Document 1251 Isolation Transformers For Analog Devices ADuM347x Quad-Channel Digital Isolators • AEC-Q200 Grade 1 qualified • Developed to work with Analog Devices ADuM347x quadchannel, digital isolators in automotive applications • Power rating: 2 Watts • Designed to meet UL/CSA/IEC 60950 Basic Insulation with 1.5 mm creepage and clearance. Core material Ferrite Terminations Tin-silver over tin over nickel over phos bronze Isolation 2500 Vrms primary to secondary; 500 Vrms winding to core Weight 0.95 – 0.98 g Ambient temperature –40°C to +125°C Maximum part temperature +165°C (ambient + temp rise) Storage temperature Component: –40°C to +125°C. Tape and reel packaging: –40°C to +80°C Resistance to soldering heat Max three 40 second reflows at +260°C, parts cooled to room temperature between cycles Moisture Sensitivity Level (MSL) 1 (unlimited floor life at <30°C / 85% relative humidity) Failures in Time (FIT) / Mean Time Between Failures (MTBF) 38 per billion hours / 26,315,789 hours, calculated per Telcordia SR-332 Packaging 600/13″ reel; Plastic tape: 24 mm wide, 0.37 mm thick, 16 mm pocket spacing, 6.1 mm pocket depth PCB washing Tested to MIL-STD-202 Method 215 plus an additional aqueous wash. See Doc787_PCB_Washing.pdf. Part Inductance2Turns number1 min (µH) ratio PA6547-AL_63.75 PA6548-AL_63.75 PA6549-AL_63.75 1 : 2 1 : 3 1 : 5 Pri / output voltages output output pri (pin 8) (pins 6 & 7) 5 V 5 V 5 V +3.3 to +5 V +12 to +15 V +12 to +15 V DCR max 3 output(Ohms) (pin 5) pri sec 0 V No output +6 to +7.5 V 0 V 0 V –12 to –15 V 0.095 0.190 0.122 0.260 0.095 1.17 LeakageVolt-time inductance4 product5 max (µH) (V-µsec) 0.460 0.660 0.515 17.6 17.6 17.6 1. When ordering, please specify a packaging code: PA6549-ALD Packaging:D=13″ machine ready reel. EIA-481 embossed plastic tape (600 per full reel). B =Less than full reel. In tape, but not machine ready. To have a leader and trailer added ($25 charge), use code letter D instead. 2. Inductance is for the primary, measured from pins 4 – 3 at 1 kHz, 0.1 Vrms. 3. DCR is for each winding of the primary and secondary. 4. Leakage inductance is for the primary windings, measured from pins 1 – 4 with all secondary windings shorted. 5. Based on Bsat of the core at 25°C and the number of turns on winding 4 ‑ 3. 6. Electrical specifications at 25°C. Refer to Doc 362 “Soldering Surface Mount Components” before soldering. Analog Devices is a trademark of Analog Devices, Inc. Dimensions are in inches mm Document 1251 Revised 01/15/15