AMT31-V SERIES Step by step instructions for the AMT31-V series REV. A DESCRIPTION NEW DRAWING DATE 01/09/2014 Tool A Sleeve Sizes: Top Cover Wide Base Base AMT kits come with all items shown. 2 mm= Light Blue 3 mm= Orange 3.175 mm (1/8”)= Purple 4 mm= Gray 4.76 mm (3/16”)= Yellow 5 mm= Green 6 mm= RedTOLERANCE: ±0.05mm UNLESS OTHERWISE SPECIFIED 6.35 mm (1/4”)= White 8 mm = Blue Shaft Adaptor RoHS Sleeve Tool C 20050 SW 112th Ave. Tualatin, OR 97062 Phone: 503-612-2300 800-275-4899 Fax: 503-612-2383 Website: www.cui.com STEP 1 STEP 2 PC FILE NAME: AMT31X Wide Base TITLE: AMT31X Wide Base DRAWN BY: RDS COPYRIGHT 2013 BY CUI INC. APPROVED BY: STEP 3 REV: AMT31X Wide Base PART NO. UNITS: A MM [INCHES] SCALE: 2:1 Align Tool C with flange on Base 1. Insert Tool A as a spacer that defines the distance to the mounting surface. 2. Slide appropriate sized Sleeve over shaft all the way down to Tool A. 3. Slide Shaft Adaptor over Sleeve. 4. Use Tool C to press Shaft Adaptor over Sleeve (ensure Shaft Adapter and Tool C spline alignment) until flush with Tool A. STEP 4 1. Fasten the Base on the motor (Tool C may need to be rotated to allow for some mounting configurations). 2. Remove Tool C. 1. Remove Tools A and C. 2. Place Base on motor, with Tool C used as a centering tool. STEP 5 1. Snap the Top Cover onto the Base, carefully observing that the teeth of the Shaft Adaptor align with the grooves in the hub.* * We recommend no more than three cycles of mounting and removal of the AMT top cover base. Multiple cycles of mounting and removing the top cover can cause base fatigue over time and affect encoder performance. 1. Align Tool C with flange on Base. 2. Slide Base and Tool C onto motor, centering onto the Shaft Adapter. STEP 6 1. Make sure the snaps are fully engaged by pressing on the Hub with the reverse side of Tool C. 2. When assembly is finished, the Shaft Adaptor, Sleeve and Rotor Hub should all be flush with the Motor Shaft rotating freely. For additional instructions or information contact customer support at CUI Inc: 800.275.4899 For more information visit www.cui.com CUI Inc’s products are not intended for applications where a failure could result in costly, dangerous, or life threatening situations. CUI Inc will not be responsible for damages, or losses greater than the cost of the CUI Inc replacement parts. CUI Inc 20050 SW 112th Ave. Tualatin, OR 97062 © 2014 CUI Inc. All rights reserved. Information in this document is subject to change without notice. 02-2014