Mini-Com Binding Post Module Part Numbers: CMBPR**Y, CMBPB**Y INSTALLATION INSTRUCTIONS © Panduit Corp. 2014 PN334B Rear Ring CMBPR**Y, CMBPB**Y (R = Red colored ring) (B = Black colored ring) Front Installation Options for Front of Module Speaker wire C C A D D Option 1 Option 3 Option 2 A. Strip off about 1/2" to 3/4" of outer jacket from the speaker wire. Twist conductor strands together. A. Strip off about 1/2" to 3/4" of outer jacket from the speaker wire. Twist conductor A. Insert banana plug straight into the shaft on the front side of module. strands together. B. Remove termination cap from front side of module by rotating counter-clockwise. C. Insert the exposed portion of the speaker wire into the side hole in the binding post shaft. D. Re-install termination cap by rotating clock-wise until wire is secure. B. Remove termination cap from front side of module by rotating counter-clockwise. C. Curve exposed wire slightly. Wrap wire around the shaft. D. Re-install termination cap by rotating clock-wise until wire is secure. Installation Options for Rear of Module A A D C B Option 2 Option 1 A. Remove set screw from rear shaft. B. Strip off about 1/2" to 3/4" of outer jacket from the speaker wire. Twist conductor strands together. A. Remove set screw from rear shaft. B. Insert banana plug straight into the shaft on the rear side of module. C. Discard set screw. E-mail: [email protected] For Instructions in Local Languages and Technical Support: www.panduit.com/resources/install_maintain.asp C. Insert exposed wires into shaft on the rear side of module. D. Replace screw and tighten until wire is secure. www.panduit.com Page 1 of 1 Phone: 866-405-6654