NSTS9116

NSTS9116 Jun. 2014
New JRC SAW FILTER
NSTS9116
Application
1589.5MHz
GNSS 1st Filter
Electrical Specification: (Table 1)
The device characteristics are measured in the circuit shown in Fig.1.
Item
Input and Output Impedance
Nominal Center Frequency (f0)
Insertion Loss
1589.5±16MHz
Response Variation
Input and Output VSWR
Out of Band Rejection
800~1000MHz
(Relative to
1700~2100MHz
Through Level)
Spec.
2.0dB max.
1.0dB max.
2.0 max.
Typ.
50Ω
1589.5MHz
1.35dB
0.3dB
1.7
17dB min.
21dB
20dB min.
23dB
Operating Temperature : -40~+105ºC
Maximum Rating: (Table 2)
Table 2. Maximum Ratings
Item
Maximum Input Power (In Band)
Maximum DC Voltage
Operating Temperature
Storage Temperature Limit
Rating
+10dBm
7.5V
-40~+105ºC
-40~+110ºC
Mechanical Specifications: (Fig.2)
Package is designed as small as 2.0x1.6x0.65[mm3] for SMD (Surface Mount Device) type.
Notice:
This part is electrostatic discharge sensitive and may be damaged by improper handling.
http://www.njr.co.jp/products/device/index.html
http://www.njr.com/products/device/index.html
NSTS9116 Jun. 2014
IN
50Ω
OUT
50Ω
4
1
SA W
2
3
Fig.1 Measuring circuit
(2)
2.0±0.15
(1)
(3)
1.6 ± 0 . 1 5
170
YB
(4)
0.7Max.
Marking
Lot Number
(1) Year
(2) Month
*Oct.--Nov.--Dec.--(3) Date
*1-9--10-19--20-31--(4) Part Number Mark
2
40.50 ± 0 . 1 0
3
40.55±0.10
4
8(0.075)
1
Fig.2 Package dimensions (in mm)
1. 80
4- 0. 60
2. 20
4- 0. 65
Fig.3 Desirable land area (in mm)
Pin no.
1
2
3
4
Connection
GND
IN
GND
OUT
X
Y
Z
0
1
2
NSTS9116 Jun. 2014
Notice
1. Use this component within operating temperature range. It might not be
satisfied with electrical specification without operating temperature range.
When it is used less than -40ºC or more than +105ºC, it might be a cause of
degradation or destruction of the component. Even if it endures during a short
time, it causes degradation of qualification.
2. When soldering iron is used, solder with the temperature at the tip of soldering
iron: 350ºC max., the time of soldering: 5 seconds max., the power of
soldering iron: 30W max..
3. Notice that the allowed time of soldering with soldering iron is accumulated
time, when soldering is repeated.
4. As rapid temperature change for cleaning after reflow soldering might be a
cause of destruction clean this component after confirming that temperature of
this component goes down to room temperature.
5. Confirm that there are not any influence for qualification to this component in
mounting on PCB when this component is cleaned.
6. As it might be a cause of degradation of destruction to apply static electricity to
this component, do not apply static electricity or excessive voltage while
assembling and measuring. And do not transport this component with bare
hand.
7. As it might be a cause of degradation or destruction to apply D.C. voltage
between each terminal, apply D.C. voltage 7.5V max. in actual circuit.
Note
1. This specification specifies the quality of this component as a single unit. Make
sure that this component is evaluated and confirmed against this specification
when it is mounted to your products.
2. The information contained herein may be changed without prior notice. It is
therefore advisable to contact New Japan Radio Company before proceeding
with the design of equipment incorporating this product.
3.
The products are designed to be used with ordinary electronic equipment (data
and communications equipment, office equipment, audio-video equipment,
measuring instruments, etc). New Japan Radio Company does not assume any
liability for the case using the products with the application required high
reliability or safety extremely (such as space equipment, sea-bottom equipment,
medical equipment etc). When intending to use any our product please
contact our sales representatives in advance.
NSTS9116 Jun. 2014
Insertion Loss [dB]
0
FREQUENCY CHARACTERISTICS
0
10
2
20
4
30
6
40
8
50
10
CH1 : center 1589.5 span 200
CH2 : center 1589.5 span 200
S11
S22
S22
11
9
9
VSWR
VSWR
S11
11
7
5
3
7
5
3
1
1489.5
1689.5
1
1489.5
Frequency [MHz]
S21
0
InsertionLoss [dB]
1689.5
Frequency [MHz]
10
20
30
40
50
0
3000
Frequency [MHz]
New Japan Radio Co.,Ltd.
Insertion Loss [dB]
S21