PRODUCT DATASHEET 1-800-383-7323 USA/CAN www.energizer.com ENERGIZER NH12-850 AAA Specifications Classification: Chemical System: Designation: Nominal Voltage: Rated Capacity: Typical Weight: Typical Volume: Terminals: Jacket: Industry Standard Dimensions mm (inches) Rechargeable Nickel-Metal Hydride (NiMH) ANSI-1.2H1 1.2 Volts 850 mAh* at 21°C (70°F) 13.0 grams (0.5 oz.) 3.8 cubic centimeters (0.2 cubic inch) Flat Contact Plastic * Based on 170 mA (0.2C rate) continuous discharge to 1.0 volts. 10.50 (0.413) 9.50 (0.374) 0.80 (0.031) Minimum 3.80 (0.150) Maximum Internal Resistance: The internal resistance of the cell varies with state of charge, as follows: Cell Charged Cell 1/2 Discharged 100 milliohms 120 milliohms (tolerance of ±20% applies to above values) 44.50 (1.752) 43.30 (1.705) AC Impedance (no load): 4.30 (0.169) Minimum The impedance of the charged cell varies with frequency, as follows: Discharge Characteristics Frequency (Hz) Typical Performance at 21ºC (70ºF) 1.4 1000 Cell Voltage 1.3 85 mA (0.1C) 1.2 Above values based on AC current set at 1.0 ampere. Value tolerances are ±20%. 170 mA (0.2C) 1.1 1.0 0.9 0 3 6 Hours of Discharge 9 12 1.3 1.2 1.1 Charge: Discharge: Storage: Humidity: 425 mA (0.5C) 850 mA (1.0C) 1700 mA (2.0C) 1.0 0.5 0ºC to 40ºC (32ºF to 104ºF) 0ºC to 50ºC (32ºF to 122ºF) -20ºC to 30ºC (-4ºF to 86ºF) 65±20% NOTE: Operating at extreme temperatures, will significantly impact battery cycle life. 0.9 0.0 Operating and Storage Temperatures: To maintain maximum performance, observe the following general guidelines regarding environmental conditions: 1.4 Cell Voltage Impedance (milliohms) (charged cell) 35 1.0 1.5 2.0 2.5 Hours of Discharge Important Notice This data sheet contains typical information specific to products manufactured at the time of its publication. ©Energizer Holdings, Inc. - Contents herein do not constitute a warranty. Form No. EBC - 7101O Page 1 of 1