Tape & Reel

PK-00065
Rev. A
Page: 2/4
TITLE: AOS Packing SPEC for TO247
1 PURPOSE
This specification shall serve as the basic spec for packing and labeling of the assembled AOS parts at all
subcontractors.
2 SCOPE
TO247 in all subcontractors.
3 REFERENCE DOCUMENT
AOS Marking SPEC: MK-00001
4 DEFINITION
4.1 TO = Transistor Outline
5 GENERAL
5.1 It’s the responsibility of P/T engineer to update this document if necessary
5.2 It’s the responsibility of P/T engineer to implement the requirement defined in this document.
6 CONTENT
6.1 TO247 should be packed in tubes.
PKG
Packing Qty/Tube
Max. Q’ty/Outer Box
TO247
30
1200 (8 tubes into 5 inner boxes)
6.2 Full tube packing, no empty is allowed in the tube.
6.3 Tubes should be enwrapped with bubble.
6.4 For tube packing products, no label on tube, but label on the inner box. The position is top-right corner.
(Refer Appendix I)
6.5 Sealing the inner box with 2 transparent tapes. Paste “QA SEALED” labels in the middle of the inner box
after post pack inspection. (Refer Appendix II)
6.6 Outer label should stick to top-right corner. (Refer to Appendix III)
7 APPENDIX LIST
7.1 Appendix I: Inner Label Position
7.2 Appendix II: “QA SEALED” Position
7.3 Appendix III: Outer Label Position
DO NOT COPY WITHOUT ANY AUTHORIZATION OF ALPHA & OMEGA SEMICONDUCTOR, INC.
PK-00065
Rev. A
Page: 3/4
Appendix I
Inner Label Position
Inner Label
Open side
Appendix II
QA SEALED Position
DO NOT COPY WITHOUT ANY AUTHORIZATION OF ALPHA & OMEGA SEMICONDUCTOR, INC.
PK-00065
Rev. A
Page: 4/4
Appendix III
Outer Label Position
AOS Logo
Additional external label Position
Outer Label Position
Please pay attention to the type
orientation of additional external label!
DO NOT COPY WITHOUT ANY AUTHORIZATION OF ALPHA & OMEGA SEMICONDUCTOR, INC.