Assembly Instructions

AMT11-V SERIES
Step by step instructions for the AMT11-V series
REV.
A
DESCRIPTION
NEW DRAWING
DATE
01/09/2014
Tool A
Sleeve Sizes:
Top Cover
Wide Base
Base
AMT kits come with all items shown.
2 mm= Light Blue
3 mm= Orange
3.175 mm (1/8”)= Purple
4 mm= Gray
4.76 mm (3/16”)= Yellow
5 mm= Green
6 mm= RedTOLERANCE:
±0.05mm UNLESS OTHERWISE
SPECIFIED
6.35 mm (1/4”)=
White
8 mm = Blue
Shaft Adaptor
RoHS
Sleeve
Tool C
20050 SW 112th Ave.
Tualatin, OR 97062
Phone: 503-612-2300
800-275-4899
Fax: 503-612-2383
Website: www.cui.com
STEP 1
STEP 2
PC FILE NAME:
AMT31X Wide Base
TITLE:
AMT31X Wide Base
DRAWN BY:
RDS
COPYRIGHT 2013 BY CUI INC.
APPROVED BY:
STEP 3
REV:
AMT31X Wide Base
PART NO.
UNITS:
A
MM [INCHES]
SCALE:
2:1
Align Tool C with
flange on Base
1. Insert Tool A as a spacer that defines the distance
to the mounting surface.
2. Slide appropriate sized Sleeve over shaft all the
way down to Tool A.
3. Slide Shaft Adaptor over Sleeve.
4. Use Tool C to press Shaft Adaptor over Sleeve
(ensure Shaft Adapter and Tool C spline alignment)
until flush with Tool A.
STEP 4
1. Fasten the Base on the motor
(Tool C may need to be rotated to allow
for some mounting configurations).
2. Remove Tool C.
1. Remove Tools A and C.
2. Place Base on motor, with
Tool C used as a centering tool.
STEP 5
1. Snap the Top Cover onto the Base, carefully observing
that the teeth of the Shaft Adaptor align with the
grooves in the hub.*
* We recommend no more than three cycles of mounting and
removal of the AMT top cover base. Multiple cycles of mounting
and removing the top cover can cause base fatigue over time
and affect encoder performance.
1. Align Tool C with flange on Base.
2. Slide Base and Tool C onto motor,
centering onto the Shaft Adapter.
STEP 6
1. Make sure the snaps are fully engaged by pressing
on the Hub with the reverse side of Tool C.
2. When assembly is finished, the Shaft Adaptor, Sleeve
and Rotor Hub should all be flush with the Motor
Shaft rotating freely.
For additional instructions or information contact
customer support at CUI Inc: 800.275.4899
For more information visit www.cui.com
CUI Inc’s products are not intended for applications where a failure could result in costly, dangerous, or life threatening situations.
CUI Inc will not be responsible for damages, or losses greater than the cost of the CUI Inc replacement parts.
CUI Inc 20050 SW 112th Ave.
Tualatin, OR 97062
© 2014 CUI Inc. All rights reserved.
Information in this document is subject to change without notice.
02-2014