NET-ACCESS N-Type Switch Cabinets (Single Hinge Door Installation) INSTRUCTIONS V00029BL © Panduit Corp. 2012-2013 Single Hinge Door (Removal and Installation) • • • • VIEW 1 Pull down Compression Sleeve at top door hinge VIEW 1 Pull Single Hinge Door away from cabinet so that Top Hinge Screw fits through cutout of door VIEW 2 Lift bottom of door off Bottom Hinge Pin REVERSE STEPS to install Single Hinge Door Top Hinge Screw Compression Sleeve (Pull down) VIEW 1 VIEW 3 VIEW 2 Bottom Hinge Pin FOR TECHNICAL SUPPORT www.panduit.com/resources/install_maintain.asp Page 1 of 2 INSTRUCTIONS V00029BL Single Hinge Door (Door Handle Direction Reversal) • • VIEW 1, 2 Remove Top and Bottom Hinge Brackets from current location (remove top hinge screw, if necessary) VIEW 1, 2 Install Top and Bottom Hinge Brackets on opposite side of cabinet (re-install top hinge screw, if necessary) Door Handle Reversal (Lay door on a flat surface) - VIEW 3, 4 • Remove [2] E-clips from Door Handle Cam and exchange positions of Top and Bottom Door Rods • Remove Door Handle Backing Plate and rotate position of Door Handle 180º • With Door Handle repositioned, secure Door Handle Backing Plate to Door Handle • Attach Top and Bottom Door Rods to Door Handle Cam with [2] E-clips (ensure that door rods are behind door rod guides) • Remove PANDUIT label and re-attach in correct orientation near top of door • Reinstall Single Hinge Door per instructions on Page 1 VIEW 1 VIEW 2 [2] M4 Screws (use 2.5mm Allen Key) Top Hinge Bracket M6 Torx Screw (use T30 Torx bit) [2] Hex Nuts (use 8mm socket wrench) Bottom Hinge Bracket [2] E-Clips Door Rod Door Handle Backing Plate Door Rod Guide Door Handle (rotate 180º) PANDUIT Label Door Rods (exchange positions) Door Rod Guide For Instructions in Local Languages and Technical Support: www.panduit.com/resources/install_maintain.asp www.panduit.com Page 2 of 2 VIEW 4 VIEW 3 E-mail: [email protected] Phone: 866-405-6654