LEDTA−6 24 Watt Power Supply and Adapter for LED Tubing 2.1mm I.D. x 5.5mm O.D. Plug Description: This document introduces the electrical, mechanical and environmental specifications of a switching power supply. − + Features: D Includes LEDTA−3 Power Supply Adapter INPUT REQUIREMENT: Item Specification Min Min Max Normal AC Input Voltage Single Phase 100VAC 110VAC/220VAC 240VAC AC Input Voltage Range Single Phase 90VAC 110VAC/220VAC 264VAC AC Input Frequency Single Phase 47Hz 50/60Hz 63Hz AC Input Current Typical Input Voltage & Output at Full Load − − 550mA AC Inrush Current Typical Inputs Voltage & Output at Full Load, +25C − − 30A Average Efficiency Typical Input Voltage & Output at (Standard Load) 82.09% − − OUTPUT SPECIFICATION: Item Specification Normal DC Output Voltage DC Output Voltage Range Typical Output Voltage Load Current Range Min Min Max − 12VDC − 11.4V − 12.6V 0.1A − 2.0A Peak Load Current Time < 60ns − − 2.3A Ripple Typical Input Voltage, Typical Load Current, +25C − − 12.mV Hold−Up Time At Typical Input Voltage and Full Load 10mS − − Turn−On Delay Typical Input Voltage and Typ Load Current − − 3S Overcurrent Protection Auto Recovry Short−Circuit Protection The Adapter Shall Not be Damaged by Shorting the DC Output to GND Overvoltage Protection − 13.8V 16V No Load Power Dissipation − − 0.3W Rev. 2−14 MECHANICAL: Item Specification OR Test Condition Bending Test Acceptance Criteria Normal Temperature No Short Circuit The Cord Shall Withstand Weight of 200g, Swinging No Breakage of the Cord From Left to Right at an Angle of 60 1000 Cycle Times Min. S/R Shall Withstand Weight of 1N, Swinging from Left to Right at an Angle of 60 1000 Cycle Times Min. Bending Speed 40 Cycle/Minute Vibration Frequency Range: 10 to 55Hz There Shall Be No Abnormality on the Appearance Structure and Operating Amplitude: 1.5mm Acceleration: 1G Sweep 1 Minute fo X, Y, Z Axis Each RELIABILITY: Item Test Condition Acceptance Criteria Temperature Up with Typical Load Test at Surface of the Case with Typical AC Input and Temperature Up Under 35 Typical Load in Output 50/60Hz Hi−Pot Test Input to Output No Damage Gradually Raised from 0 to TH 3000VAC and Held at that value for 3S, 5mA Insulation Resistance Input to Output, DC 500V > 50M MTBF Typical Input & Full Load, +25C 50000 Hours Life Typical Input & Full Load, +40C 1 Years Above Typical Input & Full Load, +25C 2 Years Above At +30C (10C), Normal Input Voltage 2 − 4 Hours Burn−In ENVIRONMENT: Item Specification or Test Conditions Operating Temperature Storage Temperature Min Min Max 0C 40C −20C +85C Operating Humidity Non−Condensing 5% RH 90% RH Storage Humidity Non−Condensing 5% RH 90% RH LEDTA−6 LEDTA−3