DATA SHEET Part No. MN103S5405YD Package Code No. FLGA324-C1515 SEMICONDUCTOR COMPANY MATSUSHITA ELECTRIC INDUSTRIAL CO., LTD. Publication date: December 2004 SDB00103AEM 1 MN103S5405YD MN103S5405YD Chip-set for Digital Still Camera Overview Key devices required for a digital still camera are integrated into this chip set. We can accommodate marketing needs by providing a total solution, which includes M-pixels CCD image sensor, high picture quality and high efficiency single processing LSI, power supply, audio playback, and LCD. Features • High picture quality CCD provides high sensitivity and broad dynamic range by a new structure. • 8-ch. Vertical Driver IC: Suitable for high pixel size frame readout CCD • Front End IC includes 10/ 12-bit AD converter, Liner Gain Control Amp • High-performance Image Processing DSP, with moving/still • 7-ch. DC-DC control IC • LCD I/F for adjustment with Bus Control • Low voltage operation audio processing IC Applications • Digital Still Cameras, OA, FA Cameras System Block Diagram 5.3M-pixel system 5.3M pixels CCD V driver AN20101A 64M-bit SDRAM CDS, AGC 10/12-bit ADC AN12012A /AN12011A CCD process DSP MN103S5405YD Memory control JPEG Timing Gen. AN12XXX ENC Analog RGB YC process LCD Panel Memory Card I/F SD or CF card USB Core Audio DSP SDB00103AEM LCD I/F AN2526FH DAC 32-bit micro Computer Core 7-ch. DC-DC AN30210A Video output DAC USB I/F Audio DAC AN2905FHQ/ AN2906FJM 2 Request for your special attention and precautions in using the technical information and semiconductors described in this material (1) An export permit needs to be obtained from the competent authorities of the Japanese Government if any of the products or technical information described in this material and controlled under the "Foreign Exchange and Foreign Trade Law" is to be exported or taken out of Japan. (2) The technical information described in this material is limited to showing representative characteristics and applied circuits examples of the products. It neither warrants non-infringement of intellectual property right or any other rights owned by our company or a third party, nor grants any license. (3) We are not liable for the infringement of rights owned by a third party arising out of the use of the technical information as described in this material. (4) The products described in this material are intended to be used for standard applications or general electronic equipment (such as office equipment, communications equipment, measuring instruments and household appliances). Consult our sales staff in advance for information on the following applications: • Special applications (such as for airplanes, aerospace, automobiles, traffic control equipment, combustion equipment, life support systems and safety devices) in which exceptional quality and reliability are required, or if the failure or malfunction of the products may directly jeopardize life or harm the human body. • Any applications other than the standard applications intended. (5) The products and product specifications described in this material are subject to change without notice for modification and/or improvement. At the final stage of your design, purchasing, or use of the products, therefore, ask for the most up-to-date Product Standards in advance to make sure that the latest specifications satisfy your requirements. (6) When designing your equipment, comply with the guaranteed values, in particular those of maximum rating, the range of operating power supply voltage, and heat radiation characteristics. Otherwise, we will not be liable for any defect which may arise later in your equipment. Even when the products are used within the guaranteed values, take into the consideration of incidence of break down and failure mode, possible to occur to semiconductor products. Measures on the systems such as redundant design, arresting the spread of fire or preventing glitch are recommended in order to prevent physical injury, fire, social damages, for example, by using the products. (7) When using products for which damp-proof packing is required, observe the conditions (including shelf life and amount of time let standing of unsealed items) agreed upon when specification sheets are individually exchanged. (8) This material may be not reprinted or reproduced whether wholly or partially, without the prior written permission of Matsushita Electric Industrial Co., Ltd. 2003 SEP