227 KB

The following document contains information on Cypress products.
FUJITSU SEMICONDUCTOR
FACT SHEET
NP706-00013-1v0-E
32-bit Microcontrollers
FM3 Family MB9B410T Series
MB9B410T series are highly integrated 32-bit microcontrollers dedicated for embedded controllers with high-performance
and competitive cost. MB9B410T series are based on the ARM Cortex-M3 Processor with Flash memory and SRAM, and has
peripheral functions such as Motor Control timers, ADCs and Communication interfaces.
■ FEATURES
 32bit ARM Cortex-M3 Core
■PRODUCT LINEUP
Part number
MB9BF416S/T
MB9BF417S/T
MB9BF418S/T
Flash
(Byte)
512K
768K
1M
RAM
(Byte)
64K
96K
128K
Processor version:r2p1
Parameter
 Clock
Maximum clock frequency:144MHz
 Base Timer:16 channels(Max.)
 Multi-function Timer:3 units(Max.)





16-bit free-run timer ×3channels/unit
Input capture ×4channels/unit
Output compare ×6channels/unit
A/D activating compare ×3channels/unit
Waveform generator ×3channels/unit
16-bit PPG timer ×3channels/unit
QPRC:3 channels(Max.)
Dual Timer:1 unit
Watch dog Timer:1 channel(SW) + 1 channel(HW)
CAN:2 channels(Max.)
Multi-function Serial Interface:8 channels(Max.)
Selectable from UART/CSIO/LIN/I2C
 External Bus Interface
 DMA Controller:8 channels
 External Interrupt Controller Unit
- Up to 32 external vectors
- Include one non-maskable interrupt(NMI)
■ORDERING INFORMATION
Part number
MB9BF416SPMC
MB9BF417SPMC
MB9BF418SPMC
MB9BF416TPMC
MB9BF417TPMC
MB9BF418TPMC
MB9BF416TBGL
MB9BF417TBGL
MB9BF418TBGL
Package
Plastic・LQFP(0.5mm pitch),144-pin
(FPT-144P-M08)
Plastic・LQFP(0.5mm pitch),176-pin
(FPT-176P-M07)
Plastic・PFBGA(0.8mm pitch),192-pin
(BGA-192P-M06)
■PACKAGE EXAMPLE OF REFERENCE
 12-bit A/D Converter:
MB9BF416S/417S/418S:24 channels(3 units)
MB9BF416T/417T/418T:32 channels(3 units)
 Low Power Mode
Sleep mode/Timer mode/Stop mode supported
 General Purpose I/O port
MB9BF416S/417S/418S:122(Max.)
MB9BF416T/417T/418T:154(Max.)
 Debug
Plastic ・ LQFP, 176-pins
(FPT-176P-M07)
-Serial Wire JTAG Debug Port (SWJ-DP)
-Embedded Trace Macrocells (ETM)
 Low Voltage Detector
 Clock Super Visor
 Power Supply:2.7V to 5.5V
ARM and Cortex are trademarks of ARM Limited in the EU and other countries.
April 2012
1/2
Copyright©2011-2012 FUJITSU SEMICONDUCTOR LIMITED All rights reserved
MB9B410T Series
■ BLOCK DIAGRAM
MB9BF416/417/418
TRSTX,TCK,
TDI,TMS
TDO
SWJ-DP
ETM
TPIU
ROM
Table
TRACED[3:0],
TRACECLK
SRAM0
32/48/64Kbyte
MPU NVIC
Multi-layer AHB (Max.144MHz)
Cortex-M3 Core I
144MHz(Max.)
D
Sys
AHB-APB Bridge:
APB0(Max.72MHz)
Dual-Timer
WatchDog Timer
(Software)
Clock Reset
Generator
INITX
WatchDog Timer
(Hardware)
Flash I/F
Security
On-chip Flash
512Kbyte/
768Kbyte/
1024Kbyte
Trace Buffer
(16Kbyte)
SRAM1
32/48/64Kbyte
CSV
Main
Osc
Sub.
Osc
X0
X1
X0A
X1A
AVCC,
AVSS,AVRH
AHB-AHB Bridge
(Slave)
RST
CLK
PLL
CR
4MHz
CR
100KHz
A/D Converter x3
DMAC
8ch
CAN
TX0,
RX0
CAN
TX1,
RX1
12bit A/D Converter
AN[31:00]
MAD[24:00]
External Bus IF
12bit A/D Converter
ADTG[8:0]
MADATA[15:00]
MCSX[7:0],
MOEX,MWEX,
MNALE,
MNCLE,
MNWEX,
MNREX,
MDQM[1:0]
12bit A/D Converter
CAN Prescaler
Base Timer
16-bit 16ch/
32-bit 8ch
AIN[2:0]
QPRC
3ch
BIN[2:0]
ZIN[2:0]
A/D Activation
Compare
3ch
IC0[3:0]
IC1[3:0]
IC2[3:0]
16-bit Input Capture
4ch
FRCK[2:0]
16-bit Free-run Timer
3ch
IRQ-Monitor
AHB-APB Bridge : APB2 ( Max.72MHz)
TIOB[15:00]
AHB-APB Bridge : APB1 (Max.72MHz)
TIOA[15:00]
LVD Ctrl
LVD
CRC
Accelerator
Regulator
C
Watch Counter
External Interrupt
Controller
32-pin + NMI
INT[31:00]
NMIX
MODE-Ctrl
16-bit Output
Compare
6ch
DTTI[2:0]X
RTO0[5:0]
RTO1[5:0]
RTO2[5:0]
Power On
Reset
GPIO
MD[1:0]
P0[F:0],
P1[F:0],
・
・
PIN-Function-Ctrl
Px[x:0]
Waveform Generator
3ch
SCK[7:0]
SIN[7:0]
SOT[7:0]
Multi Serial IF
8ch
(with FIFO ch.4-ch.7)
CTS4
RTS4
HW flow control(ch.4)
16-bit PPG
3ch
Multi Function Timer x3
Note: The following items vary depending on the package.
A) External bus address
B) 12bit A/D converter channel
■ STARTER KIT
A starter kit for FM3 family is on sale respectively from IAR Systems and KEIL.
 IAR Systems
With IAR Systems starter kit, a high performance board can be used for evaluation.
 KEIL
With KEIL starter kit, a simple board can be used for evaluation.
NP706-00013-1v0-E
April 2012
2/2
Copyright©2011-2012 FUJITSU SEMICONDUCTOR LIMITED All rights reserved