all converter caty11399448739

®
M78SA
Switching Regulator 0.5A, SMD Package
FEATURES
►SMD-Package 15.3x9.6x8.8 mm
►Very high Efficiency up tp 97%
►Excellent Line/Loads Regulation
►Low Ripple and Noise
►Short Circuit Protection
►Operating Temp.Range -40°C to +90°C
►Thermal Shutdown
►Low Stand-by Current
►3 Years Product Warranty
PRODUCT OVERVIEW
The MINMAX M78SA series is a new range of switching regulators designed as a drop-in replacement for old LM78xx linear regulators with low
efficiency.The very high efficiency of these step-down converters allow an operating temperature up to 80°C at full-load without need of any heatsink.
The high efficiency and low stand-by power consumption of these switching regulators offer the designer a new, cost-efficient solution for many applications.
Model Selection Guide
Model
Number
Output
Voltage
Input Voltage
Range(6)
VDC
M78SAR015-0.5
M78SAR018-0.5
M78SAR025-0.5
M78SAR033-0.5
M78SAR05-0.5
M78SAR065-0.5
M78SAR09-0.5
M78SAR12-0.5
M78SAR15-0.5
4.75 ~ 32
6.5 ~ 32
8 ~ 32
11 ~ 32
15 ~ 32
18 ~ 32
Output Current
Normal
Adjust Range(8)
Max.
VDC
1.5
1.8
2.5
3.3
5
6.5
9
12
15
VDC
1.4~2.5
1.5~3
1.5~3
3~5.5
3~8
3.3~11
4.5~12.6
4.5~13.5
4.5~15.5
mA
500
500
500
500
500
500
500
500
500
Max. capacitive
Load
µF
220
220
220
220
220
220
220
220
220
Efficiency
(typ.)
Efficiency
(typ.)
@Min. Vin
@Max. Vin
%
73
82
87
91
94
95
96
97
97
%
63
71
77
81
86
88
92
94
95
Input Specifications
Parameter
Conditions
Min.
Typ.
Max.
Unit
-0.3
---
34
VDC
Internal Power Dissipation
---
---
0.4
W
Short Circuit Input Power
---
---
1.5
W
@No Load
---
5
---
mA
Conditions
Min.
-----------
Typ.
±2.0
±0.2
±0.1
±0.4
±0.25
Max.
±3.0
±0.4
±0.2
±0.6
±0.4
Unit
%Vnom.
%
%
%
%
----100
±2
---
30
40
----±0.015
mV P-P
mV P-P
µsec
%
%/℃
Input Surge Voltage (1 sec. max.)
Internal Filter Type
Capacitor
Input Current
Output Specifications
Parameter
Output Voltage Setting Accuracy
1.5V to 6.5V
9V to 15V
1.5V to 6.5V
Io=10% to 100%
9V to 15V
No minimum Load Requirement
1.5V to 6.5V
--0-20MHz Bandwidth
9V to 15V
----50% Load Step Change
----Continuous
Line Regulation
Vin=Min. to Max.
Load Regulation
Min.Load
Ripple & Noise
Transient Recovery Time
Transient Response Deviation
Temperature Coefficient
Short Circuit Protection
E-mail:[email protected]
2014/04/15 REV:6
Tel:886-6-2923150
Page 1 of 4
®
M78SA
Switching Regulator 0.5A, SMD Package
General Specifications
Parameter
I/O Isolation Voltage
Switching Frequency
MTBF(calculated)
Moisture Sensitivity Level (MSL)
Conditions
Min.
Typ.
Max.
Unit
280
2,000,000
330
---
380
---
KHz
Hours
Typ.
Max.
Unit
---
---
35
µA
Conditions
Min.
Typ.
Max.
Unit
Natural Convection
-40
---
+90
℃
---
---
+100
℃
-55
---
+125
℃
---
160
---
℃
---
---
95
% rel. H
none
MIL-HDBK-217F@25℃, Ground Benign
IPC/JEDEC J-STD-020D.1
Level 2
Remote On/Off Control
Parameter
Conditions
Min.
Converter On
Open or 2.4V<Vr<5V
Converter Off
GND or 0<Vr<1.6V
Standby Input Current
Supply Off & 24 Vin
Environmental Specifications
Parameter
Operating Ambient Temperature Range (See Power Derating Curve)
Case Temperature
Storage Temperature
Thermal Shutdown
Internal IC junction
Humidity (non condensing)
Lead-free reflow solder process
IPC/JEDEC J-STD-020D.1
EMC Specifications
Parameter
Conducted EMI
Radiated Emissions
ESD
Radiated immunity
Fast transient (4)
Conducted immunity
Magnetic Field Immunity
Standards & Level
Compliance to EN55022 and FCC part 15
EN55022
EN61000-4-2 air±8KV
EN61000-4-3 3V/m
EN61000-4-4 ±0.5KV
EN61000-4-6 3Vrms
EN61000-4-8 3A/m
Performance
Class B (See Page 3)
Class B
Class A
Class A
Class A
Class A
Class A
Power Derating Curve
Notes
1
2
3
4
5
6
7
8
Specifications typical at Ta=+25℃, resistive load, nominal input voltage, rated output current unless otherwise noted.
Other input and output voltage may be available, please contact factory.
We recommend to protect the converter by a slow blow fuse in the input supply line.
The M78SA series can meet EN61000-4-4 by adding a capacitor across the input pins. Suggested capacitor CHEMI-CON KY 330µF/100V.
That “natural convection” is about 20LFM but is not equal to still air (0 LFM).
With a input capacitor 22µF/50V for input voltage >28VDC, the input voltage allows 32VDC, max.
Specifications are subject to change without notice.
Input voltage must be higher than output voltage set:>1.5V for 3.3V~5V and >3V for 6.5V~15V.
E-mail:[email protected]
2014/04/15 REV:6
Tel:886-6-2923150
Page 2 of 4
®
M78SA
Switching Regulator 0.5A, SMD Package
Adjustment Resistor Values
M78SAR015-0.5
M78SAR018-0.5
M78SAR025-0.5
M78SAR033-0.5
M78SAR05-0.5
M78SAR065-0.5
M78SAR09-0.5
M78SAR12-0.5
1.5VDC
1.8VDC
2.5VDC
3.3VDC
5.0VDC
6.5VDC
9.0VDC
12VDC
Vout(nom.)
Vout(adj)
R1
1.4 (V)
1 KΩ
R2
1.5 (V)
R1
R2
R1
3KΩ
1.8 (V)
6.49 KΩ
2.5 (V)
0.47 KΩ
R2
R1
R2
44.2KΩ
88.4KΩ
R1
R2
R1
R2
R1
R2
R1
M78SAR15-0.5
15VDC
R2
R1
R2
200Ω
12KΩ
11.8KΩ
3.0 (V)
4.64KΩ
17KΩ
3.3 (V)
3.6 (V)
60.4KΩ
27KΩ
15KΩ
42KΩ
21.5KΩ
3.9 (V)
28KΩ
58KΩ
30.1KΩ
4.5 (V)
11.3KΩ
180KΩ
56.3KΩ
26KΩ
17KΩ
10.5 KΩ
4.9 (V)
7.15KΩ
850KΩ
78.7KΩ
36KΩ
24KΩ
15.8 KΩ
5.0 (V)
6.34KΩ
86KΩ
39KΩ
26KΩ
17.4 KΩ
5.1 (V)
5.9KΩ
231KΩ
97KΩ
42KΩ
28KΩ
18.7 KΩ
5.5 (V)
3.9KΩ
56.2KΩ
154KΩ
56KΩ
36KΩ
24.9 KΩ
6.5 (V)
14KΩ
8.0 (V)
2.32KΩ
22.6KΩ
112KΩ
63KΩ
42.2 KΩ
400KΩ
125KΩ
78.7 KΩ
9.0 (V)
9.53KΩ
200KΩ
113 KΩ
10 (V)
3.92KΩ
54.9KΩ
345KΩ
160 KΩ
11 (V)
825Ω
16.5KΩ
740KΩ
232 KΩ
12 (V)
3.6KΩ
12.6 (V)
0Ω
13.5 (V)
340 KΩ
180KΩ
464 KΩ
57.6 KΩ
787 KΩ
15.5 (V)
300 KΩ
+Vin
+Vo
Switching
Regulator
R1
On/Off
Adj
R2
-Vin
-Vo
EMI-Filter to meet EN 55022, class A, class B; FCC part 15 ,level A
L1
+Vout
+Vin
M78SA Module
C1
C2
C3
Load
GND
Class
C1
C2
C3
Class A
---
4.7µF/50V 1206 MLCC
4.7µF/50V 1206 MLCC
Class B
4.7µF/50V 1206 MLCC
4.7µF/50V 1206 MLCC
4.7µF/50V 1206 MLCC
E-mail:[email protected]
2014/04/15 REV:6
Tel:886-6-2923150
Page 3 of 4
L1
Wurth Elektronik
NO. 744774033
Wurth Elektronik
NO. 74477410
®
M78SA
Switching Regulator 0.5A, SMD Package
Package Specifications
Connecting Pin Patterns
2.54x4
[0.10x4]
6
TOP View
1
2
3
4
5
9.6 [0.38]
7
11.7 [0.46]
8
9.6 [0.38]
9
10.16
[0.40]
12.35 [0.49]
10
2.1
[0.08]
15.3 [0.60]
2.57
[0.10]
13.8 [0.54]
Mechanical Dimensions
0.44
[0.02]
0.55
[0.02]
2.54
[0.10]
9.24 [0.36]
8.8 [0.35]
1.30 [0.05]
1.2
[0.05]
S SEATING
PLANE
4
0~
►All dimensions in mm
0.1 S
►Tolerance: X.X±0.5
(inches)
(X.XX±0.02)
X.XX±0.25 ( X.XXX±0.01)
►Pins ±0.05(±0.002)
Pin Connections
Pin
1
Function
+Vin
2
+Vin
3
GND
4
+Vout
5
+Vout
6
Vadj.
7
GND
8
GND
9
GND
10
Remote On/Off
Physical Characteristics
Case Size
:
15.3x9.6x8.8mm (0.60x0.38x0.35 inches)
Case Material
:
Non-Conductive Black Plastic (flammability to UL 94V-0 rated)
Pin Material
:
phosphor bronze
Weight
:
1.7g
18, Sin Sin Road, An-Ping Industrial District, Tainan 702, Taiwan
Tel: 886-6-2923150 Fax: 886-6-2923149 E-mail: [email protected]
Minmax Technology Co., Ltd.
2014/04/15 REV:6
Page 4 of 4