Available as: RF AMPLIFIER MODEL TM6615PM TM6615PM, 4 Pin TO-8 (T4) TN6615PM, 4 Pin .450” Sq. Surface Mount (SM3) FP6615PM, 4 Pin Flatpack (FP4) BX6615PM, SMA Connectorized Housing (H1) Typical Intermodulation Performance at 25 ºC Features Second Order Harmonic Intercept Point ....... +48 dBm (Typ.) Second Order Two Tone Intercept Point ........ +42 dBm (Typ.) Third Order Two Tone Intercept Point ............ +30 dBm (Typ.) n Superior Phase Noise Performance n Output Power: +15.5 dBm Typical n Operating Temp. -55 ºC to +85 ºC Absolute Maximum (No Damage) Ratings Specifications CHARACTERISTIC Frequency TYPICAL Ta= 25 ºC 5 - 500 MHz MIN/MAX Ta = -55 ºC to +85 ºC 5 - 500 MHz 10 8.5 Min. +15.5 +14.0 Min Gain (dB) Power @ 1 dB Comp. (dBm) Reverse Isolation (dB) -15.5 VSWR -14 In Out Noise Figure (dB) 1.5:1 1.5:1 5.5 2.0:1 Max. 2.0:1 Max. 7.0 Max. Power +15 50 +15 55 Max. Vdc mA Note: Care should always be taken to effectively ground the case of each unit. Ambient Operating Temperature ................ -55ºC to +100 ºC Storage Temperature ................................. -62ºC to +125 ºC Case Temperature .................................................. +125 ºC DC Voltage .......................................................... +18 Volts Continuous RF Input Power .................................. +13 dBm Short Term RF Input Power ...... 50 Milliwatts (1 Minute Max.) Maximum Peak Power .................... 0.5 Watt (3 µsec Max.) Thermal Resistance θ 19.68 ºC/watt jc .................. Guaranteed @ 25 ºC (200 MHz) Phase Noise Performance (dBc/Hz)* Frequency Typical Guarantee (Min.) -163 -159 100 Hz 1 kHz -168 -172 -173 -169 10 kHz 100 kHz -171 -175 1 MHz -171 -175 Revision 12/3/2013 *Note: Phase Noise Performance typically tested at midband. Bandedge performance may vary. Typical Performance Data Gain (dB) 12 0 11 - 5 10 -10 9 -15 Reverse Isolation (dB) -140 - 150 -20 8 Start 5 MHz Stop 500 MHz Stop 500 MH z Noise Figure (dB) - 170 7 6 +16 - 180 5 +15 +14 4 +13 3 Start 5 MHz 2.0 Input VSWR Stop 500 MHz -190 100 Start 5 MHz Output VSWR Legend Stop 500 MHz +25 ºC 1.0 10K 100K 1M Stop 500 MH z Phase Noise Test Conditions: Carrier Frequency: 200 MHz Power Output: +15.5 dBm Temperature: 25 ºC Agilent ES5500 System 1.5 Start 5 MHz 1K Typical 2.0 1.5 1.0 - 160 Sta rt 5 MH z 1 dB Comp. (dBm) +17 Phase Noise (dBc/Hz) -130 Start 5 MHz Stop 500 MHz +85 ºC - - - - - - -55 ºC Spectrum Microwave · 2144 Franklin Drive N.E. · Palm Bay, Florida 32905 · PH (888) 553-7531 · Fax (888) 553-7532 www.SpectrumMicrowave.com Spectrum Microwave · 2707 Black Lake Place · Philadelphia, Pennsylvania 19154 · PH (215) 464-4000 · Fax (215) 464-4001