BOM for COM6M Rev.1.1 Part Number Reference Suppier Note LBEE5ZSTNC IC1 Murata Murata module XC6218P182HR-G IC3 TOREX LDO for 1.8V supply to 32.768kHz XO SG-3030LC U1 EPSON 32.768kHz XO MM8130-2600RB8 CN2 Murata SW connector LDA313G3313F-243 ANT1 Murata 2.4GHz Antenna LQP15MN5N1B02D C1 Murata Antenna matching GRM155B10J104KA01D C4 Murata GRM155B10J104KA01D C5 Murata ERJ2GE0R00X R1 Panasonic Jumper for BT_SPI I/F support (default : NC) NC R2 ERJ2GE0R00X R3 Panasonic Jumper for SDIO I/F support (default : 0ohm) NC ERJ2GE0R00X R4 Panasonic Jumper for SPI I/F support (default : NC) ERJ2GE0R00X R5 Panasonic Jumper for SDIO I/F support (default : 0ohm) ERJ2GE0R00X R6 Panasonic Jumper for SPI I/F support (default : NC) ERJ2GE0R00X R7 Panasonic Jumper for SDIO I/F support (default : 0ohm) ERJ2GE0R00X R8 Panasonic Jumper for SPI I/F support (default : NC) ERJ2GE0R00X R9 Panasonic Jumper for SDIO I/F support (default : 0ohm) ERJ2GE0R00X R10 Panasonic Jumper for SDIO I/F support (default : 0ohm) ERJ2GE0R00X R11 Panasonic Jumper for SPI I/F support (default : NC) ERJ2GE0R00X R12 Panasonic Jumper for SDIO I/F support (default : 0ohm) ERJ2GE0R00X R14 Panasonic Jumper for BT_UART I/F support (default : 0ohm) ERJ2GE0R00X R15 Panasonic Jumper for BT_SPI I/F support (default : NC) ERJ2GE0R00X R16 Panasonic Jumper for BT_UART I/F support (default : 0ohm) ERJ2GE0R00X R17 Panasonic Jumper for BT_SPI I/F support (default : NC) ERJ2GE0R00X R18 Panasonic Jumper for BT_UART I/F support (default : 0ohm) ERJ2GE0R00X R19 Panasonic Jumper for BT_SPI I/F support (default : NC) ERJ2GE0R00X R20 Panasonic Jumper for BT_SPI I/F support (default : NC) ERJ2GE0R00X R21 ERJ2GE0R00X R22 ERJ2GE0R00X R23 Panasonic Jumper for BT_UART I/F support (default : 0ohm) Jumper for Antenna selection Panasonic Chip Antenna on board:0ohm (default) / Ant Connenctor on Panasonic Jumper for BT_PCM I/F (default : 0ohm) ERJ2GE0R00X R24 Panasonic Jumper for BT_I2S I/F (default : NC) ERJ2GE0R00X R25 Panasonic Jumper for BT_PCM I/F (default : 0ohm) ERJ2GE0R00X R26 Panasonic Jumper for BT_I2S I/F (default : NC) ERJ2GE0R00X R27 Panasonic Jumper for BT_PCM I/F (default : 0ohm) ERJ2GE0R00X R28 Panasonic Jumper for BT_I2S I/F (default : NC) ERJ2GE0R00X R29 Panasonic Jumper for BT_PCM I/F (default : 0ohm) ERJ2GE0R00X R30 Panasonic Jumper for BT_I2S I/F (default : NC) ERJ2GE0R00X R31 Panasonic Jumper for 32kHz clock ERJ2GE0R00X R32 Panasonic ERJ2GE0R00X R33 Panasonic NC R34 ERJ2GE0R00X L1 Panasonic Antenna matching LQP15MN1N3B02D L2 Murata Default setting R31:NC / R32:0ohm (XO on board is used as 32kHz clock) NC Antenna matching