DC-DC Converter Bricks, Open/Enclosed BAH SERIES, 1/2 BRICK, UP TO 300W FEATURES: 5 year warranty 1500Vdc isolation voltage Output current up to 60A Efficiency up to 93% Operating temperature range -40 Under voltage, over current, short circuit, ℃ to +85 ℃ over voltage protection Remote on/off Adjustable output voltage Output voltage (Vdc) Output current (A) Efficiency Typ. BAH48-33V25 3.3 25.0 92% BAH48-33V30 3.3 30.0 93% 5.0 15.0 94% BAH48-50V30 5.0 30.0 93% BAH48-50V40 5.0 40.0 92% Model BAH48-50V15 Input voltage (Vdc) 48(36~72) Notes: 1. Other input and output models may available on request; 2. You may request for the models with heatsink, plus “R” in the suffix, e.g. BAH48-25V30R. ELECTRICAL Input voltage range 48Vdc 36-72Vdc OFF: High level or left close Negative logic ON: Low level or grounded Remote control ON: High level or left open Positive logic OFF: Low level or grounded Output power Input voltage range Output voltage Single output Output voltage accuracy Input voltage range Output voltage adjustable Positive Line regulation Full load ±0.2% Load regulation 10%-100% full load ±0.5% Dynamic response (transient/recovery time) 50-300W 2.5/3.3/5/12Vdc ±1% -20% - +10% 25%-50%-75% load capability Ripple and noise Parallel test, 20MHz wide range Operating frequency Typical value Isolation resistance --- www.pairuigroup.com ∆Vo/∆t: ±4.0%/500μs 180mVp-p max. 250KHz typ. 10MΩ Page: 1/4 Date: 11/07/2015 DC-DC Converter Bricks, Open/Enclosed BAH SERIES, 1/2 BRICK, UP TO 300W ELECTRICAL Isolation voltage Input to output 1500Vdc Input to case 1050Vdc Output to case 500Vdc IEC-60950-1, UL-60950-1 Safety --- Temperature coefficient --- Operating temperature range Auxiliary heat sink Storage temperature range --- Over temperature protection Typical Under voltage protection --- Yes Over current protection --- Yes Short circuit protection --- Yes Over voltage protection --- Yes Relative humidity --- 95% max. MTBF Bellcore TR-332, 25 EN-60950-1, GB4943 300ppm ℃ to +85℃ -40℃ to +125℃ 110℃ typ. -40 ℃ 2000KHrs Notes: All the parameters are measured at 25℃ ambient temperature, humidity < 75%, nominal input voltage, full load and after warm-up, unless otherwise specified. MECHANICAL WITHOUT HEATSINK www.pairuigroup.com WITH HEATSINK Page: 2/4 Date: 11/07/2015 DC-DC Converter Bricks, Open/Enclosed BAH SERIES, 1/2 BRICK, UP TO 300W MECHANICAL PCB LAYOUT CONNECTION PIN # SINGLE 1 -Vin 2 FG 3 REM 4 +Vin 5 GND 6 -S 7 TRIM 8 +S 9 +Vo Note: * Unit is mm(inch). DERATING CURVE EFFICIENCY CURVE NOTES RECOMMENDED TEST AND APPLICATION CIRCUIT www.pairuigroup.com Page: 3/4 Date: 11/07/2015 DC-DC Converter Bricks, Open/Enclosed BAH SERIES, 1/2 BRICK, UP TO 300W NOTES 1. TVS&FUSE be helpful with over voltage protection and inrush limiting. Recommended FUSE better be 1.5~2times of the rated current . 2. The input filter capacitor C6 could select the aluminum electrolytic capacitors or tantalum capacitors, and the withstand voltage should be greater than the highest input voltage. Recommended capacitor should be between 22μF~100μF. 3. C1,C2 for the input filter capacitor,0.1~1μF high-frequency ceramics capacitor or chip capacitor are recommended. The withstand voltage of output filter C5, C7 should be greater than the highest output voltage. Recommended capacitor of C7 better within 100μF and C5 connected with the chip to reduce the input voltage peak, recommended 0.1~1μF high-frequency ceramics capacitor or chip capacitor. www.pairuigroup.com Page: 4/4 Date: 11/07/2015