PM05S Series SIP3, Single Output, Switching Regulator 0.5A, Package FEATURES Efficiency up to 97%, Non-isolated SIP Package 11.5x7.5x10.2 mm Excellent Line/Loads Regulation Short Circuit Protection, Thermal Shutdown Low Ripple and Noise Operating Temperature range -40°C to +80°C Low Stand-by Current Wideinputrange (4.75V~32V) 3 Years Product Warranty The PM05S series provides high efficiency switching regulators The high efficiency of these step-down converters allow an operating temperature up to 80°C at full-load without heatsink. The regulators come in a package which fits in the standard TO-220 footprint of linear regulators. The high efficiency of up to 97% and low stand-by power consumption of these switching regulators offer a cost-efficient solution for different applications These high efficiency DC/DC converters are the latest offering from a world leader in power systems technology and manufacturing ― Delta Electronics, Inc.. Model List Model Input Output Number Voltage Voltage (Range) VDC PM05S015A PM05S018A PM05S025A 4.75 ~ 32 PM05S033A Output Current Max. capacitive Efficiency Load (typ.) (typ.) @Min. Vin @Max. Vin Max. Efficiency VDC mA μF % % 1.5 500 220 73 63 1.8 500 220 82 71 2.5 500 220 87 77 3.3 500 220 91 81 PM05S050A 6.5 ~ 32 5 500 220 94 86 PM05S065A 8 ~ 32 6.5 500 220 95 88 PM05S090A 11 ~ 32 9 500 220 96 92 PM05S120A 15 ~ 32 12 500 220 97 94 PM05S150A 18 ~ 32 15 500 220 97 95 Input Characteristics Parameter Conditions Input Surge Voltage (1 sec. max.) Min. Typ. Max. Unit -0.3 --- 34 VDC Capacitor Internal Filter Type Internal Power Dissipation --- --- 0.4 Short Circuit Input Power --- --- 1.5 W --- 5 7 mA Input Current DS_PM05S_11212014 @No Load W E-mail: [email protected] http:// www.deltaww.com/dcdc P1 Output Characteristics Parameter Conditions Min. ----------- Output Voltage Setting Accuracy Line Regulation Vin=Min. to Max. Load Regulation Io=10% to 100% 1.5V to 6.5V 9V to 15V 1.5V to 6.5V 9V to 15V Min.Load 1.5V to 6.5V 9V to 15V Ripple & Noise (20MHz) Transient Recovery Time Transient Response Deviation Typ. ±2.0 ±0.2 ±0.1 ±0.4 ±0.25 No minimum Load Requirement --20 --30 50% Load Step Change Temperature Coefficient Output Current Limit Max. ±3.0 ±0.4 ±0.2 ±0.6 ±0.4 Unit %Vnom. % % % % 30 40 mV P-P mV P-P μsec --- 100 --- --- ±2 --- % --- --- ±0.015 %/℃ --- --- 1 A Unit Continuous Short Circuit Protection General Characteristics Parameter Conditions I/O Isolation Voltage Min. Typ. Max. 280 330 380 KHz 2,000,000 --- --- Hours none Switching Frequency MTBF(calculated) MIL-HDBK-217F@25℃, Ground Benign Environmental Characteristics Parameter Conditions Min. Typ. Max. Unit Operating Ambient Temperature Range (See Power Derating Natural Convection -40 --- +90 ℃ --- --- +100 ℃ -55 --- +125 ℃ --- 160 --- ℃ Humidity (non condensing) --- --- 95 % rel. H Lead Temperature (1.5mm from case for 10Sec.) --- --- 260 ℃ Curve) Case Temperature Storage Temperature Thermal Shutdown Internal IC junction EMC Characteristics Parameter Conducted EMI Radiated Emissions Standards & Level Performance Compliance to EN55022 and FCC part 15 Class B (See Page 3) EN55022 Class B ESD EN61000-4-2 Class A Radiated immunity EN61000-4-3 Class A Fast transient (See Note 5) EN61000-4-4 Class A Conducted immunity EN61000-4-6 Class A Magnetic Field Immunity EN61000-4-8 Class A DS_PM05S_11212014 E-mail: [email protected] http:// www.deltaww.com/dcdc P2 Power Derating Curve 100 Output Power (%) 80 Natural Convection 20LFM 60 40 20 0 ~ -40 0 20 40 60 80 100 110 Ambient Temperature C Notes 1 Specifications typical at Ta=+25℃, resistive load, nominal input voltage, rated output current unless otherwise noted. 2 Ripple & Noise measurement bandwidth is 0-20 MHz. 3 All DC/DC converters should be externally fused at the front end for protection. 4 Other input and output voltage may be available, please contact factory. 5 The PM05S series can meet EN61000-4-4 by adding a capacitor across the input pins. Suggested capacitor CHEMI-CON KY 330μF/100V. 6 That “natural convection” is about 20LFM but is not equal to still air (0 LFM). 7 It needs to increase 1V for Vin(min) under high and low temperature. 8 Specifications are subject to change without notice. EMI-Filter to meet EN 55022, class A, class B; FCC part 15 ,level A L1 +Vout +Vin M78A Module C1 C2 C3 Load GND Class Class A Class B Model C1 PM05S series --- PM05S series 4.7μF/50V 1206 MLCC DS_PM05S_11212014 C2 C3 L1 4.7μF/50V 1206 MLCC 4.7μF/50V 1206 MLCC 4.7μF/50V 1206 MLCC 4.7μF/50V 1206 MLCC Wurth Elektronik NO. 744774033 Wurth Elektronik NO. 74477410 E-mail: [email protected] http:// www.deltaww.com/dcdc P3 Mechanical Drawing Mechanical Dimensions Pin Connections Pin 0.5 [0.02] Function 1 +Vin 2 GND 3 +Vout 0.25 [0.01] 2x2.54 [2x0.10] 0.70 [0.03] 1 2 3 Bottom View 7.55 [0.30] 0.5 [0.02] 2.0 [0.08] 4.1 [0.16] 10.2 [0.40] 11.5 [0.45] ►All dimensions in mm (inches) ►Tolerance: X.X±0.5 (X.XX±0.02) X.XX±0.25 ( X.XXX±0.01) 10.5 [0.41] ►Pins ±0.05(±0.002) Physical Characteristics Case Size : 11.5x7.55x10.2mm (0.45x0.30x0.40 inches) Case Material : Non-Conductive Black Plastic (flammability to UL 94V-0 rated) Pin Material : Alloy 42 Weight : 1.95g Part Numbering System P M 05 S 033 A Form factor Family series Watt Number of Outputs Output Voltage Option Code P-SIP M-Regulator 05:0.5AMP S - Single 033:3.3VDC A - Std. Functions WARRANTY Delta offers a three(3) years limited warranty. Complete warranty information is listed on our web site or is available upon request from Delta. Information furnished by Delta is believed to be accurate and reliable. However, no responsibility is assumed by Delta for its use, nor for any infringements of patents or other rights of third parties, which may result from its use. No license is granted by implication or otherwise under any patent or patent rights of Delta. Delta reserves the right to revise these specifications at any time, without notice. DS_PM05S_11212014 E-mail: [email protected] http:// www.deltaww.com/dcdc P4