND OBSERVATIONS
N/A
5. DETAILED TEST RESULTS
Please see ReceiverDataSheet.xlsx for all the specific measurements, and for more details
please contact NTS for the oscilloscope image and log traces.
6. CONCLUSION
On the Wireless Power Consortium Level, testing was conducted according to the Wireless
Power Consortium documents. Through testing with qualified WPC tester, Clients product
has passed all relevant Wireless Power test cases and therefore has satisfied the full
Wireless Power Consortium Specification.
SIGNATURES
CONFIDENTIAL
Page 5 of 6
Test Report / MJO No. PR026358
Revision Level: 0
Prepared by:
Date:
01/22/2014
Phillip Preechakul, Test Engineer
Approved by:
Date:
01/22/2014
Mansour Salamat, Operations Manager
CONFIDENTIAL
Page 6 of 6