Errata: CS4297A Rev. H (Reference CS4297A_DS318PP6 Data Sheet dated March '06) 1. The CS4297A requires a minimum SYNC pulse width of 1.13 µs in the absence of BIT_CLK for a warm reset to occur. AC ’97 version 2.1 requires SYNC to be asserted for a minimum of only 1.0 µs. Note: This requirement refers to the behavior of SYNC during warm reset only. During normal operation, SYNC is asserted for the entire period of slot 0 (the tag phase), which is 16 cycles of BIT_CLK. 2. SDATA_IN does not meet the AC ’97 specification of driving a 47.5 pF capacitive load within the rise time constraints of 2 ns ≤ Trise ≤ 6 ns. However, even at maximum capacitive loading, the codec provides sufficient SDATA_IN data setup margin to prevent any functional issues. Workaround Solution - Minimize SDATA_IN trace length during board layout, and keep the total capacitive loading to 22 pF or less. 3. BPCFG (Pin 31) does not meet the JEDEC latch-up specification of ±100 mA at 70 °C. The negative injection failing point is 50 mA at 70 °C. Workaround Solution - None required. Under normal operation, the BPCFG pin is not connected to external circuitry. If PC_BEEP bypass is disabled, this pin is tied to analog ground. Contacting Cirrus Logic Support For all product questions and inquiries, contact a Cirrus Logic Sales Representative. To find the one nearest you, go to http://www.cirrus.com http://www.cirrus.com Copyright © Cirrus Logic, Inc. 2006 (All Rights Reserved) March '06 ER318C4