NET-ACCESS N-Type and S-Type Cabinets (SN2RC, SN5RC, SN8RC, SN1RC Adjustable Cage Nut Equipment Rails) INSTRUCTIONS CM667A © Panduit Corp. 2013, 2014 Equipment Rail Installation • • Install [4] Equipment Rail Mounting Brackets to Equipment Rails with [3] Counter-sunk Torx screws per bracket (use T25 Torx bit) Ensure that counter-sinks of brackets are oriented to match heads of counter-sunk screws Equipment Rail Mounting Bracket Ensure that counter-sinks of bracket match screw [3] Counter-sunk Torx Screws (use T25 Torx bit) FOR TECHNICAL SUPPORT www.panduit.com/resources/install_maintain.asp Page 1 of 2 INSTRUCTIONS CM667A Equipment Rail Installation • • • • Locate desired Equipment Rail position Insert [2] Equipment Rail Mount Nuts through slots of Front-to-Back Beam (top and bottom locations) Fasten [2] M10 Hex Screws to E-Rail Mount Nuts at top and bottom of Equipment Rail Tighten M10 Hex Head Screw to 30.0 +/- 5.0 N-m [22.1 +/- 3.7 Ft-lbs] M10 Hex Head Screw (use 15mm socket wrench) Equipment Rail Mount Nut (Finger Grip Area) Barbed Surface (face to outside of cabinet) INSTALL EQUIPMENT RAILS Equipment Rail Mount Nut M10 Hex Head Screw (use 15mm socket wrench) Slot of Front-to-Back Beam M10 Hex Head Screw (use 15mm socket wrench) For Instructions in Local Languages and Technical Support: www.panduit.com/resources/install_maintain.asp www.panduit.com Page 2 of 2 E-mail: [email protected] Phone: 866-405-6654