Series 55 Universal Zero-Insertion-Force DIP Test Socket FEATURES • Accepts Devices on 0.300 to 0.600 [7.62 to 15.24] Centers • All Pin Count Sockets go into PCB with either 0.300 or 0.600 [7.62 or 15.24] Centers • Contacts Normally-closed to Eliminate Dependence on Plastic to Sustain Contact Integrity • Socket Handle Configured with Closed Contacts (on) when in the Up or Down Position, and Mounted on the Right- or Left-hand Side • Sockets may be Soldered into PCBs or Plugged into Any Socket or Receptacle GENERAL SPECIFICATIONS • SOCKET BODY: Black UL 94V-0 glass-filled Polyphenylene Sulfide (PPS) • HANDLE: Stainless Steel • HANDLE KNOB: Brass 360, 1/2-hard • CONTACTS: BeCu 172 per QQ-C-533 –OR– Spinodal Alloy • CONTACT PLATING: 50μ [1.27μ] min. Ni under-plate per QQ-N-290, over-plated with either 200μ [5.08μ] min. matte Sn per ASTM B545-97 –OR– 50μ [1.27μm] NiB • CONTACT CURRENT RATING: 1 amp • INSULATION RESISTANCE: 1000 MΩ min. • DIELECTRIC WITHSTANDING VOLTAGE: 1000 VAC • LIFE CYCLE: 25,000 to 50,000 cycles • OPERATING TEMPERATURE: 221°F [105°C] Sn plating; 302°F [150°C] Au plating; 392°F [200°C] NiB plating • RETENTION FORCE (closed): 55g/pin based on a 0.020 [0.51] dia. test lead • ACCEPTS LEADS: 0.015-0.045 [0.38-1.14] wide, 0.110-0.280 [2.79-7.11] long MOUNTING CONSIDERATIONS ORDERING INFORMATION XX-X55X-X X Plating 0 = Sn over Ni 0TL = Sn/Pb over Ni 1 = Au over Ni 6 = NiB (Spinodal only) Termination 1 = Solder Pin Tail Handle Options 1 = Left up is closed 2 = Right up is closed 3 = Left down is closed 4 = Right down is closed (std) Row-to-Row Spacing (btm) 3 = 0.300 [7.62] 6 = 0.600 [15.24] • See Socket Footprint No. of Pins 24, 28, 32, 36, 40, 42, 44, 48 ALL DIMENSIONS: INCHES [MILLIMETERS] ALL TOLERANCES: ±0.005 [0.13] UNLESS OTHERWISE SPECIFIED FOR TEST SOCKET RECEPTACLES, SEE DATA SHEET 10003 DO NOT USE THIS SOCKET IN A BURN-IN OVEN WITH CONTACTS IN OPEN POSITION, AS IT WILL DAMAGE THE SOCKET CONSULT FACTORY FOR OTHER SIZES AND CONFIGURATIONS CUSTOMIZATION: ARIES SPECIALIZES IN CUSTOM DESIGN AND PRODUCTION. SPECIAL MATERIALS, PLATINGS, SIZES, AND CONFIGURATIONS CAN BE FURNISHED, DEPENDING ON QUANTITY. ARIES RESERVES THE RIGHT TO CHANGE PRODUCT GENERAL SPECIFICATIONS WITHOUT NOTICE PRINTOUTS OF THIS DOCUMENT MAY BE OUT-OF-DATE AND SHOULD BE CONSIDERED UNCONTROLLED 2609 Bartram Road • Bristol, PA 19007-6810 USA TEL 215-781-9956 • FAX 215-781-9845 WWW.ARIESELEC.COM • [email protected] 10001 Rev. 1.7 1 of 1