JFW Industries, Inc. Phone: 317-887-1340 [email protected] www.jfwindustries.com SPECIFICATION SHEET JFW MODEL 50SA-133 SOLID-STATE SWITCH ASSEMBLY Frequency Range 50-2200 MHz Configuration 1P8T self-terminating solid-state RF switch Enclosure Type 19 inch rack mount @ 1RU high Startup/Default States (configurable) RF switch off at startup (see SWITCH command) DHCP enabled (see NET command) 4 Ethernet users (see NET command) Prompts off (see PROMPT command) Impedance 50 Ohms nominal VSWR 1.5:1 maximum Insertion Loss 4.5 dB maximum Isolation 50 dB minimum RF Input Power +20 dBm Switching Speed 10 microseconds (after command is received and processed) (3 milliseconds typical processing time) Control Ethernet (DHCP, TCP/IP, 10/100, up to 12 users) RS-232 (up to 115200 Baud) Remote Command Format RF Switch Control Commands: Switch, Set Switch, Read Switch System Commands: Help, Identification, Store, Recall, Pause, Net, Serial, Close, Disconnect, MOTD, Date, Message, Restrict, IDENT, Name, Show Users, Reboot, Uptime, Prompt Indicators LED's on front panel denote active port AC Supply 100-240 VAC @ 47-63 Hz 2 Amp 5x20mm "Slo-Blo" AC fuse Littelfuse #215-002, JFW #025-021 Control Connector RJ-45 RF Connectors SMA female or BNC female Operating Temperature Range 0º to +65ºC Physical Size See outline drawing 092-4863 (BNC) 092-5285 (SMA) ECR/ECN # DATE REV 07/15/2005 Page 1 of 1 APPR / DATE ECR/ECN # DATE REV APPR / DATE BAC 07/15/2005 15916 05/28/2008 C TRS 05/28/2008 13146 08/07/2006 A BAC 08/07/2006 16179 08/07/2008 D TRS 08/07/2008 13698 12/20/2006 B BAC 12/20/2006 24759 12/03/2014 E TRS 12/03/2014 JFW FORM E-7-F REV F