UNISONIC TECHNOLOGIES CO., LTD U74LVC2G125 CMOS IC DUAL BUS BUFFER GATE WITH 3-STATE OUTPUTS DESCRIPTION The U74LVC2G125 consists of two bus buffers with 3-state output controlled by enable input (n OE ), when n OE is high, the output is disable. Inputs can be driven from either 3.3V or 5V devices, so the device can be used in a mix 3.3V/5V system. This device is full specified for partial power-down protective circuit, preventing the backflow current through the device when it is powered down. FEATURES * Operation Voltage Range: 1.65~5.5V * Low Power Dissipation * Input Accept Voltage to 5.5V ORDERING INFORMATION Ordering Number U74LVC2G125G-P08-R U74LVC2G125G-SM1-R Package TSSOP-8 MSOP-8 Packing Tape Reel Tape Reel MARKING MSOP-8 www.unisonic.com.tw Copyright © 2016 Unisonic Technologies Co., Ltd TSSOP-8 1 of 5 QW-R502-136.D U74LVC2G125 CMOS IC PIN CONFIGURATION 1OE 1 VCC 1A 2 7 2OE 2Y 3 6 1Y GND 4 5 2A FUNCTION TABLE (each gate) INPUT 8 OUTPUT n OE A Y L L H L H X L H Z LOGIC DIAGRAM (positive logic) UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 2 of 5 QW-R502-136.D U74LVC2G125 CMOS IC ABSOLUTE MAXIMUM RATING (unless otherwise specified)(Note 1) PARAMETER SYMBOL RATINGS UNIT VCC -0.5~6.5 V VIN -0.5~6.5 V Enable mode VOUT -0.5~VCC+0.5 V Output Voltage Disable mode VOUT -0.5~6.5 V Power-down mode VOUT -0.5~6.5 V Input Clamp Current (ViN<0) IIK -50 mA Output Clamp Current (VOUT<0) IOK -50 mA Output Current IOUT ±50 mA VCC or GND Current ICC ±100 mA Power Dissipation PD 500 mW Storage Temperature TSTG -65 ~ +150 °C Note 1. The input and output voltage ratings may be exceeded if the input and output current ratings are observed. 2. Absolute maximum ratings are those values beyond which the device could be permanently damaged. Absolute maximum ratings are stress ratings only and functional device operation is not implied. Supply Voltage Input Voltage RECOMMENDED OPERATING CONDITIONS PARAMETER Supply Voltage Input Voltage Output Voltage Input Transition Rise or Fall Rate Operating Temperature SYMBOL TEST CONDITIONS VCC Operating VIN VCC=1.65V~5.5V; Enable mode VOUT VCC=1.65V~5.5V; Disable mode VCC=0V; Power-down mode VCC=1.65~2.7V tR, tF VCC=2.7~5.5V TA MIN 1.65 0 0 0 0 0 0 -40 TYP MAX 5.5 5.5 VCC 5.5 5.5 20 10 85 UNIT V V V V V ns/V ns/V °C MIN TYP MAX UNIT V V V V V V V V V V V V V V V V V V V V STATIC CHARACTERISTICS (TA=25°C) PARAMETER High-Level Input Voltage Low-Level Input Voltage High-Level Output Voltage Low-Level Output Voltage SYMBOL VIH VIL VOH VOL TEST CONDITIONS VCC = 1.65V ~ 1.95V VCC = 2.3V ~ 2.7V VCC = 2.7V ~ 3.6V VCC = 4.5V ~ 5.5V VCC = 1.65V~1.95V VCC = 2.3V ~ 2.7V VCC = 2.7V ~ 3.6V VCC = 4.5V ~5.5V VCC = 1.65V ~ 5.5V, IOH=-100μA VCC = 1.65V, IOH=-4mA VCC = 2.3V, IOH=-8mA VCC = 2.7V, IOH=-12mA VCC = 3V, IOH=-24mA VCC = 4.5V, IOH=-32mA VCC = 1.65V ~ 5.5V, IOL=100μA VCC = 1.65V, IOL=4mA VCC = 2.3V, IOL=8mA VCC = 2.7V, IOL=12mA VCC = 3V, IOL=24mA VCC = 4.5V, IOL=32mA UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 0.65×VCC 1.7 2 0.7×VCC 0.35×VCC 0.7 0.8 0.3×VCC VCC－0.1 1.2 1.9 2.2 2.3 3.8 0.1 0.45 0.3 0.4 0.55 0.55 3 of 5 QW-R502-136.D U74LVC2G125 STATIC CHARACTERISTICS (Cont.) PARAMETER Input Leakage Current Output OFF-State Current Power OFF Leakage Current Quiescent Supply Current Additional Quiescent Supply Current Input Capacitance CMOS IC SYMBOL II(LEAK) IOZ IOFF(LEAK) IQ IQ CIN MIN TYP ±0.1 ±0.1 ±0.1 0.1 MAX ±5 ±10 ±10 10 UNIT μA μA μA μA 5 500 μA 2 pF DYNAMIC CHARACTERISTICS (TA=25℃) PARAMETER SYMBOL Propagation Delay From Input (A) to Output(Y) tPLH/tPHL Propagation Delay From Input (n ΟΕ ) to Output(Y) tPZL/tPZH Propagation Delay From Input (n ΟΕ ) to Output(Y) tPLZ/tPHZ TEST CONDITIONS VCC= 5.5V, VIN=5.5V or GND VCC= 3.6V, VOUT=VCC or GND VCC= 0V, VIN or VOUT =5.5V VCC= 5.5V, VIN=VCC or GND, IOUT=0 VCC= 2.3V ~ 5.5V, One input at VCC-0.6V, other inputs at VCC or GND VIN=VCC or GND TEST CONDITIONS VCC =1.8V±0.15 VCC =2.5V±0.2 VCC =2.7V VCC =3.3V±0.3 VCC =5V±0.5 VCC =1.8V±0.15 VCC =2.5V±0.2 VCC =2.7V VCC =3.3V±0.3 VCC =5V±0.5 VCC =1.8V±0.15 VCC =2.5V±0.2 VCC =2.7V VCC =3.3V±0.3 VCC =5V±0.5 MIN 1 0.5 1 0.5 0.5 1.5 1 1.5 0.5 0.5 1 0.5 1 1 0.5 TYP 3.7 2.5 2.7 2.3 1.9 4.3 2.8 3.3 2.4 2 3.5 1.8 2.7 2.7 1.8 MAX 9.1 4.8 4.8 4.3 3.7 9.9 5.6 5.7 4.7 3.8 11.6 5.8 4.8 4.6 3.4 UNIT MIN TYP 18 5 MAX UNIT ns ns ns OPERATING CHARACTERISTICS PARAMETER Power Dissipation Capacitance SYMBOL Cpd TEST CONDITIONS Output Enable, f=10MHz Output Disable, f=10MHz UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw pF 4 of 5 QW-R502-136.D U74LVC2G125 CMOS IC TEST CIRCUIT AND WAVEFORMS Note: CL includes probe and jig capacitance. VCC 1.8V±0.15V 2.5V±0.2V 2.7V 3.3V±0.3V 5V±0.5V VIN VCC VCC 2.7V 2.7 V VCC tR, tF ≤2ns ≤2ns ≤2.5ns ≤2.5ns ≤2.5ns VM VCC/2 VCC/2 1.5V 1.5V VCC/2 VEXT 2×VCC 2×VCC 6V 6V 2×VCC CL 30pF 30pF 50pF 50pF 50pF RL 1KΩ 500Ω 500Ω 500Ω 500Ω V△ 0.15V 0.15V 0.3V 0.3V 0.3V UTC assumes no responsibility for equipment failures that result from using products at values that exceed, even momentarily, rated values (such as maximum ratings, operating condition ranges, or other parameters) listed in products specifications of any and all UTC products described or contained herein. UTC products are not designed for use in life support appliances, devices or systems where malfunction of these products can be reasonably expected to result in personal injury. Reproduction in whole or in part is prohibited without the prior written consent of the copyright owner. The information presented in this document does not form part of any quotation or contract, is believed to be accurate and reliable and may be changed without notice. UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 5 of 5 QW-R502-136.D