Document 860 SMD Telecoil – CP-H0114-C Core material Ferrite Terminations RoHS compliant silver-palladium-platinum-glass frit. Other terminations available at additional cost. Weight 100 mg Ambient temperature –40°C to +85°C with Irms current, +85°C to +100°C with derated current Storage temperature Component: –40°C to +100°C. Packaging: –40°C to +80°C Resistance to soldering heat Max three 40 second reflows at +260°C, parts cooled to room temperature between cycles Moisture Sensitivity Level (MSL) 1 (unlimited floor life at <30°C / 85% relative humidity) Failures in Time (FIT) / Mean Time Between Failures (MTBF) One per billion hours / one billion hours, calculated per Telcordia SR-332 Packaging 1000 per 7″ reel; 3500 per 13″ reel Paper tape: 12 mm wide, 0.23 mm thick, 8 mm pocket spacing, 2.34 mm pocket depth PCB washing Only pure water or alcohol recommended Part number1 CP-H0114-C_ Inductance2 ±5% (mH) 6.6 SRF typ3 (kHz) SRF in parallel with 220 pF capacitor ±3 (kHz) DCR max4 (Ohms) Irms5 (mA) 710 124.6 82.7 30 1. When ordering, please specify packaging code: CP-H0114-CC Packaging: C = 7″ machine-ready reel. EIA-481 embossed plastic tape (2000 parts per full reel). B = Less than full reel. In tape, but not machine ready. To have a leader and trailer added ($25 charge), use code letter C instead. D = 13″ machine-ready reel. EIA-481 embossed plastic tape. Factory order only, not stocked (3500 parts per full reel). 2. Inductance measured at 125 kHz, 0.1 Vrms using Coilcraft SMD-B fixture in Agilent/HP 4192-A impedance analyzer with Coilcraftprovided correlation pieces. 3. SRF measured using Agilent/HP 8753D network analyzer with Coilcraft SMD-D test fixture. 4. DCR measured on Cambridge Technology Micro-ohmmeter. 5. Current that causes a 15°C temperature rise from 25°C ambient. Because of their open construction, these parts will not saturate. 6 Electrical specifications at 25°C. Refer to Doc 362 “Soldering Surface Mount Components” before soldering. B overall A C F I G J F I E terminal A max B max Recommended Land Pattern Terminal wraparound: approx 0.015/0,38 both ends C max D ref E F G H I J 0.224 0.098 0.098 0.039 0.083 0.031 0.138 0.093 0.041 0.129 inches 5,70 2,50 2,50 1,00 2,10 Specifications subject to change without notice. Please check our website for latest information. © Coilcraft, Inc. 2010 H D 0,80 3,50 2,36 Document 860 1,04 3,27 mm Revised 12/08/10