NET-ACCESS N-Type Network Cabinets (Split/Hinged Side Panels - N21SPH, N22SPH, N51SPH, N52SPH) INSTRUCTIONS CM606 © Panduit Corp. 2012 Split/Hinged Side Panels Installation • • • VIEW 3 Secure Bottom Support Bracket to cabinet frame with [3] M5 Torx Screws VIEW 1, 2 Secure Vertical Support Bracket to cabinet frame and bottom support bracket with [1] M5 Torx Screw and [2] Hex Nuts See Page 2 for Side Panel Installation Instructions VIEW 1 Vertical Support Bracket (Top) [2] Hex Nuts (use 6mm Socket Wrench) [1] M5 Torx Screw (use T25 Torx bit) VIEW 2 Vertical Support Bracket (Bottom) [3] M5 Torx Screws (use T25 Torx bit) VIEW 3 Bottom Support Bracket (Part of bracket cut away to show detail) FOR TECHNICAL SUPPORT www.panduit.com/resources/install_maintain.asp Page 1 of 2 INSTRUCTIONS CM606 Split/Hinged Side Panels Installation • • • • Open Side Panel to approximately 90º VIEW 1 Lift Top Hinge Point of Side Panel onto top pin of Vertical Support Bracket VIEW 2 Lower Bottom Hinge Point of Side Panel onto bottom pin of Vertical Support Bracket VIEW 3 Close Side Panel and secure top and bottom of Side Panel to cabinet frame with [2] Spring Loaded Hinge Pins VIEW 1 VIEW 3 Lift Top Hinge Point of Side Panel onto Top Pin of Vertical Support Bracket Spring Loaded Hinge Pin (Top and Bottom) Hold Hinge Pin Open VIEW 2 Lower Bottom Hinge Point of Side Panel onto Bottom Pin of Vertical Support Bracket For Instructions in Local Languages and Technical Support: www.panduit.com/resources/install_maintain.asp www.panduit.com Page 2 of 2 E-mail: [email protected] Phone: 866-405-6654