DC-DC Converter DIP-Package DNV-50 SERIES, 50WATT, 2:1 INPUT RANGE FEATURES: 1500Vac isolation voltage Six-side shielded metal case with low ripple and noise Over voltage, over current, short circuit protection Operating temperature range -40 3 year warranty Remote on/off Adjustable output voltage ℃ to +85℃ Output voltage (Vdc) Output current (A) Efficiency Typ. 5.1 10 89% 12.1 4.2 89% 15.1 3.3 89% 5.1 10 88% 12.1 4.2 89% 15.1 3.3 89% 24.2 2 89% 48.2 1 87% DNV50-4811 5.1 10 88% DNV50-4812 12.1 4.2 89% 15.1 3.3 89% DNV50-4814 24.2 2 89% DNV50-4815 48.2 1 89% DNV50-11011 5.1 10 89% 12.1 4.2 89% 15.1 3.3 89% 24.2 2 89% Model DNV50-1211 DNV50-1212 DNV50-1213 DNV50-2411 DNV50-2412 DNV50-2413 DNV50-2414 DNV50-2415 DNV50-4813 DNV50-11012 DNV50-11013 DNV50-11014 Input voltage (Vdc) 12(9~18) 24(18~36) 48(36~72) 110(66~160) Notes: 1. Other input and output models may available on request; 2. You may request for the models with heatsink, plus “R” in the suffix, e.g. DNV50-1211R. www.pairuigroup.com Page: 1/4 Date: 08/01/2014 DC-DC Converter DIP-Package DNV-50 SERIES, 50WATT, 2:1 INPUT RANGE ELECTRICAL Output voltage adjustable Remote control --- ±10% max. REM left open Output on REM connect with -Vin Output off Output voltage accuracy --- Line regulation Nominal Load, full voltage ±0.2% max. Load regulation 20% ~ 100% rated load ±0.5% max. Dynamic response (transient/recovery time) Ripple and noise Isolation voltage (<2mA/min) ≤1% 5%-50%-75% load capability 20MHz BM, full load ∆Vo/∆t: ±5.0%/400μs 1% Vout max. Input to output 1500Vac Input to case 1500Vac Output to case 500Vac Isolation resistance 500Vdc 100MΩ Temperature coefficient --- Operating temperature range Auxiliary heat sink Storage temperature range --- Input under voltage protection ±0.02%/℃ max. -40℃ to +85℃ -45℃ to +120℃ When input voltage is lower than the low terminal input voltage Auto-recovery Over current protection --- Auto-recovery Short circuit protection --- Continuous auto-recovery Over voltage protection --- Auto-recovery Relative humidity --- 10%-90% max. MTBF Bellcore TR-332, 25℃ Weight --- 200KHrs 69g Notes: All the parameters are measured at 25 ℃ ambient temperature, humidity < 75%, nominal input voltage, full load and after warm-up, unless otherwise specified. www.pairuigroup.com Page: 2/4 Date: 08/01/2014 DC-DC Converter DIP-Package DNV-50 SERIES, 50WATT, 2:1 INPUT RANGE MECHANICAL WITHOUT HEATSINK WITH HEATSINK PCB LAYOUT CONNECTION PIN # SINGLE 1 +Vin 2 -Vin 4 REM 5 No Pin 6 +Vo 7 GND 8 ADJ Note: * Unit is mm(inch). www.pairuigroup.com Page: 3/4 Date: 08/01/2014 DC-DC Converter DIP-Package DNV-50 SERIES, 50WATT, 2:1 INPUT RANGE TEMPERATURE PROFILE CAPACITIVE LOADS SELECTION Vout: 3.3V 5V Recommended MAX. value value 4700μF 10000μF Vout: 12V 5V Recommended value 1000μF Vout: 24V MAX. Recommended MAX. value value value 2200μF 470μF 1000μF NOTES RECOMMENDED TEST AND APPLICATION CIRCUIT 1. TVS&FUSE be helpful with over voltage protection and inrush limiting. Recommended FUSE better be 1.5~2times of the rated current . 2. The input filter capacitor C6 could select the aluminum electrolytic capacitors or tantalum capacitors, and the withstand voltage should be greater than the highest input voltage. Recommended capacitor should be between 22μF~100μF. 3. C1,C2 for the input filter capacitor,0.1~1μF high-frequency ceramics capacitor or chip capacitor are recommended. The withstand voltage of output filter C5, C7 should be greater than the highest output voltage. Recommended capacitor of C7 better within 100μF and C5 connected with the chip to reduce the input voltage peak, recommended 0.1~1μF high-frequency ceramics capacitor or chip capacitor. www.pairuigroup.com Page: 4/4 Date: 08/01/2014