3.0mmx1.0 mm RIGHT ANGLE SMD CHIP LED LAMP P/N: KPA-3010SGC Features SUPER BRIGHT GREEN Description 3.0mmx1.0mm RIGHT ANGLE SMT LED, 2.0mm THICKNESS. The Super Bright Green source color devices are made with Gallium Phosphide Green Light Emitting Diode. LOW POWER CONSUMPTION. WIDE VIEWING ANGLE. IDEAL FOR BACK LIGHT AND INDICATOR. VARIOUS COLORS AND LENS TYPES AVAILABLE. PACKAGE : 2000PCS / REEL. RoHS COMPLIANT. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is ±0.15(0.006") unless otherwise noted. 3. Specifications are subject to change without notice. SPEC NO: DSAA0926 REV NO: V.14 DATE: NOV/12/2005 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: Y.L.LI PAGE: 1 OF 4 Selection Guide Part No. Dice KPA-3010SGC Iv (mcd) @ 20mA Lens Type SUPER BRIGHT GREEN (GaP) WATER CLEAR Viewing Angle Min. Typ. 2θ θ1/2 4 15 120° Note: 1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. Electrical / Optical Characteristics at TA=25°C Symbol Parameter Device Typ. λpeak Peak Wavelength Super Bright Green λD Dominant Wavelength ∆λ1/2 Max. Units Test Conditions 565 nm IF=20mA Super Bright Green 568 nm IF=20mA Spectral Line Half-width Super Bright Green 30 nm IF=20mA C Capacitance Super Bright Green 15 pF VF=0V;f=1MHz VF Forward Voltage Super Bright Green 2.2 2.5 V IF=20mA IR Reverse Current Super Bright Green 10 uA VR = 5V Absolute Maximum Ratings at TA=25°C Parameter Super Bright Green Units Power dissipation 105 mW DC Forward Current 25 mA Peak Forward Current [1] 140 mA 5 V Reverse Voltage Operating/Storage Temperature -40°C To +85°C Note: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. SPEC NO: DSAA0926 REV NO: V.14 DATE: NOV/12/2005 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: Y.L.LI PAGE: 2 OF 4 Super Bright Green KPA-3010SGC SPEC NO: DSAA0926 REV NO: V.14 DATE: NOV/12/2005 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: Y.L.LI PAGE: 3 OF 4 KPA-3010SGC Recommended Soldering Pattern (Units : mm) Tape Specifications (Units : mm) Remarks: If special sorting is required (e.g. binning based on forward voltage, Luminous intensity/ luminous flux, or wavelength), the typical accuracy of the sorting process is as follows: 1. Wavelength: +/-1nm 2. Luminous intensity/ Luminous Flux: +/-15% 3. Forward Voltage: +/-0.1V Note: Accuracy may depend on the sorting parameters. SPEC NO: DSAA0926 REV NO: V.14 DATE: NOV/12/2005 APPROVED: J. Lu CHECKED: Allen Liu DRAWN: Y.L.LI PAGE: 4 OF 4