Datasheet

UNISONIC TECHNOLOGIES CO., LTD
FC8779
Preliminary
CMOS IC
SILICON MONOLITHIC
INTEGRATDE CIRCUIT

DESCRIPTION
Single-Phase Full-Wave Motor Driver for Fan Motor.

FEATURES
* Soft switched drive
* Built-in Lock Protection and Auto Restart Function
* FG Output
* Include Hall Bias Circuit
* Thermal shut-down circuit

ORDERING INFORMATION
Ordering Number
Lead Free
Halogen Free
FC8779L-SM1-R
FC8779G-SM1-R
www.unisonic.com.tw
Copyright © 2013 Unisonic Technologies Co., Ltd
Package
Packing
MSOP-8
Tape Reel
1 of 4
QW-R502-981.a
FC8779


CMOS IC
PIN CONFIGURATION
OUT2
1
8
GND
H+
2
7
OUT1
HB
3
6
VCC
H-
4
5
FG
FC8779
PIN DESCRIPTION
PIN NO
1
2
3
4
5
6
7
8

Preliminary
PIN NAME
OUT2
H+
HB
HFG
VCC
OUT1
GND
DESCRIPTION
H-bridge output connection.
Hall Input+
Hall Bias
Hall InputFG signal output terminal
Supply Voltage
H-bridge output connection.
Power GND.
BLOCK DIAGRAM
150kΩ
VCC
500Ω
OSC
OUT2
+
GND
Lock
Detection
Control
TSD
H+
+
H-
-
HB
OUT1
500Ω
Hall
Bias
150kΩ
FG
+
UNISONIC TECHNOLOGIES CO., LTD
www.unisonic.com.tw
2 of 4
QW-R502-981.a
FC8779

Preliminary
CMOS IC
ABSOLUTE MAXIMUM RATING
PARAMETER
SYMBOL
RATINGS
UNIT
Supply Voltage
VCC
7
V
Power Dissipation (Note 2)
PD
585
mW
Output Current (Note 3)
IOMAX
1000
mA
FG Signal Output
IFG
5
mA
FG Signal Output Voltage
VFG
7
V
Operating Temperature
TOPR
-40~+105
°C
Storage Temperature
TSTG
-55~+150
°C
Junction Temperature
TJMAX
150
°C
Notes: 1. Absolute maximum ratings are those values beyond which the device could be permanently damaged.
Absolute maximum ratings are stress ratings only and functional device operation is not implied.
2. To use at temperature above TA=25°C reduce 4.68mW/°C (On 70.00mm×1.6mm glass epoxy board).
3. This value is mot to be over Pd, VCC=4.0V~6.0V At VCC=2.2V~4.0V, output current tolerance reduces.

OPERATING CONDITIONS
PARAMETER
SYMBOL
RATINGS
Operating Supply Voltage Range
VCC
2.2~6.0
Hall Input Voltage Range
VH
0.4~VCC-1.1
Notes: 1. This product is not designed for production against radioactive rays.
2. This document may be strategic data subject to COCOM regulations.

UNIT
V
V
ELECTRICAL CHARACTERISTICS (Unless otherwise specified TA=25°C, VCC=5V)
PARAMETER
Supply Current
Input Offset Voltage
Output Voltage
Input-Output Gain
FG Low Voltage
Input Hysteresis Voltage
Lock detection ON Time
Lock Detection OFF Time
Hall Bias Voltage
SYMBOL
ICC
VHOFS
VO
GIO
VFGL
VHYS
TON
TOFF
VHB
TEST CONDITIONS
IO=250mA upper and lower total
TYP
5
45
0.32
48
±5
0.35
3.5
1.1
±10
0.50
5.0
1.3
IFG=3mA
IHB=-5mA
UNISONIC TECHNOLOGIES CO., LTD
www.unisonic.com.tw
MIN
MAX
8
±6
0.49
51
0.3
±15
0.65
6.5
1.5
UNIT
mA
mV
V
dB
V
mV
sec
sec
V
3 of 4
QW-R502-981.a
FC8779

Preliminary
CMOS IC
TYPICAL APPLICATION CIRCUIT
UTC assumes no responsibility for equipment failures that result from using products at values that
exceed, even momentarily, rated values (such as maximum ratings, operating condition ranges, or
other parameters) listed in products specifications of any and all UTC products described or contained
herein. UTC products are not designed for use in life support appliances, devices or systems where
malfunction of these products can be reasonably expected to result in personal injury. Reproduction in
whole or in part is prohibited without the prior written consent of the copyright owner. The information
presented in this document does not form part of any quotation or contract, is believed to be accurate
and reliable and may be changed without notice.
UNISONIC TECHNOLOGIES CO., LTD
www.unisonic.com.tw
4 of 4
QW-R502-981.a