Datasheet

UNISONIC TECHNOLOGIES CO., LTD
UG5J
NPN SILICON TRANSISTOR
NPN DIGITAL TRANSISTOR
(BUILT- IN BIAS RESISTORS)
„
FEATURES
* Two DTC114Y chips in a SOT-353 package.
* Mounting cost and area can be reduced in half.
„
STRUCTURE
* Epitaxial planar type
* NPN silicon transistor
(Built-in resistor type)
* Halogen Free
„
„
ORDERING INFORMATION
Ordering Number
Package
UG5JG-AL5-R
SOT-353
1
I1
Pin Assignment
2
3
4
G1,G2
I2
O2
5
O1
Packing
Tape Reel
MARKING INFORMATION
5
4
UG5J
1
2
3
www.unisonic.com.tw
Copyright © 2010 Unisonic Technologies Co., Ltd
1 of 3
QW-R222-004,A
UG5J
„
NPN SILICON TRANSISTOR
ABSOLUTE MAXIMUM RATING (Ta=25℃)
PARAMETER
Supply Voltage
RATINGS
UNIT
50
V
40
Input Voltage
VIN
V
-6
IOUT
70
mA
Output Current
100
IC(MAX)
Total Power Dissipation
PD
150 (Note 2)
mW
Junction Temperature
TJ
+150
℃
Storage Temperature
TSTG
-50 ~ +150
℃
Notes : 1. Absolute maximum ratings are those values beyond which the device could be permanently damaged.
Absolute maximum ratings are stress ratings only and functional device operation is not implied.
2. 120mW per element must not be exceeded.
„
SYMBOL
VCC
ELECTRICAL CHARACTERISTICS (Ta=25℃)
PARAMETER
SYMBOL
VI(OFF)
Input Voltage
VI(ON)
Output Voltage
VO(ON)
Input Current
II
Output Current
IO(OFF)
DC Current Gain
GI
Transition Frequency
fT
Input Resistance
R1
Resistance Ratio
R2/R1
Note: 1.Transition frequency of the device.
„
TEST CONDITIONS
VCC=5V, IO=100µA
VO=0.3V, IO=1mA
IO=5mA, II=0.25mA
VI=5V
VCC=50V, VI=0V
VO=5V, IO=5mA
VCE=10V, IE=-5mA, f=100MHz (Note 1)
MIN
1.4
TYP MAX UNIT
0.3
V
0.1
0.3
0.88
0.5
V
mA
µA
68
7
3.7
250
10
4.7
13
5.7
MHz
KΩ
EQUIVALENT CIRCUIT (The following characteristic apply to both DTr1 and DTr2)
UNISONIC TECHNOLOGIES CO., LTD
www.unisonic.com.tw
2 of 3
QW-R222-004,A
UG5J
TYPICAL CHARACTERISTICS
Collector Current vs. CollectorEmitter Voltage
6
Collector Current, IC (mA)
„
NPN SILICON TRANSISTOR
IB=34.6µA
5
4
IB=29.6µA
3
IB=24.6µA
2
1
IB=19.6µA
0
0
1 2 3 4 5 6 7 8 9
Collector-Emitter Voltage, VCE(V)
UTC assumes no responsibility for equipment failures that result from using products at values that
exceed, even momentarily, rated values (such as maximum ratings, operating condition ranges, or
other parameters) listed in products specifications of any and all UTC products described or contained
herein. UTC products are not designed for use in life support appliances, devices or systems where
malfunction of these products can be reasonably expected to result in personal injury. Reproduction in
whole or in part is prohibited without the prior written consent of the copyright owner. The information
presented in this document does not form part of any quotation or contract, is believed to be accurate
and reliable and may be changed without notice.
UNISONIC TECHNOLOGIES CO., LTD
www.unisonic.com.tw
3 of 3
QW-R222-004,A